Panasonic CZ-RWSU3 User manual

Operating Instructions

Wireless Remote Controller

Model No.

CZ-RWSU3 CZ-RWSU2N CZ-RWSC3 CZ-RWSD2

CZ-RWST3N CZ-RWSL2N CZ-RWSK2

Panasonic Corporation

1006 Kadoma, Kadoma City, Osaka, Japan

Installation Instructions Separately Attached.

English

Before operating the unit, read these operating instructions thoroughly and keep them for future

reference.

CV6233317755

Panasonic Corporation

http://www.panasonic.com

TIMEROPERATION

STANDBY

1234

Front side Rear side

2(EN)

Safety Precautions

CAUTIONS

This appliance is intended to be used by expert or

trained users in shops, in light industry and on farms, or

for commercial use by lay persons.

This appliance can be used by children aged from 8

years and above and persons with reduced physical,

sensory or mental capabilities or lack of experience

and knowledge if they have been given supervision or

instruction concerning use of the appliance in a safe

way and understand the hazards involved.

WARNING

Do not use this appliance in a potentially explosive

atmosphere.

• Do not operate with wet hands.

• Do not wash with water.

In case of malfunction of this appliance, do not repair

by yourself. Contact the sales or service distributor for

repair.

In case of emergency, remove the power plug

from the socket or switch off the circuit breaker

or the means by which the system is isolated

from the mains power.

WARNING CAUTION

This symbol refers to a hazard

or unsafe practice which can

result in severe personal injury

or death.

This symbol refers to a hazard

or unsafe practice which can

result in personal injury or

product or property damage.

Matters to be observed Prohibited matters

ENGLISH

(EN)

Note:

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions: (1) This

device may not cause harmful interference, and (2) this

device must accept any interference received, including

interference that may cause undesired operation.

This equipment has been tested and found to comply with

the limits for a Class B digital device, pursuant to Part 15

of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a

residential installation. This equipment generates, uses

and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause

harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more

of the following measures:

• Reorient or relocate the receiving antenna.

•

Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different

from that to which the receiver is connected.

• Consult the distributor or an experienced radio/TV

technician for help.

FCC Caution: To assure continued compliance, follow

the attached installation instructions. Any changes

or modiﬁcations not expressly approved by the party

responsible for compliance could void the user’s authority

to operate this equipment.

4(EN)

Contents

1. Important Safety Instructions ................................................5

2. Names and Operations .........................................................6

3. Installing Batteries...............................................................10

4. Setting the Current Time .....................................................11

5. Operation ............................................................................12

6. Timer Operation ..................................................................14

7. Adjusting the Wind Direction...............................................16

8. Operating Multiple In/Outdoor Units Simultaneously ..........17

9. Using the Remote Controller...............................................18

10. For Best Results .................................................................18

11. Addresses ...........................................................................19

12. Emergency Operation .........................................................21

13. Miscellaneous Settings .......................................................22

14. Before Requesting Service .................................................23

15. Speciﬁcations......................................................................24

NOTICE

The English text is the original instructions.

Other languages are translation of the original instructions.

1. Important Safety Instructions

(EN)

ENGLISH

Before using the system, be sure to

read these “Important Safety

Instructions”.

After reading this manual, save it in a

convenient place.

Warning

Installation Precautions

• Do not install this equipment

yourself.

Installation should always be

performed by your distributor or a

professional service provider.

Electric shock or ﬁre may result if

an inexperienced person performs

any installation or wiring

procedures incorrectly.

• Use only speciﬁed air conditioners.

Always use only air conditions

speciﬁed by the distributor.

Precautions for Use

• Do not touch switches with wet

hands.

Electric shock and damage to the

system can result.

• Protect the remote controller from

water because it may cause

damage to the system.

• Stop the system and turn the

power off if you notice unusual

smells or other irregularities.

Continuing operation when the

system is out of order can result in

electric shock, ﬁre, and damage to

the system. Contact your

distributor.

• Do not swallow the battery.

Moving and Repair

Precautions

• Do not repair.

Never repair the system yourself.

• Contact your distributor before

moving the system.

Contact your distributor or a

professional service provider about

moving and reinstalling the system.

Electric shock or ﬁre may result if

an inexperienced person performs

any installation procedures

incorrectly.

2. Names and Operations

6(EN)

REMOTE CONTROLLER

ENGLISH

(EN)

One remote controller can control a group of up to eight indoor units.

(See page 17)

1. Operation Display

Displays the operation status.

(The ﬁgure shows all the

statuses.)

• The auto-ﬂap display may be

different, depending on the

installed unit. (See page 16.)

2. Start/Stop button

Pressing this button once starts

and pressing again stops the

operation.

3. Fan speed button

4. Swing/Wind Direction button

5. Timer setting button

Use for operating with a timer.

6. Reset button

Use this button after changing the

batteries.

7. Cover

Press at the top center and then

slide down.

8. Transmitter

9. Remote control sensor

Detects the temperature at the

remote controller when detection

has been switched to the remote

controller by the sensor button.

10.Temperature setting buttons

raises the temperature

setting 1 °C at a time.

lowers the temperature

setting 1 °C at a time.

11.Filter button

CZ-RWSC3

Press to turn off the ﬁlter lamp on

the receiver.

12.Mode Select button

Press to switch the operation

mode.

13.Ventilation button

Use this when connected to an

aftermarket fan. Pressing this

button starts and stops the fan.

When the air conditioner is started

or stopped, the fan starts or stops

at the same time. ( appears on

the display of the remote

controller when the fan is

operating.)

14.Address button

15.Sensor button

Used this to activate the

temperature sensor on the remote

controller instead of the one on

the indoor unit. The temperature

sensor on the indoor unit is

selected before shipment. At this

time is shown on the display.

