Philips CEM2220BT/55 User manual
Register your product and get support at
www.philips.com/support
Always there to help you
CEM2220BT
User manual
Question?
Contact
Philips
1
English
EN
Contents
1 Safety 2
2 Your car audio system 3
Introduction 3
What's in the box 3
Overview of the main unit 4
3 Install the car audio system 6
Connect wires 6
Mount into the dashboard 7
Attach the front panel 8
4 Get started 9
)RUWKHÀUVWWLPHXVH
Set the time format 9
Set the clock 10
Turn on 10
Switch music listening zone 10
Mute the button beep 10
5 Listen to radio 11
Tune to a radio station 11
Store radio stations in memory 11
Tune to a preset station 11
Play with RDS 12
6 Play from hard media 14
Play a disc 14
Play from USB 14
Control play 14
Switch tracks 15
7 Use Bluetooth devices 15
Connect a device 15
Play audio from a Bluetooth device 16
Make a call 16
8 Connect external sound source 17
9 Adjust sound 18
10 Adjust system settings 18
11 Others 19
Reset 19
Replace fuse 19
12 Product information 20
6SHFLÀFDWLRQV
USB playability information 21
13 Troubleshooting 22
General 22
About the Bluetooth device 22
14 Notice 23
Compliance 23
Disposal of your old product 23
Trademark notice 24
Copyright 24
15 Glossary 24
2EN
1 Safety
Read and understand all instructions before
you use your apparatus. If damage is caused by
failure to follow instructions, the warranty does
not apply.
This apparatus is designed for negative
ground (earth) 12 V DC operation only.
To ensure safe driving, adjust the volume to
a safe and comfortable level.
Improper fuses can cause damage or
ÀUH:KHQ\RXQHHGWRFKDQJHWKHIXVH
consult a professional.
Use only the supplied mounting hardware
for a safe and secure installation.
To avoid short circuit, do not expose the
apparatus to rain or water.
Never insert objects into the ventilation
slots or other openings on the apparatus.
Clean the apparatus and frame with a soft,
damp cloth. Never use substances such as
alcohol, chemicals or household cleaners
on the apparatus.
Never place any objects other than discs
into the apparatus.
Never use solvents such as benzene,
thinner, cleaners available commercially, or
anti-static sprays intended for discs.
Visible and invisible laser radiation when
open. Avoid exposure to beam.
Caution
Use of controls or adjustments or performance of
procedures other than herein may result in hazardous
radiation exposure or other unsafe operation.
The apparatus shall not be exposed to
dripping or splashing.
Do not place any sources of danger on the
DSSDUDWXVHJOLTXLGÀOOHGREMHFWVOLJKWHG
candles).
3
English
EN
2 Your car audio
system
Congratulations on your purchase, and
ZHOFRPHWR3KLOLSV7RIXOO\EHQHÀWIURPWKH
support that Philips offers, register your product
at www.philips.com/welcome.
Introduction
With the in-car audio system, you can enjoy
your drive while listening to:
FM or AM (MW) radio
Audio from CD or MP3 disc
Audio from USB devices
Audio from Bluetooth devices
Audio from other external devices
The unit supports the following media format:
What's in the box
Check and identify the contents of your
package:
a Main unit (with a sleeve)
b Front panel
c Trim plate
d Carrying case for front panel
e ISO male connector X 2
f Rubber cushion
g Screw x 1 pc
h Disassembly tools x 2 pcs
i User manual
a
e
ih
g
f
bc d
4EN
Overview of the main unit
a /
Tune for radio station.
Skip/search for track.
Fast backward/forward playback.
b
Press to answer or redial a call.
Press and hold to transfer call.
c /MENU
Return to previous menu.
Access system menu.
s
adcbe fg
npo h
r
qmlkij
d /
Turn the unit on or off.
&RQÀUPVHOHFWLRQ
Mute or unmute sound.
Rotate to adjust volume.
e ZONE /
Select tuner band.
Select MP3/WMA folder.
Press and hold to switch music
listening zone.
5
English
EN
f
Eject disc.
g
USB socket.
h AUDIO IN
Connect external audio device.
i
6281'
/
Press to enable or disable the MAX
Sound feature.
In any mode, press and hold to view
clock.
j DBB/AS
Press to turn on or off Dynamic Bass
Boost (DBB) sound.
In radio mode, press and hold to
access to tuner auto store.
k /
Start, pause, or resume the play of
tracks.
In radio mode, press to select the
preset radio station of No. 5/6.
In radio mode, press and hold to store
the current radio station at channel
No. 5/6.
l /
In radio mode, press to select the
preset radio station of No. 3/4.
In radio mode, press and hold to store
the current radio station at channel
No. 3/4.
For .wma and .mp3 tracks, press
UHSHDWHGO\WRVHOHFWVKXIÁHSOD\UHSHDW
play.
m /
In radio mode, press to select the
preset radio station of No. 1/2.
In radio mode, press and hold to store
the current radio station at channel
No. 1/2.
