ELECTRIC INSECTICIDES
IN GENERAL
b. Unscrew the retaining screw of the
B e f o r e r e m o v i n g t h e d r a w e r f o l l o w
carefully the below steps.
There is a special drawer at the bottom
side of the device where all dead insects
are collect e d . To r e m o v e t h e d r a w e r
unscrew the retaining screw.
Without using any chemical material it offers
a c o m p l e t e p r o t e c t i o n a g a i n s t m a n y
insects like mosquitos, flies, tiny gnats etc.
There is an exterior net in order to protect
birds, animals or human beings that are
close enough.
WARNING!!!
a. Remove the plug of the mains.
The device was created to exterminate all
disturbing insects. The special fluorescent tubes
(Black Light) attract insects from a long
distance. For this reason it could be used in
every place that many insects exist. They are
attracted and pass though the interior metal net,
they are exterminated by high voltage.
again the retaining screw and
b. Unfasten the retaining screws and
In case of changing the lamps or the starter,
follow carefully the below steps.
drawer and re- install it. Then screw
reconnect the device on the mains.
remove the protective exterior net.
a. Remove the plug of the mains.
drawer.
c. Remove the special drawer, clean the
c. Replace the tube or the starter which
925015000_09_010 925015000_09_010
RT-15 RT-15/2 RT-15/6 RT-15/7
TECHNICAL CHARACTERISTICS
OPERATION TEMPERATURE RANGE
RELATIVE HUMIDITY
CONSTRUCTION MATERIALS
EXTERNAL DIMENSIONS
TYPICAL WEIGHT
GUARANTEE
OPERATION VOLTAGE
DESCRIPTION
MAXIMUM POWER CONSUMPTION
DEGREES OF COVER PROTECTION
PRODUCED IN ACCORDANCE WITH
GRID VOLTAGE
FLUORESCENT LAMP
220-240V AC/50-60Hz
Electric insecticide Electric insecticide with mirror
IP 20
3.5kV
3x36W BL 3x36W BL 2x36W BL
270VA 270VA150VA
EN 60335-1, EN 60335-2-59
o
0 to 60 C
Up to 95%
Bayblend FR3010, electrostatic painted aluminum
2 years (1 year for the lamps)
13.7kgr.13kgr.13.6kgr. 12.9kgr.
1250 x 140 x 480 mm (L x W x H)
is worn.
The models RT-15/6 and RT-15/7 are special
models with a mirror for wall-mounting
installation. The connection is the same as
previously. The installation is as follows.
mains and it is ready to operate.
Installation
First remove the screws 1A and 1B(Figure
1) which are found at the upper side-wise
and replace them with the plastic holders.
Afterwards install the apparatus on the wall.
Finally place the plastic holders at point
2A and 2B (Figure 1) and fix it on the wall.
and fasten the removed screws.
It is placed in a clear and visible place so
as to attract insects easily .
AT T E N T I O N ! ! ! W h e n t h e d e v i c e i s
operating the protective exterior net must
be installed.
d. Reinstall the protective exterior net
Just plug the apparatus to the mains and it is
ready for operation.
e. Finish reconnecting the device on the
It includes two hooks on top side for ceiling-
mounting installation using a chain. The
RT15 and RT-15/2 are suitable for hospitals,
army camps, factories, etc.
Page 2 from 2Page 1 from 2
Olympia Electronics - European manufacturer
Thank you for your trust in our products
1. Hole (for wall-mounted installation).
2. Hole (for wall-mounted installation).
3. Special drawer.
4. Installation point (for normal installation with chain).
5. Fuse holder.
6. Plug.
7. Protection grid.
Description
Figure 1
2B
2A
3
7
1A 5
6
1B
4
Olympia Electronics reserves the right to repair or to replace the returned goods and to or not charge
the buyer depending on the reason of defection. Olympia Electronics reserves the right to charge or
not the buyer the transportation cost.
72nd km. O.N.R. Thessaloniki-Katerini
www.olympia-electronics.com
P.C. 60300 P.O. Box 06 Εginio Pierias Greece
Olympia Electronics guarantees the quality, condition and operation of the goods. The period of
warranty is specified in the official catalogue of Olympia Electronics and also in the technical leaflet,
which accompanies each product. This warranty ceases to exist if the buyer does not follow the
technical instructions included in official documents given by Olympia Electronics or if the buyer
modifies the goods provided or has any repairs or re-setting done by a third party, unless Olympia
Electronics has fully agreed to them in writing. Products that have been damaged can be returned to
the premises of our company for repair or replacement, as long as the warranty period is valid.
HEAD OFFICE
WARRANTY
WARNING!!!
- The device is suitable for internal installation.
- The device must be kept away from children.
- The device must be not installed in ar e a s w i th
combustible gases or explosive dust.
- The device is not suitable for use in Sheds, cottages,
stables and likewise places.
- If the device’s cable is worn or damaged it must be
replaced from OLYMPIA ELECTRONICS SERVICE
department.
