Philips HQ9070/27 User manual



 4

 14

한국어 24

 34

ภาษาไทย 44

 52

繁體中文 62



Read this user manual carefully before you use the

appliance and save it for future reference.

- This appliance is not intended for use by persons

(including children) with reduced physical, sensory

or mental capabilities, or lack of experience

and knowledge, unless they have been given

supervision or instruction concerning use of the

appliance by a person responsible for their safety.

- Children should be supervised to ensure that they

do not play with the appliance.

- Only use the powerplug supplied.

- The powerplug transforms 100-240 volts to a safe

low voltage of less than 24 volts.

- The powerplug contains a transformer. Do not cut

off the powerplug to replace it with another plug,

as this causes a hazardous situation.

- Do not use a damaged powerplug.

- If the powerplug is damaged, always have it

replaced with one of the original type in order to

avoid a hazard.

- Charge and store the shaver at a temperature

between 5°C and 35°C.

- Do not recharge the shaver in a closed pouch.

- Make sure the powerplug does not get wet.

- Always unplug the shaver before cleaning it under

the tap.

- The appliance complies with the internationally

approved IEC safety regulations and can be safely

cleaned under the tap.

Be careful with hot water. Always check if the water

is not too hot, to prevent your hands from getting

burnt.





This Philips appliance complies with all standards

regarding electromagnetic elds (EMF). If handled

properly and according to the instructions in this

user manual, the appliance is safe to use based on

scientic evidence available today.



Make sure the appliance is switched off before you

start to charge it.

Charging takes approx. 1 hour.

You can also shave without charging by connecting

the shaver to the mains.

Do not leave the appliance connected to the mains

for more than 24 hours.





When you connect the appliance to the mains to

charge it:

,HQ9080: the power symbol lights up.

,HQ9070: the battery symbol lights up.



When the battery has been fully charged:

 5

,HQ9080: the battery symbol starts to ash

green.

,HQ9070: the battery symbol starts to ash

green.



- HQ9080: When the battery is running low, the

battery symbol starts burning red. When you

switch off the shaver, this symbol ashes red.

- HQ9070: There is no warning or indication when

the battery is running low. The appliance switches

off automatically when the battery is completely

empty.



Charge the appliance when the battery symbol

burns or ashes red (HQ9080) or when the motor

stops or starts running slower (HQ9070).

1 Put the appliance plug in the shaver.

2 Put the powerplug in the wall socket.

3 Remove the powerplug from the wall socket

and pull the appliance plug out of the shaver

when the battery has been fully charged.



A fully charged shaver has a cordless shaving time of

up to 80 minutes.





1 Press the on/off button once to switch on the

shaver.

6

,The light ring goes on.

2 Move the shaving heads quickly over your skin,

making both straight and circular movements.

Shaving on a dry face gives the best results.

Your skin may need 2 or 3 weeks to get accustomed

to the Philips shaving system.

3 Press the on/off button once to switch off the

shaver.

4 Put the protection cap on the shaver every

time you have used it, to prevent damage.



For grooming sideburns and moustache.

1 Open the trimmer by pushing the slide

upwards.

The trimmer can be activated while the motor is

running.



Regular cleaning guarantees better shaving

performance.

The easiest and most hygienic way to clean the

appliance is to rinse the shaving unit and the hair

chamber with hot water every time you have used

the appliance.

Be careful with hot water. Always check if the

water is not too hot, to prevent your hands from

getting burnt.

 7



1 Switch off the shaver, remove the powerplug

from the wall socket and pull the appliance plug

out of the shaver.

2 Press the release button (1) and open the

shaving unit (2).

3 Clean the shaving unit and the hair chamber by

rinsing them under a hot tap for some time.

Make sure the inside of the shaving unit and the hair

chamber have been cleaned properly.

4 Rinse the outside of the appliance.

5 Close the shaving unit and shake off excess

water.

Never dry the shaving unit with a towel or tissue,

as this may damage the shaving heads.

6 Open the shaving unit again and leave it open

to let the appliance dry completely.

You can also clean the hair chamber without water

by using the brush supplied.



1 Open the shaving unit, pull it off the shaver and

remove the retaining frame.

8

2 Clean the cutters and guards with the brush

supplied.

Do not clean more than one cutter and guard

at a time, since they are all matching sets. If you

accidentally mix up the cutters and guards, it

may take several weeks before optimal shaving

performance is restored.

3 Put the shaving heads back into the shaving

unit. Put the retaining frame back into the

shaving unit.

Make sure that the projections of the shaving heads

t into the recesses.

4 Put the shaving unit back onto the shaver and

close it.



Clean the trimmer every time you have used it.

1 Switch off the shaver, remove the powerplug

from the wall socket and pull the appliance plug

out of the shaver.

2 Clean the trimmer with the brush supplied.

3 Lubricate the trimmer teeth with a drop of

sewing machine oil every six months.

 9



,Put the protection cap on the shaver to prevent

damage.

