optonica 6341 User manual
● Apply to single color or dual color LED controller.
● Each remote can match one or more receiver.
● R bC 2032 attery powered.
● Operate with LED indicator light.
●Magnet on the back which can be easily stuck on back holder or any metal surfaces.
User Manual Ver 1.0.6
Technical Parameters
Input and Output
Warranty
3 years
Warranty
Operation temperature
Case temperature (Max.)
Environment
IP20
IP rating
Ta: -30
O
C ~ +55
O
C
T c: +85
O
C
Features
Page 1
10-Key RF Remote Controller
Model No.: 6341
4 zone dimming/10-key/Wireless remote 30m distance/CR2032 battery/Magnet stuck fix
Output signal RF 2.4GHz( )
Working voltage 3VDC CR2032( )
Working current ＜5mA
Standby current ＜2μA
Standby time 2 years
Remote distance 30m
Safety and EMC
EMC standard (EMC) EN301 489,EN 62479
Radio Equipment(RED) EN300 328
Certification CE,EMC,LVD,RED
EN60950
Safety standard(LVD)
Mechanical Structures and Installations
Match Remote Control (two match ways)
Use the controller’s Match key
Match:
Short press match key, immediately press on/off
key (single zone remote) or zone key (multiple zone
remote) of the remote.
Use Power Restart
Match:
Switch off the power, then switch on power again,
immediately short press on/off key (single zone remote)
or zone key (multiple zone remote) 3 times on the remote.
The light blinks 3 times means match is successful.
.
Delete:
Switch off the power, then switch on power again,
immediately short press on/off key (single zone remote)
or zone key (multiple zone remote) 5 times on the remote.
The light blinks 5 times means all matched remotes were
deleted.
Delete:
Press and hold match key for 5s to delete all match,
The light blinks 5 times means all matched remotes
were deleted.
End user can choose the suitable match/delete ways. Two options are offered for selection:
LVDRED
6341
4 Zone Dimming
11mm
135mm
40mm
Note: Before the first use,
please remove the protective film on the battery.
53 .50 mm
CR2032 Batter y
To fix the remote, three options are offered for selection:
Option 1: stuck the remote on any metal surfaces directly.
Option 2: fix the remote' back holder on the wall with two screws.
Option 3: adhere the remote' back holder to the wall with paster.
Back holder with magnet
Safety information
1. Read all instructions carefully before you begin this installation.
2. When installing batter y, pay attention to the battery positive and negative polarity.
A long time without the remote control, remove the battery.
When remote distance becomes smaller and insensitive, replace the battery.
3. If no response from the receiver, please re-match the remote.
4. Gently handle remote, beware of falling.
5. For indoor and dry location use only.
User Manual Ver 1.0.6 Page 2
ON O FF
ON O FF
ON O FF
OF F
ON O FF
All
ON
All
All on All off
Zone1 on Zone1 off
Zone2 on
Zone2 off
Zone3 on Zone3 off
Zone4 on Zone4 off
1
2
3
4
All on: Turn on all 4 zone light .
All off: Turn off all 4 zone light .
Zone 1 4 on -:
Short press turn on zone light,
long press 1-6s increase brightness continuously.
Zone 1 4 off -:
Short press turn off zone light,
long press 1-6s decrease brightness continuously.
4 zone dimming remote
●
LED indicator
Key function
Other optonica Remote Control manuals
