Philips HQ6735/01 User manual
ENGLISH 4
FRANÇAIS 18
ESPAÑOL 32
PORTUGUÊS 47
73
87
HQ6735
3
á«Hô©dG
ENGLISH4
Introduction
The shaver comes with two different kinds of
NIVEA FOR MEN cartridges:Extra Fresh Shaving
Gel for a fresh sensation during and after shaving
and Moisturising Shaving Lotion for sensitive skin.
This gives you the opportunity to try them out
and discover which one suits your skin type best.
Important
Read these instructions for use carefully before
using the appliance and save them for future
reference.
◗Only use the HQ600 powerplug and the
charging stand supplied to charge the shaver.
◗Only the powerplug supplied guarantees
safety.
◗The HQ600 powerplug transforms 100-240
volts to a safe low voltage of less than
24 volts.
◗The powerplug contains a transformer.Do
not cut off the powerplug to replace it with
another plug,as this will cause a hazardous
situation.
C◗Never immerse the charging stand in water
nor rinse it under the tap when the charging
stand is plugged in.
C◗The shaver runs at a safe low voltage of less
than 24 volts.It is watertight and can be
cleaned under the tap.Rinse the shaver with
hot water.
Be careful with hot water.Always check if the
water isn't too hot,to prevent your hands from
burning.
◗Do not leave the charging stand with the
shaver in it plugged into the mains
continuously.
◗Check if the gel and lotion supplied with the
appliance contain ingredients (see back of
cartridge) to which you are allergic before
you start using the appliance.Do not use the
gel and/or lotion if you are allergic to one or
more ingredients!
◗If the mains cord of this appliance is damaged,
it must always be replaced by Philips or a
service centre authorised by Philips in order
to avoid hazardous situations.
Charging
Charge indications
C◗As soon as you start charging the empty
shaver,the green pilot light goes on.
◗The red pilot light blinks when the batteries
are almost empty.
◗When the batteries are almost empty,the red
pilot light blinks a few times after the shaver
has been switched off.
ENGLISH 5
ENGLISH6
Charging the appliance
Recharge,store and use the appliance at a
temperature between 5cC and 35cC.
1Insert the small plug into the charging
stand and put the powerplug in the wall
socket.
C2Place the shaver in the charging stand.
C3Press until you hear a click.
The shaver automatically switches off when
placed in the charging stand.
4When charging for the first time or after a
long period of disuse:leave the shaver to
charge continuously for 24 hours.
Charging normally takes approx.8 hour.
A fully charged shaver has a cordless shaving time
of up to approx.40 minutes.
Inserting the cartridge
Cartridges with moisturising NIVEA FOR MEN
shaving gel/lotion are available in boxes containing
five cartridges and one small plastic pump.
Do not throw the pump away when you replace
an empty cartridge.You will need it for all five
cartridges.
ENGLISH 7
One Philishave NIVEA FOR MEN Cool Skin
cartridge contains enough gel/lotion for approx.
10 shaves.
Remove the shaving gel/lotion cartridge from the
appliance when you are not going to use the
shaver for more than one week.
Use only Philishave NIVEA FOR MEN Cool Skin
(HQ160 or HQ161) cartridges.
For hygienic reasons,we advise you to insert a
new pump when you start using a new set of five
cartridges.
When you have run out of shaving gel/lotion
cartridges and you do not know where to buy
them,contact the Customer Care Centre in your
country (see 'Guarantee & service').
Inserting the cartridge
C1Take one cartridge from the box.Take the
pump (supplied in the same box) out of its
bag and push it into the cartridge until it
locks into position with a click.
C2Move the release slide downwards and
open the cover of the cartridge
compartment.
12
ENGLISH8
C3Slide the cartridge with the pump into the
shaver.It only fits properly if the white side
of the pump is pointing upwards.
4Close the cover (you will hear a click).
5Press the yellow pump button a few times
until the NIVEA FOR MEN shaving
emulsion appears.The shaver is now ready
for use.
BThe NIVEA FOR MEN shaving gel/lotion in the
cartridges will keep for 32 months when stored at
temperatures between 0cC and +40cC.
