Philips HQ8174CC User manual

HQ8174CC, HQ8170CC

ENGLISH 4

DEUTSCH 20

ESPAÑOL 38

FRANÇAIS 56

ITALIANO 73

NEDERLANDS 90

PORTUGUÊS 108

TÜRKÇE 126

Introduction

Congratulations on your purchase and welcome to

Philips! To fully benet from the support that Philips

offers, register your product at

www.philips.com/welcome.

Important

Read this user manual carefully before you use the

shaver and the washing machine and save it for

future reference.

The shaver and the washing machine are not

intended for use by persons (including children)

with reduced physical, sensory or mental

capabilities, or lack of experience and knowledge,

unless they have been given supervision or

instruction concerning use of these appliances by

a person responsible for their safety.

Children should be supervised to ensure that

they do not play with the shaver or the washing

machine.

Only use the powerplug supplied.

The powerplug transforms 100-240 volts to a safe

low voltage of less than 24 volts.

The powerplug contains a transformer. Do not cut

off the powerplug to replace it with another plug,

as this causes a hazardous situation.

Do not use a damaged powerplug.

If the powerplug is damaged, always have it

replaced with one of the original type in order to

avoid a hazard.

Make sure the powerplug does not get wet.

Charge, use and store the shaver at a temperature

between 5°C and 35°C.

Do not recharge the shaver in a closed pouch.

ENGLISH

Always unplug the shaver before you clean it

under the tap.

The shaver complies with the internationally

approved IEC safety regulations and can be safely

cleaned under the tap.

Be careful with hot water.Always check if the

water is not too hot, to prevent your hands from

getting burnt.

This washable shaver is not suitable for shaving in

the shower.

Do not immerse the shaver in water.

Water may leak from the socket at the bottom

of the shaver when you rinse it.This is normal

and not dangerous because all electronics are

enclosed in a sealed power unit inside the shaver.

Only use the washing machine with the original

HQ200 Cleaning Fluid.

Empty the cleaning chamber and rinse it

thoroughly with hot tap water every 15 days.

The washing machine thoroughly cleans but does

not disinfect your shaver, therefore do not share

the shaver with others.

Never immerse the washing machine in water nor

rinse it under the tap.

Use and store the washing machine at a

temperature between 5°C and 35°C.

Always place the washing machine on a stable,

level and horizontal surface to prevent leakage.

Always place and use the washing machine on a

surface that is uid-resistant.

When the washing machine is ready for use, do

not move it to prevent leakage of cleaning uid.

ENGLISH 5

Electromagnetic elds (EMF)

These Philips appliances comply with all standards

regarding electromagnetic elds (EMF). If handled

properly and according to the instructions in this

user manual, the appliances are safe to use based on

scientic evidence available today.

Charging

Make sure the shaver is switched off before you

charge it.

Charging takes approx. 1 hour.

You can also shave without charging by connecting

the shaver to the mains.

A fully charged shaver has a cordless shaving time of

up to 55 minutes.

1 Charge the shaver when the bottom light

burns or ashes red.

Charge indications

Charging

When you start to charge the empty shaver,

the bottom light ashes red. When the battery

contains enough power for one shave, all

lights ash green sequentially.

Battery fully charged

When the battery is fully charged, all lights burn

green.

A few hours after charging, all lights go out.

Remaining battery capacity

The number of lights that are on show how

much power is left in the battery. The battery

capacity is only shown when you switch the

shaver on or off.

ENGLISH6

When all lights burn green, the battery is 100%

charged.

When the bottom light burns green, 20% of the

battery capacity is left.

Battery running low

When the battery is running low, the bottom

light turns red.

When you switch off the shaver, this light ashes a

few times.

Charging with the powerplug

Do not recharge the shaver in a closed pouch.

1 Put the appliance plug in the shaver.

2 Put the powerplug in the wall socket.

3 Remove the powerplug from the wall socket

and pull the appliance plug out of the shaver

when the battery is fully charged.

Charging in the washing machine

1 Place the shaver in the holder and push the

lever down completely to lock the shaver into

place.

The charging light on the washing machine ashes to

indicate that the shaver is charging.

When the charging light lights up continuously

(after approx. 1 hour), the shaver is fully charged.

ENGLISH 7

2 Move the lever upwards until it does not go

any further (1) and remove the shaver from the

washing machine (2).

The charging light goes out.

Using the shaver

Shaving

1 Press the on/off button once to switch on the

shaver.

The blue light ring round the on/off button goes on

to indicate that the motor is running.

Note:When you switch on the shaver, all lights go on

and then the remaining battery capacity is shown for a

few seconds.

2 Move the shaving heads quickly over your skin.

Make both straight and circular movements.

Shaving on a dry face gives the best results.

Your skin may need 2 or 3 weeks to get

accustomed to the Philips shaving system.

3 Press the on/off button once to switch off the

shaver.

The blue light ring round the on/off button goes out.

4 Clean the shaver (see chapter ‘Cleaning and

maintenance’).

5 Put the protection cap on the shaver every

time you have used it, to prevent damage.

ENGLISH8

Trimming

You can use the trimmer to groom your sideburns

and moustache.

1 Push the slide downwards to open the

trimmer.

You can activate the trimmer while the motor is

running.

2 Close the trimmer (‘click’).

Cleaning and maintenance

The best and most hygienic way to clean the

shaver is in the washing machine. You can also

clean the shaver by rinsing it under the tap or

with the brush supplied.

The light above the tap symbol starts to ash

after every shave to remind you that the shaver

needs to be cleaned (except when the bottom

light burns red).