,Store the appliance in the luxury pouch or place

the appliance in the stand.



Replace the shaving heads every two years for

optimal shaving results.

Replace damaged or worn shaving heads with HQ9

Philips SmartTouch shaving heads only.

1 Switch off the shaver, remove the powerplug

from the wall socket and pull the appliance plug

out of the shaver.

2 Open the shaving unit and remove the

retaining frame.

You can also remove the shaving unit by pulling it off

the shaver.

3 Remove the shaving heads and place new ones

in the shaving unit. Put the retaining frame back

into the shaving unit.

Make sure that the projections of the shaving heads

t into the recesses.

4 Close the shaving unit.

10



The following accessories are available:

- HQ9 SmartTouch Shaving Heads

- HQ110 Philips Shaving Head Cleaning Spray (not

available in China)



- Do not throw away the appliance with the normal

household waste at the end of its life, but hand

it in at an ofcial collection point for recycling. By

doing this, you help to preserve the environment.

- The built-in rechargeable shaver battery contains

substances that may pollute the environment.

Always remove the battery before you discard

and hand in the shaver at an ofcial collection

point. Dispose of the battery at an ofcial

collection point for batteries. If you have trouble

removing the battery, you can also take the shaver

to a Philips service centre. The staff of this centre

will remove the battery for you and will dispose of

it in an environmentally safe way.



Only remove the battery if it is completely empty.

1 Remove the powerplug from the wall socket

and pull the appliance plug out of the shaver.

2 Let the shaver run until it stops, undo the

screws and open the shaver.

3 Remove the battery.

Do not connect the shaver to the mains again after

the battery has been removed.

 11



If you need information or if you have a problem,

please visit the Philips website at www.philips.com

or contact the Philips Customer Care Centre

in your country (you nd its phone number in

the worldwide guarantee leaet). If there is no

Customer Care Centre in your country, go to

your local Philips dealer or contact the Service

Department of Philips Domestic Appliances and

Personal Care BV.



The shaving heads (cutters and guards) are not

covered by the terms of the international guarantee

because they are subject to wear.



1 Reduced shaving performance.

- Cause 1: the shaving heads are dirty. The shaver

has not been rinsed long enough or the water

used was not hot enough.

Clean the shaver thoroughly before you continue

shaving. See chapter ‘Cleaning and maintenance’.

- Cause 2: long hairs are obstructing the shaving

heads.

Clean the cutters and guards with the brush

supplied. See chapter ‘Cleaning and maintenance’,

section ‘Every six months: shaving heads’.

- Cause 3: the shaving heads are damaged or worn.

Replace the shaving heads. See chapter

‘Replacement’.

2 The shaver does not work when the on/off

button is pressed.

- Cause 1: the battery is empty.

Recharge the battery. See chapter ‘Charging’.

12

This manual suits for next models

Table of contents

Languages:

Other Philips Electric Shaver manuals

Philips

Philips HQ4608/01 User manual

Philips

Philips OneBlade Pro QP6510/20 User manual

Philips

Philips PT729CC User manual

Philips

Philips SK-HQ7140 User manual

Philips

Philips Norelco 3605X User manual

Philips

Philips Norelco Multigroom 5000 Instruction Manual

Philips

Philips RQ1285 User manual

Philips

Philips MG3757/15 User manual

Philips

Philips Accuvac T870 User manual

Philips

Philips QP6520 User manual

Philips

Philips HQ444 User manual

Philips

Philips HQ6095 User manual

Philips

Philips HQ 8865 User manual

Philips

Philips Norelco BG2022 Bodygroom User manual

Philips

Philips HQ6900 series User m User manual

Philips

Philips HP6368 User manual

Philips

Philips PQ217 User manual

Philips

Philips NORELCO NT9105 User manual

Philips

Philips S3000 Series User manual

Philips

Philips OneBlade QP2531 User manual

Philips

Philips S7000 series User manual

Philips

Philips Norelco QT4000 User manual

Philips

Philips Philishave QT4020 User manual

Philips

Philips OneBlade QP2531 User manual

Popular Electric Shaver manuals by other brands

Norelco

Norelco Quadra 7610X owner's manual

Braun

Braun WaterFlex WF2s manual

Daga

Daga MT-400 Directions for use

Remington

Remington BHT100 user manual

Kompernass

Kompernass KH 5537 operating instructions

Remington

Remington BHT6100 manual

MIA

MIA Aqua Body manual

Matheo

Matheo MLR 15 manual

CTC Union

CTC Union Clatronic HSM 3441 NE instruction manual

Remington

Remington XR7000 user manual

Eldom

Eldom G47 manual

Braun

Braun silk-epil 5 manual

SEVERIN

SEVERIN SÉRIE E700 0533 Dimensions

Remington

Remington PR1355 manual

Aurora

Aurora AU 3543 manual

Braun

Braun InterFace 3614 user manual

Wahl

Wahl 8061 5-STAR operating manual

Norelco

Norelco 4404LC Specifications