Philips R3306 User manual

www.philips.com/support

User manual

R3306

3000 Series

Clock Radio

4 EN

Your clock radio

Congratulations on your purchase, and welcome

to Philips! To fully benet from the support that

Philips oers, register your product at

www.philips.com/support.

Introduction

With this clock radio, you can

•

listen to FM radio

What's in the box

Check and identify the contents of your package:

• Main unit

• Power adaptor

• Quick start guide

• Safey sheet

Warranty

•

Overview of the clock radio

set two alarms to ring at dierent times.

• Turn on or switch to standby.

PRESET / SET TIME

• Store radio stations in memory.

• Select a preset radio station.

• Set time.

HR / MIN / TUN

•

Tune to FM radio stations.•

Set hour and minute.

SNOOZE / BRIGHTNESS

• Snooze alarm.

• Adjust display brightness.

SLEEP / SCAN

•

Scan and store radio stations automatically.

•

Set the sleep timer.

5Display panel

• Display current status.

AL1 / AL2 / VOL

• Set alarm.

• Adjust volume.

Caution

• Risk of product damage! Make sure that the power

voltage corresponds to the voltage printed on the

back or underside of the clock radio.

• Risk of electrical shock! When you unplug the power

cord, always pull the plug from the socket. Never pull

the cord.

Note

•

Get started

Always follow the instructions in this chapter in

The batteries can only back up clock and alarm

settings.

Connect the power adaptor to the wall outlet.

sequence.

Install batteries

Connect power

Caution

• Risk of explosion! Keep the batteries away from heat,

sunshine or re. Never discard batteries in re.

• Batteries contain chemical substances, so they should

be disposed of properly.

• Do not mix battery types: e.g. alkaline with carbon

zinc. Only use batteries of the same type for the set.

The type plate is located at the bottom of the clock

radio.

Insert 2 AAA batteries (not provided) with

correct polarity (+/-) as illustrated.

Set time

Note

• You can only set time in standby mode.

1 In standby mode, press and hold SET TIME

for 2 seconds.

2 Press HR to set hour and MIN to set

minute, then press to conrm.

SET TIME

The time is set.

Listen to FM radio

Note

• Keep the clock radio away from other electronic

devices to avoid radio interference.

• For better reception, fully extend and adjust the

position of the FM antenna.

Tune to FM radio stations

1 Press to turn on the clock radio.

2 Press and hold TUN

for 2 seconds.

The clock radio tunes to a station with

strong reception automatically.

3 Repeat Step 2 to tune to more radio stations.

To tune to a station manually:

Press TUN repeatedly to select a frequency.

Note

• The tuning grid of the clock radio is 50KHz, the radio

frequency on the display panel will increase 0.1MHz

by pressing

TUN twice.

Tip

• To remove a pre-stored station, store another station

in its place.

Select a preset radio

station

In FM tuner mode, press PRESET repeatedly to

select a preset number.

Adjust volume

While listening, press VOL

to adjust volume.

Store FM radio stations

automatically

Store FM radio stations

manually

In FM tuner mode, press and hold SCAN for

more than 2 seconds.

The unit stores all the available FM radio

stations automatically and broadcasts the

rst station.

Note

• You can store a maximum of 20 FM radio stations.

1In FM tuner mode，tune to an FM radio station.

2Press and hold PRESET for 2 seconds to

activate programming mode.

The preset number begins to blink.

3Press TUN

TUN

repeatedly to select a number.

4Press again to conrm.PRESET

5Repeat steps 1 to 4 to store more FM radio

stations.

6 EN

Option A:

1 In FM tuner mode, press PRESET.

2 Press to select a preset radio station.

Option B:

Other features

Set alarm time

Set alarm

Note

• You can only set the alarm in standby mode.

• Make sure that you have set the clock correctly.

1In standby mode, press and hold AL1 or

AL2 for 2 seconds to set alarm time.