16.Clock button

Use this to set the clock.

From this page, the names of

remote controller’s buttons will be

indicated with the above

illustrations.

E.g.: Start/Stop button 

8(EN)

2. Names and Operations (Cont.)

Receiver

1543

CZ-RWSD2CZ-RWSU2NCZ-RWSU3

345

ADDRESS 1

ADDRESS 2

ADDRESS 3

REM SUB/MAIN

1234

CZ-RWSC3

Front side Rear side

CZ-RWSL2N

345

Operation Panel

TIMEROPERATION

STANDBY

CZ-RWSK2

(For wall mounted type indoor unit)

1543

CZ-RWST3N

Display

ENGLISH

(EN)

1. Receiver

Receives the signal sent from the

remote controller.

2. Emergency operation button

Indicator lamps

When an error occurs, one of the lamps

ﬂashes. When an indicator lamp is

ﬂashing, refer to “14. Before Requesting

Service”.

3. OPERATION lamp

Lights up when the unit is

operating.

4. TIMER lamp

Lights up when the timer is set.

5. STANDBY lamp

• The lamp in the HEAT mode

lights up at the following times:

during the startup, during the

thermostat operation, and during

the defrosting.

• The lamp ﬂashes when an error

occurs.

6. FILTER lamp

This lamp is for notifying you

when the ﬁlter needs to be

cleaned.

7. Address switch

See “11. Addresses”.

Note

• If non-cooling/heating free type is

being used, it will beep twice and the

operating lamp will light up on the

display; if the timer and standby lamps

blink alternately, a conﬂict between the

heating and cooling exists, so the unit

cannot operate in the desired mode.

(On models that do not have an Auto

function, even if Auto is selected, it

works in the same way.)

• When the local operation is disabled

by centralized control or similar cause,

and if the Start/Stop , Mode or

Temperature setting button

is pressed, the unit will beep ﬁve times

and the change will not be made.

3. Installing Batteries

10 (EN)

1. Remove the cover.

2. Insert two LR03 size batteries.

Put the batteries in with the polarity [+/–]

as shown in the ﬁgure.

3. Gently insert one end of an

unfolded paper clip (or a similar

object that can ﬁt) into the Reset

hole and press the Reset button

inside the hole, then put the cover

back on.

Notes

• Change the batteries when the display of the

remote controller gets weak, or if it will not work

unless close to the receiver.

(Alkaline batteries generally last about one year.)

• When changing batteries, always use two fresh batteries of the same make.

• If the remote controller will not be used for a long period of time, remove the batteries.

• Please dispose of batteries appropriately.

• After changing the batteries, follow the procedures on the next page to reset the

current time.

How to Remove Batteries

1. Remove the cover.

2. Press the battery toward the

negative end and lift it out by

its positive end. (See the

ﬁgure on the right.)

3. Remove the other battery in

the same way.

Note

• Dispose of the used batteries at the designated location in compliance with the

applicable local ordinances.

Warning

• Do not swallow the battery.

•

After removing the battery from remote controller, keep it out of the reach of children.

The battery can cause death by suffocation if swallowed.

• When inserting the battery, make sure the polarities (+ and -) are correct.

Reset hole

Cover

Other manuals for CZ-RWSU3

This manual suits for next models

Table of contents

Other Panasonic Remote Control manuals

Panasonic

Panasonic EUR501455 User manual

Panasonic

Panasonic Palmcorder PV-DRC9 User manual

Panasonic

Panasonic EUR7603Z50 User manual

Panasonic

Panasonic TY-RM50VW User manual

Panasonic

Panasonic CZ-01RT11P User manual

Panasonic

Panasonic CZ-RWS3 User manual

Panasonic

Panasonic CZ-RTC6WBLW User manual

Panasonic

Panasonic WV-CU50 User manual

Panasonic

Panasonic EUR511163 User manual

Panasonic

Panasonic CZ-RD514C Installation and operation manual

Panasonic

Panasonic AK-HRP1015G User manual

Panasonic

Panasonic CZ-RC515UA Operating manual

Panasonic

Panasonic EUR511511 guide User manual

Panasonic

Panasonic CZ-RTC2 User manual

Panasonic

Panasonic EUR501371 Use and maintenance manual

Panasonic

Panasonic WV-CU161 User manual

Panasonic

Panasonic AK-HRP1005G User manual

Panasonic

Panasonic CZ-RTC4 User manual

Panasonic

Panasonic CZ-RTC2 User manual

Panasonic

Panasonic EUR501375 User manual

Panasonic

Panasonic WV-CU20 User manual

Panasonic

Panasonic SH-MK390 User manual

Panasonic

Panasonic AKHRP200 User manual

Panasonic

Panasonic WV-CB550 User manual

Popular Remote Control manuals by other brands

Bang & Olufsen

Bang & Olufsen Beo4 user manual

Sunwave Tech.

Sunwave Tech. RemoteComm SRC-7000 user manual

Multiplex

Multiplex PROFI TX 9 instructions

One Remote

One Remote RMB4 user manual

FUTABA

FUTABA 9ZAP - PART2 manual

HR Matic

HR Matic HR MULTI 3 quick start guide

Yamaha

Yamaha ACC-GNRST-30-20 installation instructions

EisSound

EisSound KBSOUND user manual

Marantz

Marantz RC101 user guide

Conrad

Conrad FS20 TC6 operating instructions

Anritsu

Anritsu MP1777A Operation manual

Niles

Niles WVC100 Installation & operating guide

RCA

RCA RCU1300 manual

Bang & Olufsen

Bang & Olufsen BEO6 Getting started

GE 94901 instruction manual

Onbon

Onbon YQ1-75 user manual

FUTABA

FUTABA R7108SB Full manual

Invacare

Invacare G91S user manual