@ 1.5VA
Enclosure Elliptical Extrusion
Dimensions (mm) 25 x 40 x 38L (excluding connectors)
Weight of Module 50g
Operating
Temperature -40 to 75°C
Relative Humidity 0 to 95% non-condensing
102881005
▲
ELECTROMAGNETIC COMPATIBILITY
WARNING: This is a Class A product. In a domestic
environment this product may cause radio interference
in which case the user may be required to take
adequate measures.
▲
OPTICAL OUTPUT OPERATION
WARNING: Laser Safety: Class 1 Laser Product per
IEC/EN 60825-1:20011 standard.
Class 1
The OSD8810 is a Class 1 laser product.
Precautions
▲
All service personnel should be provided training
as to the hazards of direct viewing of laser
radiation and of the precautionary measures
during servicing of equipment
▲
Areas where laser products are installed should
be restricted in access to trained service
personnel only and appropriate warning signs
posted in the work area.
▲
All laser apertures should be covered by
protective covers when not connected to optical
fibers. Never leave outputs uncovered.
▲
Laser equipment should be positioned above or
below eye level where possible. Apertures should
be positioned away from personnel.
▲
Protective eyewear should be worn in the vicinity
of laser equipment
Maintenance
This equipment has been fully tested prior to dispatch and
is ready for immediate operation. However it is advisable to
check for external transportation damage before operation.
If damage is evident, return the unit with the packaging to
your supplier immediately.
Visually check for the following:
▲
Check that the correct power source is
connected to the power socket.
▲
Check that the video signal is connected to the
modem correctly and that the distant modem
has been terminated correctly to any external
equipment.
▲
Inspect the optical connector for any
contamination and clean using isopropyl
alcohol and a lint free tissue if any
contamination is detected.
▲
Check that any external terminations are
connected if the system configuration
requires them.
Warranty/Repairs
Thank you for purchasing equipment designed, manufactured
and serviced by Optical Systems Design (OSD). OSD warrants
that at the time of shipment, its products are free from defects
in material and workmanship and conforms to specifications.
For warranty period and repair service please call your local
OSD distributor.
Optical Systems Design reserves the right to repair or replace
faulty modules/units. Should your unit be faulty, please obtain a
“Return Material Authorisation” (RMA) form and number before
returning goods.
Goods must be returned in adequate packing material to
Optical Systems Design, Warriewood or its nominated
authorised representative, for all repairs.
This warranty does not apply to defects caused by
unauthorized modifications, misuse, abuse or transport
damage to the equipment. All modifications to OSD’s standard
product will need written authorization and will be charged at
normal repair rates. All modifications are to be carried out by
OSD Technicians. Warranty is void if unauthorized removal
and/or tampering with serial number and/or repair labels is
evident.
OPTICAL SYSTEMS DESIGN PTY LTD
7/1 Vuko Place, Warriewood 2102.
PO Box 891, Mona Vale,
NSW, Australia 1660.
Phone: +61 2 9913 8540
Fax: +61 2 9913 8735