2Press HR to set hour and MIN to set

to conrm.minute, then press AL1 or AL2

Tip

• The unit exits alarm setting mode when being idle for

10 seconds.

Select alarm source

You can select FM radio or buzzer as the alarm

source by pressing AL1 or AL2 in standby

mode.

The corresponding alarm icon lights up.

Activate/deactivate alarm timer

Press AL1 or AL2 repeatedly to activate or

deactivate the alarm timer.

If the alarm timer is activated, the alarm

indicator turns on.

If the alarm timer is deactivated, the alarm

indicator turns o.

The alarm repeats ringing for the next day.

To stop the alarm, press the coresponding

AL1 or AL2.

Snooze the alarm

When the alarm sounds, press SNOOZE.

The alarm snoozes and repeats ringing 9

minutes later.

Set sleep timer

This clock radio can switch to standby mode

automatically after a preset period.

• Press SLEEP repeatedly to select a period

(in minutes).

The clock radio switches to standby mode

automatically after the preset period.

To deactivate the sleep timer:

• Press SLEEP repeatedly until [OFF] (o)

appears.

Adjust display brightness

Press BRIGHTNESS repeatedly to select

dierent brightness levels:

• High

• Medium

• Low

8EN

Product

information

Note

• Product information is subject to change without prior

notice.

Rated Output Power 400mW RMS

Tuner (FM)

Amplier

Tuning Range 87.5-108 MHz

Tuning Grid 50 KHz

Sensitivity

- Mono, 26 dB S/N Ratio <22 dBf

Total Harmonic Distortion <3%

Signal to Noise Ratio >50 dBA

General information

AC Power (power

adaptor)

Brand: Philips

Model: AS030-

Input: 100-240V~

50/60 Hz; 0.15A

Output: 5V 0.6A

Operation Power

Consumption <3 W

Standby Power

Consumption <1 W

Dimensions

(W x H x D) 186 x 96 x 65 mm

Weight

(Main unit) 296 g

Troubleshooting

Warning

• Never remove the casing of the product.

To keep the warranty valid, never try to repair

the device yourself. If you encounter problems

when using this device, check the following

points before requesting service. If the problem

remains unsolved, go to the Philips webpage

www.philips.com/support. When you contact

Philips, make sure that the device is nearby

and the model number and serial number are

available.

No power

• Make sure that the AC power plug of the unit

is connected properly.

• Make sure that there is power at the AC outlet.

No sound

• Adjust the volume.

No response from the unit

• Disconnect and reconnect the AC power plug,

then turn on the unit again.

Poor radio reception

• Keep the clock radio away from other

electronic devices to avoid radio interference.

• Fully extend and adjust the position of the

antenna.

Alarm does not work

• Set the clock/alarm correctly.

Clock/alarm setting erased

• Power has been interrupted or the power

plug has been disconnected.

• Reset the clock/alarm.

• Replace the backup batteries.

050-EE060

Table of contents

Other Philips Clock Radio manuals

Popular Clock Radio manuals by other brands

Denver

Denver CRQ-105 quick start guide

Audiovox

Audiovox CE90 Operation instructions

Sony

Sony Dream Machine ICF-C763L operating instructions

Sanyo

Sanyo DMP-P6 instruction manual

RCA

RCA RPC100 user manual

Yamaha

Yamaha ISX-80 owner's manual

Pyle

Pyle PLMR20W user manual

Blaupunkt

Blaupunkt CR7BK user manual

HoMedics

HoMedics SS-5500-2EU instruction manual

RCA

RCA RC66i user manual

Versaudio

Versaudio Vers user manual

SOUNDMASTER

SOUNDMASTER UR8100 instruction manual

Audiovox

Audiovox CE90 operating instructions

Jensen Audio

Jensen Audio JCR-222 - AM/FM Projection Alarm Clock Radio instruction manual

Roberts

Roberts ChronoDAB user manual

AEG

AEG MRC 4132 BT instruction manual

Tokai

Tokai TC-155 user manual

Timex

Timex T300 manual