For .wma and .mp3 tracks on a storage
device, press to access the track/folder
list.
n SOURCE/DISPLAY
Press repeatedly to select source.
Display current status.
Press and hold to select the dimmer
high or low.
o
Press repeatedly to select a preset
equalizer (EQ).
Press and hold to access audio setting
menu.
p
Unlock the panel.
q
Press to hang up a call.
Press and hold to reject an incoming
call.
r RESET
Restore default settings.
s Disc slot
6EN
3 Install the car
audio system
These instructions are for a typical installation.
However, if your car has different requirements,
make the adjustment accordingly. If you have
any question regarding installation kits, consult
your local retailer.
Note
This system is designed for negative ground (earth) 12V
DC operation only.
Always install this system in the car dashboard. Other
locations can be dangerous as the rear of the system
heats up during use.
To avoid short-circuit: before you connect, make sure
that the ignition is off.
Make sure that you connect the yellow and red power
supply leads after all other leads are connected.
Make sure that all loose leads are insulated with
electrical tape.
Make sure that the leads do not get caught under
screws or iron parts that will move (e.g. seat rail).
Make sure that all ground (earth) leads are run to a
common ground (earth) point.
Use only the supplied mounting hardware for a safe
and secure installation.
,PSURSHUIXVHVFDQFDXVHGDPDJHRUÀUH:KHQ\RX
need to change the fuse, consult a professional.
When you connect other devices to this system, make
sure that the rating of the car circuit is higher than the
total fuse value of all the connected devices.
Never connect speaker wires to the metal body or
chassis of the car.
Never connect speaker wires with stripes to one
another.
Connect wires
Note
Consult a professional to connect CEM2220BT as
instructed below.
1 Check the car's wiring carefully and
connect them to the the supplied male
connector.
ISO male
connectors
Connect to
a Green strip, black-
edged green strip
Left speaker (Rear)
b White strip, black-
edged white strip
Left speaker (Front)
c Gray strip, black-
edged gray strip
Right speaker (Front)
d Purple strip, black-
edged purple strip
Right speaker (Rear)
e Red Ignition key +12V
DC when ON/ACC
f Blue Motor/electric
antenna relay control
lead
g White edged blue
strip
$PSOLÀHUUHOD\
control lead
h Black Ground
i Yellow To the +12V car
battery which is
energized at all times
7
English
EN
2 &RQQHFWWKHDQWHQQDDQGDPSOLÀHUDV
illustrated, if applicable.
Connector Connect to
1 ANTENNA Antenna
2 Socket for ISO male
connectors
As indicated in
Step 1 above
3 REAR LINE OUT R
(Socket)
Rear right speaker
4 REAR LINE OUT L
(Socket)
Rear left speaker
5 OE REMOTE
(Purple)
OE Remote
Tip
The pin arrangement for the ISO connectors depends
on the type of vehicle you drive. Be sure to make
proper connections to prevent damage to the unit.
Mount into the dashboard
1 If the car does not have an on-board drive
or navigation computer, disconnect the
negative terminal of the car battery.
If you disconnect the car battery in
a car that has an on-board drive or
navigation computer, the computer
may lose its memory.
If the car battery is not disconnected,
to avoid short-circuit, ensure that the
bare wires do not touch each other.
2 Ensure that car dashboard opening is
within these measurements:
3 Remove the mounting sleeve with the
supplied disassembly tools.
183 mm
53mm
5mm
8EN
4 Install the sleeve into the dashboard and
EHQGWKHWDEVRXWZDUGWRÀ[WKHVOHHYH
Note
,IWKHXQLWLVQRWÀ[HGE\VOHHYHEXWE\WKHVXSSOLHG
screws, skip this step.
5 Place the supplied rubber cushion over the
end of the mounting bolt.
183 mm
53.5 mm
6 Slide the unit into the dashboard until you
hear a click sound.
7 Reconnect the negative terminal of the car
battery.
Attach the front panel
1 Insert the notch on the front panel to the
chassis on the main unit.
2 Press the left end of the front panel
inwards until it is securely locked with a
"click".
This manual suits for next models
1
Table of contents
Other Philips Car Receiver manuals
Philips
Philips CEM2090 User manual
Philips
Philips CEM3100/00 User manual
Philips
Philips CEM2000B User manual
Philips
Philips CE130 User manual
Philips
Philips CarStudio CEM2101R/51 User manual
Philips
Philips CarStudio CEM2250 User manual
Philips
Philips CEM220/51 User manual
Philips
Philips CID2780 User manual
Philips
Philips CEM2000X/78 User manual
Philips
Philips CarStudio CEM5100 User manual
Philips
Philips CEM250 User manual
Philips
Philips CEM2000/55 User manual
Philips
Philips CED380 User manual
Philips
Philips CE130/51 User manual
Philips
Philips CarStudio CEM5100 User manual
Philips
Philips CE130X/78 User manual
Philips
Philips CE600BT User manual
Philips
Philips CE138/85 User manual
Philips
Philips CE233 User manual
Philips
Philips CEM3000B User manual
