PEZTIO Dashcam-M1 User manual
MODEL INTRODUCTION
Front & Cabin Dual 1080P Lens
Peztio M1 equipped with dual cameras (a front and a cabin cam)
and both of them can record videos in 1080P (1920*1080),
vividly capture the videos of both front side road and in-cabin
driver and passengers, ideal for the taxi driver. and Uber drivers.
Infrared Night Vision
The interior facing camera is surrounded by 4 infrared night
vision lights, which captures decent images of the interior of
your car when the passenger cabin is dark.
Parking Monitor
Even if the engine of your car is off, M1 can record the moment
of the collision: the shake triggers the G-sensor, then the
dashcam auto power on, and record a video. Protect your cars
from robbery and vandalism.
:NOTE::M1 supports 24 hours recording only when it connects
to the hardwire kit, please purchase a hardwire kit separately if
you want the camera to record videos 24 hours because the
hardwire kit is not included in the package.
Auto Lock the Vital Video in An Accident
When a severe bump happens to your vehicles, the current
video will be automatically locked and protected in the memory
card, becomes unable to overwrite by the loop recording.
Loop Recording
The Loop recording video can be set the timing 1 min, 2 mins
or 3 mins. It will overwrite the oldest unprotected video with
the lasted footage, make space for your memory card.
3.18 inches High-Definition IPS Screen
Built-in 3.18-inch HD large IPS screen, with 4 real-time display
modes for you to master the situation on both the front side of
the car and passenger cabin.
:Power Supply::Please keep the camera connect to the
cigarette lighter of your cars for daily use because the internal
battery is only supplying power for the emergent situation
when your car engine is off.
PACKAGE CONTENT
PRODUCT STRUCTURE
No
Content
Description
1
Stand
Attach the camera to the windscreen.
2
Front Lens
Record the front side video.
3
Reset Key
Push the reset hole to reset the dash
cam (recommend to use a needle).
4
Power Slot
Connect to the car cigarette charger.
5
Card Slot
Insert the SD card from here.
No
Content
Description
6
AV Jet
External equipment (not included).
7
Screen
3.18-inch HD IPS screen.
8
Cabin Cam
Record the cabin video.
9
IR lights
Captures decent cabin images when
the passenger cabin is dark.
10
UP Key
1. Upwards / switch display modes
2. Long press to switch albums from
front/cabin camera in video playback
mode.
11
Down Key
Downwards, Turn on/off microphone
12
Power Key
Long press: Turn on/off the camera
Short press: Turn on/off the screen
13
Menu Key
1. Single press: enter setting menu,
lock the current footage in recording
2. Double press: enter system menu.
3. Long press: Switch camera from
video, image and playback mode
14
OK Key
Press to confirm / enter the sub
menu / start & stop recording
PARAMETERS
Display Screen
3.18-inch IPS Screen
G-Sensor
Support
IR Camera
Cabin Camera Support
Resolution
Dual 1080P (front & cabin)
Battery
Build in 200mah
Loop recording
Support
Lens Angle
170 Degrees Wide Angle
Power Interface
Mini USB
Support SD card
Class 10 SD Card up to 64GB
Language
English, German, Japanese, etc.
Warranty
12 months
START TO USE
:Preparation in advance::
1. Please charge the camera for 15-20 mins before you set
up the camera in case the battery drained in shipping.
2. Please Use a good quality branded SD card between 32GB
and 64GB (Class 10 or UHS type 3) and format the card
within the Setup menu.
S1: Insert the SD Card
Please pay attention to the
right SD card insert orientation
following the instruction of the
picture on the right. Gently
insert the TF card into the slot
till a “tik” sound occurred.
S2: Stick it on the windscreen of your car
A. Find a suitable position of your windscreen: the most ideal
position is that will not shade your view while driving and
meanwhile both the front and cabin video are complete
recorded.
B. Use the wet & dry tissues to clean this point make sure the
dust is cleaned.
C. Rotate the integrated suction
(can be rotate up to 90 degrees),
remove the protective plastic
film from the sticky pad, push
the sticky pad onto the inner
windshield in the position you
selected.
S3: Connect the power to dash cam and cigarette lighter
Connect the car original charger to the cigarette lighter.
Route the cables through the top ceiling and the A-pillar so
that it does not interfere with driving. The camera will power on
and auto start recording once you spark the engine.
US customers UK customers
S4: Adjust the angle of front & cabin camera
A. Spark the engine to power on the
camera,
B. Twist the camera to adjust the
angle of the front video
C. Twist the rear lens to adjust the rear
lens image,
Make sure both the front and cabin
videos are completely recorded.
S5: Remove the camera
Please hold the integrated suction
of the camera, then pull the camera
and suction downside, then the
dashcam successfully removed from
the sticky pad which is sticked on the
windscreen.
:NOTE: Do not use brute force to pull the recorder out of the
windshield (will cause irreparable damage), please remove the
recorder according to the instructions above.
Scan the code to watch
the installation video. Or
search “Peztio M1” on
Youtube.com
SET UP YOUR CAMERA
Format the SD card
We recommend you format the SD card for the first time use
and format the SD card once a month regularly.
>Double press Menu button to enter the system setting.
>Choose the “Format”, press ok to enter the sub menu.
> Press OK to confirm formatting.
Set the date & time
>Double Press the Menu button to enter the system.
>Choose the “Date & Time”, press ok to enter the sub menu.
>Press Up/Down to change the date/time, and press OK to
confirm & jump into the next setting field.
>Press Menu button again to save & exit.
Turn on the IR Light of the cabin camera
When there is not enough light in the cabin, you can turn on
the infrared lens to shoot a clearer video (the video will become
black and white).
>Double press the menu button to enter system menu.
>Select the “IR Light”, press ok to turn it on/auto.
Set your preference display mode
This camera supports 4 display modes, namely PIP mode, half
front half cabin mode, front only mode and cabin only mode.
:Set display mode: You can press the up key to switch the
camera from 4 different display modes in when the camera is
in video recording mode.
Lock the Current Footage
You can short press the menu button to lock the current video
manually to save the vital evidence.
Switch the camera from different modes
Long press the menu button from video mode, camera mode
and playback mode
Table of contents
Other PEZTIO Dashcam manuals