Using the appliance
Shaving
Switching on the shaver.
1Switch the shaver on by pressing the on/off
button once.
C2Press the yellow pump button to apply
NIVEA FOR MEN shaving gel/lotion to
your skin.
3Move the shaving heads over your skin,
making both straight and circular
movements.
4While shaving,press the pump button
frequently to apply more NIVEA FOR
MEN shaving gel/lotion so that the shaver
keeps gliding smoothly over your face.
Do not press the shaver too hard against your
skin while shaving.If you prefer,you can wet your
face before shaving.
◗When you have run out of shaving emulsion,
you can also use the shaver without it on a
dry face.
The shaver will not perform optimally when used
without shaving gel/lotion.
◗Your skin may need 2-3 weeks to get
accustomed to the Philishave system.
Switching of the shaver
1Switch the shaver off.
C2Put the protection cap on the shaver every
time you have used it,to prevent damage.
Remove the cartridge and clean the shaver if you
are not going to use the appliance for more than
one week.Rinse the shaver after each shave.
Trimming
The shaver has a separate trimmer for grooming
sideburns and moustache.
1Switch the shaver off.
Clean the shaver before you attach the trimmer.
ENGLISH 9
C2Press the release button to open the
shaving unit and pull the shaving unit off
the shaver.
C3Tilt the trimmer slightly backwards and fit
it onto the shaver.
4Remove the trimmer by pressing the
release button again and pulling the
trimmer off the shaver.
Cleaning and maintenance
Shaving unit
Rinse the shaving unit and the hair chamber with
hot water (60cC - 80cC) after every use.
1Switch the shaver off.
C2Press the release button to open the
shaving unit.
C3Clean the shaving unit and the hair
chamber by rinsing them under a hot tap
for some time.
Never dry the shaving unit with a towel or tissue
as this may damage the shaving heads.
ENGLISH10
2
1
2
C4Rinse the outside of the shaver.
Make sure the inside of the shaving unit and the
hair chamber have been cleaned properly.Close
the shaving unit and shake off excess water.
Charging stand
1Unplug the charging stand.
2Clean the charging stand with a moist
cloth.
Trimmer
1Clean the outside of the trimmer with the
brush supplied after every use.
C2Open the trimmer to clean it on the
inside.
C3Lubricate the trimmer teeth with a drop
of sewing machine oil every six months.
Replacement
Replace the shaving heads every two years for
optimal shaving results.
1Switch the shaver off.
ENGLISH 11
OIL
C2Press the release button to open the
shaving unit.
C3Turn the wheel anticlockwise and remove
the retaining frame.
C4Remove the shaving heads and place the
new ones in the shaving unit.
C5Put the retaining frame back onto the
shaving unit,press the wheel and turn it
clockwise.
Replace damaged or worn shaving heads with
Philishave HQ167 Cool Skin shaving heads only.
Storage
C◗After cleaning,the wet shaver can be placed in
the charging stand.
◗The appliance and the trimmer can be stored
in the pouch or cassette supplied.Whether
you have a pouch or a cassette depends on
your type of shaver.
ENGLISH12
1
1
2
1
1
This manual suits for next models
1
Table of contents
Languages:
Other Philips Electric Shaver manuals
Philips
Philips HQ6640 User manual
Philips
Philips NT9148 User manual
Philips
Philips Norelco Multigroom 5000 Instruction Manual
Philips
Philips NORELCO MG7791 User manual
Philips
Philips 3000 series User manual
Philips
Philips OneBlade Pro Face QP6510/60 User manual
Philips
Philips PT717 User manual
Philips
Philips S5582/27 User manual
Philips
Philips QT4015 User manual
Philips
Philips QS6140/32 User manual
Philips
Philips HQ7180 User manual
Philips
Philips HQ853 User manual
Philips
Philips HQ6900/16 User manual
Philips
Philips HC9490 User manual
Philips
Philips BG1025 User manual
Philips
Philips S1030 Assembly instructions
Philips
Philips 1180X/40 User manual
Philips
Philips S9000 Series User manual
Philips
Philips Satin Lady Shaver User manual
Philips
Philips HQ6676/33 User manual
