Orla PX100 User manual
The Sound of Italy
PX100
Digital Keyboard
User’s Manual
SAFETY PRECAUTIONS AND INSTRUCTIONS
WARNING
Make sure that the voltage set is suitable for the instrument (the voltage is
indicated next to the power inlet).
When using electric products, always follow basic precautions, including the
following:
Read all of these instructions before using the product.
To reduce the risk of injury, close supervision is necessary when the product is
used near children.
Do not use this product near water - for example, near a bathtub, washbowl,
kitchen sink, in a wet basement, near a swimming pool, or the like.
This product, either alone or in combination with an amplifier and headphones,
or speakers may be capable of producing sound levels that could cause permanent
hearing loss Do not operate for a long period of time at a high volume level, or at
a level that is uncomfortable. If you experience any hearing loss, or ringing in
your ears, you should consult an audiologist.
The product should be located so that its location, or position, does not interfere
with proper ventilation.
This product should only be located away from heat sources such as radiators,
heat registers, and other products that cause heat.
The product should be connected only to the type of power supply described in
the operating instructions, or as marked on the product.
This product may be equipped with a polarised plug. This is a safety feature. If
you are unable to insert the plug into the outlet, contact an electrician to replace
your obsolete outlet. Do not defeat the safety purpose of the plug.
The power-supply cord of the product should be unplugged from the outlet when
left unused for a long period of time When re-plugging unit, turn on the keyboard
and leave on for 3-5 hours to recharge internal battery. The battery may need to
be replaced after two or three years of use.
Care should be taken so that objects do not fall, and liquids are not spilled, into
the cabinet through openings
The product should be serviced by qualified personnel.
Do not attempt to service the product beyond that described in the maintenance
instructions. All other servicing should be referred to qualified service personnel.
Panel Contents
1. Power Button
2. Main Volume D ial
3. ACC.Volume Button
4. Tempo Button
5. Trans./Tune Button
6. KBD.Mode Button
7. Touch Button
8. Sustain Button
9. Effect Button
10. Chord Button
11. Synchro/Fill In Button
12. Start/Stop Button
13. Intro/Ending Button
14. Metronome Button
15. Voice/Style (Left/Right) Button
16. [+] / [-] Buttons
[0] - [9] Buttons
2
17. Setup Button
18. Chord Dictionary Button
19. Demo/Play Button
20. 3 Steps Button
21. Record Button
22. Play Button
23. LCD Display
Rear Panel
24. Phones
25. DC 12V
Panel Contents
3
LCD Display
LCD DISPLAY
1. VOICE/STYLE/DEMO STATUS
2. VOICE/STYLE/DEMO NUMBER OR FUNCTION VALUE ADJUSTMENT
3. TEMPO
4. BEAT INDICATOR
5. METRONOME
6. CHORD TYPE
7. CONTROLS: CHORD, SPLIT, DUAL, TOUCH, EFFECT,
SUSTAIN, VIBRATO
8. VOICE
9. STYLE
10. SONG
31
42
5
6
TEMPO
CHORD TYPE
119
dim
6
513
mM7
augsus4
CHORD SPLIT DUAL TOUCH
VOICE 8
STYLE 9
SONG 10
EFFECT SUSTAIN VIBRATO
7
4
Basic Operation
Turning On the Power
1. Ensure the keyboard is turned off when connecting and DC POWER
disconnecting the power, and turn the volume control to the
minimum level.
2. Connect the adaptor to the AC mains wall outlet and plug the cord into
the keyboard, then turn the power on.
NOTE:
When the keyboard is not in use, or during a thunderstorm, please
disconnect the power for safety purposes.
Headphone jack
Plug a set of stereo headphones into the phones jack, the
internal speaker system will automatically shut off when
the headphones are plugged in.
PHONES
NOTE:
Never use headphones at a high volume, as high volume levels could cause
permanent hearing damage.
Setting Music Rest
Please set up the music rest as per the instructions below:
5
Basic Operation
Adjusting the Main Volume
Use MASTER VOLUME control to adjust the volume to your
desired level.
MIN MAX
Demo Play
There are 10 preset demo songs and 100 learning songs that you can play individually.
Here's how you can select and play the songs.
1. Press the [DEMO/PLAY] button, then the demo songs will play in sequence.
TEMPO VOICE
STYLE
DEMO/PLAY 3 STEPS SONG
CHORD TYPE
dim 6 119513
m
M
7
augsus4
CHORD SPLIT DUAL TOUCHEFFECTSUSTAIN VIBRATO
2. Press the [0] ~ [9] numeric buttons or [+/-] buttons to select the demo songs.
01~09 demo: press 01~09
10~99 demo: press 11~99
100~110 demo: hold the [1] button till the LCD displays: 1_ , then enter the tens and units
digits.
3. Press the [DEMO/PLAY ] button again to stop playing.
6
Voices
Your instrument has 129 (
including 128 GM standard voices (patches 01~128)) voices
that you can select and play. (See voice list: p36)
Select a Voice
You can use [+] and [-] buttons or numeric buttons to select the desired voices.
1~9 voice: press 01~09.
10~99 voice: press 10~99.
100~129 voice: hold the [1] button till the LCD displays: 1_ , then enter the tens digit
and single digits.
+0123
-5678
Voice/Style Button
TEMPO
VOICE
STYLE
SONG
4CHORD TYPE 119
dim
6
513
mM7
augsus4
9
CHORD SPLIT DUAL TOUCH EFFECT SUSTAIN VIBRATO
Press the [VOICE/STYLE] button to switch between the Voice and Style
mode.
In the "3 Steps" mode, press the [VOICE/STYLE] button to switch between Left or Right
part.
VOICE/STYLE
LEFT/RIGHT
NOTE:
Please read the display on the LCD when pressing [VOICE/STYLE] button.
7
Voices
KBD.Mode Button
1)Split Mode
Your keyboard can be split into two sections, which means that different voices can be played
by the left and right hands at the same time.
Select a Split Voice
Press the [KBD.MODE] button to enter the Split mode, the split voice number and name
displays on the LCD message area.
Use the [+] and [-] buttons or the numeric buttons to select the desired split voice number
(01 though 129).
TEMPO VOICE
STYLE
KBD.MODE SONG
CHORD TYPE
dim 6 119513
m
M
7
augsus4
CHORD SPLIT DUAL TOUCHEFFECTSUSTAIN VIBRATO
Press the [KBD.MODE] button repeatedly until its indication icon is not showing.
Adjust the Split Voice Volume
Press the [SETUP] button repeatedly to select S.Volume . (See P21)
Change the Split Point
Press the [SETUP] button repeatedly to select .Point (See P26)
2) Dual
This function allows two voices to be combined, so that they play at the same time, producing a
layered sound. This is useful for creating rich orchestral sounds, for example, the layering of Piano
and Strings. When the dual function is off, the voice indicated is VOICE R1.
When the dual function is on, the voice indicated is VOICE R2.
8
Table of contents
Languages:
Other Orla Electronic Keyboard manuals
