Philips CLOCK/TIMER AJ1000 User manual

AJ1000

EN User manual

100

1 Important

Safety

aRead these instructions.

bKeep these instructions.

cHeed all warnings.

dFollow all instructions.

eDo not use this apparatus near water.

fClean only with dry cloth.

gDo not block any ventilation openings. Install in accordance

with the manufacturer’s instructions.

hDo not install near any heat sources such as radiators, heat

registers, stoves, or other apparatus (including ampliers) that

produce heat.

iProtect the power cord from being walked on or pinched,

particularly at plugs, convenience receptacles, and the point

where they exit from the apparatus.

j Only use attachments/accessories specied by the

manufacturer.

kUnplug this apparatus during lightning storms or when unused

for long periods of time.

l Refer all servicing to qualied service personnel. Servicing is

required when the apparatus has been damaged in any way,

such as power-supply cord or plug is damaged, liquid has been

spilled or objects have fallen into the apparatus, the apparatus

has been exposed to rain or moisture, does not operate

normally, or has been dropped.

mApparatus shall not be exposed to dripping or splashing.

nDo not place any sources of danger on the apparatus

(e.g. liquid lled objects, lighted candles).

oWhere the MAINS plug or an appliance coupler is used as

the disconnect device, the disconnect device shall remain

readily operable.

Warning

Never remove the casing of this apparatus.•

Never lubricate any part of this apparatus.•

Never place this apparatus on other electrical equipment.•

Keep this apparatus away from direct sunlight, naked ames or •

heat.

Never look into the laser beam inside this apparatus.

•

Ensure that you always have easy access to the power cord, plug or•

adaptor to disconnect this apparatus from the power.

Notice

This product complies with the radio interference

requirements of the European Community.

Any changes or modications made to this device that are

not expressly approved by Philips Consumer Lifestyle may void the

user’s authority to operate the equipment.

Recycling

Your product is designed and manufactured with high quality

materials and components, which can be recycled and reused.

When you see the crossed-out wheel bin symbol attached to a

product, it means the product is covered by the European Directive

2002/96/EC:

Never dispose of your product with other household waste. Please

inform yourself about the local rules on the separate collection of

electrical and electronic products.The correct disposal of your old

product helps prevent potentially negative consequences on the

environment and human health.

Environmental information

All unnecessary packaging has been omitted. We have tried to make

the packaging easy to separate into three materials: cardboard (box),

polystyrene foam (buffer) and polyethylene (bags, protective foam

sheet.)

Your system consists of materials which can be recycled and reused

if disassembled by a specialized company. Please observe the local

regulations regarding the disposal of packaging materials, exhausted

batteries and old equipment.

2 Your clock radio

Congratulations on your purchase, and welcome to Philips! To fully

benet from the support that Philips offers, register your product at

www.philips.com/welcome.

Introduction

With this clock radio, you can:

enjoy the FM radio•

know the time•

wake up to buzz or favorite radio tone•

set two alarms to ring at different time.•

What’s in the box

Check and identify the contents of your package:

Main unit (with power adapter attached)•

User manual•

Quick start guide•

Overview of the main unit

aTUNING

Tune to a radio station.•

bREPEAT ALARM/SLEEP OFF

Repeat the alarm.•

Disable the sleep timer.•

cSLEEP

Set the sleep timer.•

d+/-

Adjust the times of clock, alarm timer and sleep timer.•

eAL1,AL2

• RADIO: Set the current radio station as alarm tone.

• BUZ: Set buzz as alarm tone.

• OFF:Turn off the alarm timer.

fVOL

Adjust the volume level of radio.•

gDisplay panel

hAL RESET

Stop the alarm.•

iRADIO ON/OFF

Turn on or off radio.•

jBRIGHTNESS CONTROL

Adjust the brightness of display panel.•

kClock Control

• SET TIME: Activate the clock time setup.

• SET AL1/AL2: Activate the alarm time setup; display the

set alarm time.

• CLOCK: Display the clock time.

lFM ANT

Attached FM radio antenna.•

3 Get started

Caution

Use of controls or adjustments or performance of procedures other•

than herein may result in hazardous radiation exposure or other

unsafe operation.

Always follow the instructions in this chapter in sequence.

If you contact Philips, you will be asked for the model and serial

number of this apparatus.The model number and serial number are

on the bottom of the apparatus.Write the numbers here:

Model No. __________________________

Serial No. ___________________________

Connect power

Caution

Risk of product damage! Ensure that the power supply voltage•

corresponds to the voltage printed on the back or the underside of

the apparatus.

Risk of electric shock! When you unplug the AC power cord, always

•

pull the plug from the socket. Never pull the cord.

Before connecting the AC power cord, ensure you have completed

•

all other connections.

1Connect the power adapter to the power socket.

Set the clock time

1Switch Clock Control to SET TIME.

2Press +/- to set the time (24-hour system).

3Switch Clock Control to CLOCK.

Tip

Press and hold•+to fast increase the time digits.

Press

•-to decrease the time digits one by one.

4 Listen to radio

Tune to a radio station

1Press RADIO ON/OFF to turn on the radio.

2Adjust TUNING slowly to tune to a radio station.

To turn off the radio, press• RADIO ON/OFF again.

Adjust the volume level

1Rotate VOL clockwise or anti-clockwise.

5 Set the alarm timer

Set the alarm time

You can set two separate alarms. For the alarm tone, you can select

the buzz or the FM radio.

Note

Before you start, ensure that the time is set correctly.•

1Switch Clock Control to AL1 or AL2 (on SET AL1/AL2).

2Press +/- to set the alarm time.

3Switch Clock Control to CLOCK.

Turn on the alarm timer

Note

Ensure the alarm time is set successfully.•

1Switch AL1/AL2 to BUZ or RADIO.

»/ appears.

The buzz or FM radio is set for alarm tone.»

Other manuals for CLOCK/TIMER AJ1000

This manual suits for next models

Table of contents

Other Philips Clock Radio manuals

Popular Clock Radio manuals by other brands

Denver

Denver CRQ-105 quick start guide

Audiovox

Audiovox CE90 Operation instructions

Sony

Sony Dream Machine ICF-C763L operating instructions

Sanyo

Sanyo DMP-P6 instruction manual

RCA

RCA RPC100 user manual

Yamaha

Yamaha ISX-80 owner's manual

Pyle

Pyle PLMR20W user manual

Blaupunkt

Blaupunkt CR7BK user manual

HoMedics

HoMedics SS-5500-2EU instruction manual

RCA

RCA RC66i user manual

Versaudio

Versaudio Vers user manual

SOUNDMASTER

SOUNDMASTER UR8100 instruction manual

Audiovox

Audiovox CE90 operating instructions

Jensen Audio

Jensen Audio JCR-222 - AM/FM Projection Alarm Clock Radio instruction manual

Roberts

Roberts ChronoDAB user manual

AEG

AEG MRC 4132 BT instruction manual

Tokai

Tokai TC-155 user manual

Timex

Timex T300 manual