Regular cleaning guarantees better shaving

performance.

Note:Water may leak from the socket at the bottom

of the shaver when you rinse it.This is normal and not

dangerous.

Cleaning the shaver in the washing machine

supplied

Preparing the washing machine for use

Fill the cleaning chamber before rst use and when

the cleaning light ashes to indicate that the uid

ENGLISH 9

level is too low. When the uid level drops below

the minimum level, the cleaning light ashes with

intervals and the holder returns to its starting

position.

If you use the washing machine to clean the shaver

every day, rell the cleaning chamber approx. every

15 days.

1 Simultaneously press the release buttons on

both sides of the cleaning chamber (1) and lift

the washing machine off the cleaning chamber

(2).

The cleaning chamber remains behind.

2 Unscrew the dosing cap from the bottle with

HQ200 Cleaning Fluid and remove the airtight

seal.

3 Fill the cleaning chamber with cleaning uid up

to the MAX indication.

4 Place the washing machine back onto the

cleaning chamber.

Make sure the release buttons snap back into place.

5 Put the appliance plug in the washing machine

and put the powerplug in the wall socket.

The holder automatically moves to the highest

position.

The washing machine is now ready for use.

Using the washing machine

1 Place the shaver in the holder and push the

lever down completely to lock the shaver into

place.

The charging light on the washing machine ashes to

indicate that the shaver is being charged.

ENGLISH10

2 Press the start button to start the cleaning

program.

The cleaning light starts to ash and the shaver is

automatically lowered into the cleaning uid.

During the cleaning program, which takes

approx. 1 hour, the cleaning light ashes

continuously.

During the rst phase of the cleaning program,

the shaver automatically switches on and off

several times and is put in different positions.

During the second phase of the cleaning

program, the shaver is placed in the drying

position. It stays in this position until the end

of the program. The cleaning light lights up

continuously.

After the cleaning program, the shaver

automatically returns to its starting position and

the charging program is started. The charging

light ashes.

Note: If you press the start button or open the lever

during cleaning, the cleaning program is aborted and

reset. In this case, the cleaning light stops ashing and

the holder returns to its starting position.

Note: If the powerplug is removed from the wall socket

during cleaning, the cleaning program is aborted.

The holder remains in its current position.When

the powerplug is put back into the wall socket, the

holder moves to the highest position.

Note: If the uid volume in the cleaning chamber drops

below the minimum level during the cleaning program,

the program is aborted. The cleaning light ashes with

intervals and the holder returns to its starting position.

ENGLISH 11

Cleaning the washing machine

The cleaning chamber is not dishwasher-proof.

Clean the cleaning chamber every two weeks.

1 Simultaneously press the buttons on both sides

of the washing machine (1) and lift the washing

machine off the cleaning chamber (2).

The cleaning chamber remains behind.

2 Pour any remaining cleaning uid out of the

cleaning chamber.

You can simply pour the cleaning uid down the sink.

3 Rinse the cleaning chamber under the tap.

4 Place the washing machine back onto the

cleaning chamber.

Make sure the release buttons snap back into place.

5 Clean the washing machine with a moist cloth.

Cleaning the shaver under the tap

Be careful with hot water. Always check if the

water is not too hot, to prevent your hands from

getting burnt.

1 Switch off the shaver, remove the powerplug

from the wall socket and pull the appliance plug

out of the shaver.

ENGLISH12

This manual suits for next models

Table of contents

Languages:

Other Philips Electric Shaver manuals

Philips

Philips Norelco 7345XL User manual

Philips

Philips HQG269/10 User manual

Philips

Philips SatinShave Essential Wet&Dry HP6342 User manual

Philips

Philips Norelco SW6700/91 User manual

Philips

Philips HQ9080 User manual

Philips

Philips BT720 Series User manual

Philips

Philips Bodygroom TT2022 User manual

Philips

Philips Coolskin HS8060 User manual

Philips

Philips RQ1100 Series User manual

Philips

Philips 9000 SERIES S91 SERIES Installation and operation manual

Philips

Philips HQ6843/16 User manual

Philips

Philips Cool Skin HQ6707 User manual

Philips

Philips AT754 User manual

Philips

Philips HQ7380 User manual

Philips

Philips Philishave HQ 30 User manual

Philips

Philips HQ10/15 User manual

Philips

Philips HP6383 User manual

Philips

Philips S5000 series User manual

Philips

Philips Norelco BG7030 User manual

Philips

Philips HQ5601/16 User manual

Philips

Philips Norelco Multigroom 9000 Instruction Manual

Philips

Philips S588 User manual

Philips

Philips NORELCO MG7750/59 User manual

Philips

Philips PT866 User manual

Popular Electric Shaver manuals by other brands

Norelco

Norelco Quadra 7610X owner's manual

Braun

Braun WaterFlex WF2s manual

Daga

Daga MT-400 Directions for use

Remington

Remington BHT100 user manual

Kompernass

Kompernass KH 5537 operating instructions

Remington

Remington BHT6100 manual

MIA

MIA Aqua Body manual

Matheo

Matheo MLR 15 manual

CTC Union

CTC Union Clatronic HSM 3441 NE instruction manual

Remington

Remington XR7000 user manual

Eldom

Eldom G47 manual

Braun

Braun silk-epil 5 manual

SEVERIN

SEVERIN SÉRIE E700 0533 Dimensions

Remington

Remington PR1355 manual

Aurora

Aurora AU 3543 manual

Braun

Braun InterFace 3614 user manual

Wahl

Wahl 8061 5-STAR operating manual

Norelco

Norelco 4404LC Specifications