Objecto T1 User manual

USER MANUAL
F
F
1
180200aT1CHMS-011USAll.indb1180200aT1CHMS-011USAll.indb1 2018/09/1411:09:362018/09/1411:09:36

2
English
Safety Information
This section presents important safety information. Always follow
these instructions when using the product.
IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliances, basic precautions should always be
followed to reduce the risk of fire, electric shock, and injury to
persons, including the following:
1. Read all instructions before using this product.
2. This product is hot when in use. To avoid burns, do not let bare skin touch hot
surfaces. Use the handle when moving this product. Keep combustible materials,
such as furniture, pillows, bedding, papers, clothes, and curtains at least 1.6 feet
from the foot warmer and keep them away from the sides and rear.
3. Extreme caution is necessary when the foot warmer is used by or near children or
invalids and whenever the product is left operating and unattended.
4. Always unplug the product when not in use.
5. Do not operate the foot warmer with a damaged cord or plug or after the product
malfunctions, has been dropped or damaged in any manner. Return the product
to authorized service facility for examination, electrical or mechanical adjustment,
or repair.
6. Do not use outdoors.
7. This product is NOT intended for use on tabletops or desktops, use ONLY ON
FLOORS. It is not to be used in wet or moist locations, such as bathrooms and
laundry areas. Never position the product where it may fall into a bathtub or other
water container.
8. Do not run cord under carpeting. Do not cover cord with throw rugs, runners,
or similar coverings. Do not run cord under furniture or appliances. Arrange cord
away from traffic area to avoid tripping over it.
9. To disconnect the product, first turn controls to the OFF position, then grip the
plug and pull it from the wall outlet. Never pull by the cord.
10. Do not insert or allow foreign objects to enter any ventilation or exhaust opening
as this may cause an electric shock or fire, or damage the foot warmer.
11. The foot warmer has hot and/or sparking parts inside. Do not use it in the areas
where gasoline, paint, or flammable liquids are used or stored.
12. Use this product only as described in this manual. Any other use not
recommended by the manufacturer may cause fire, electric shock, or injury to
persons.
13. Always plug the product directly into a wall outlet/receptacle. Never use with an
extension cord or power strip.
14. To prevent a possible fire, do not block air intakes or exhaust in any manner.
Do not use on soft surfaces, like a bed, where openings may become blocked.
15. This appliance has a polarized plug (one blade is wider than the other). To reduce
the risk of electric shock, this plug is intended to fit in a polarized outlet only one
way. lf the plug does not fit fully in the outlet, reverse the plug. lf it still does not
fit, contact a qualified electrician.
Do not modify the plug in any way.
180200aT1CHMS-011USAll.indb2180200aT1CHMS-011USAll.indb2 2018/09/1411:09:362018/09/1411:09:36

3
English
16. a) A short power-supply cord (or short detachable power-supply cord) is provided
to reduce the risks resulting from becoming entangled in or tripping over a
longer cord.
b) Extension cords (or longer detachable power-supply cords) are available and
may be used if care is exercised in their use.
c) If an extension cord (or a long detachable power-supply cord) is used:
1) The marked electrical rating of the detachable power-supply cord or extension
cord should be at least as great as the electrical rating of the appliance;
2) If the appliance is of the grounded type, the extension cord should be a
grounding type 3- wire cord; and
3) The longer cord should be arranged so that it will not drape over the
countertop or tabletop where it can be tripped over, snagged, or pulled on
unintentionally (especially by children).
17.
SAVE THESE INSTRUCTIONS
WARNING
In order to avoid any electrical shock, short-circuit, burns, injury, or
fire:
Use only with the designated power supply 120 V.•
Do not scratch, damage, modify, forcibly bend, pull, twist, bind/clamp, or place heavy objects on•
the power cord.
Do not use if the power cord or plug is damaged, or if the plug is not fully inserted into the•
outlet.
Do not allow children to use this product by themselves, and keep product and power cords out•
of the reach of small children.
Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may•
cause an electric shock or fire, or damage the foot warmer.
Do not leave items like spray cans near the foot warmer.•
Do not use while clothing or a blanket is hanging on the foot warmer.•
Do not use while in bed.•
If you notice anything unusual during operation (burning smell, smoke, etc.), immediately stop•
use, and unplug the power cord.
Use a wall outlet rated at 15A or greater, with no other devices plugged in.•
Wipe off any dust adhering to the power plug blades and plug surface.•
After use, be sure to turn off the power, and unplug the power cord from the outlet.•
When cleaning the product, for safety's sake be sure to unplug it from the outlet.•
Do not disassemble. This product may only be disassembled by qualified repair technicians. To•
180200aT1CHMS-011USAll.indb3180200aT1CHMS-011USAll.indb3 2018/09/1411:09:362018/09/1411:09:36

4
English
request repair, see Warranty Page at the back of this manual.
Do not plug in or unplug the product while your hands are wet.•
Do not get the product wet.•
CAUTION
Always allow the unit to cool down before picking it up for service or storage.•
Do not use close to walls or furniture.•
Do not use in unstable locations or on flooring that may be easily damaged by heat.•
Never use in a location that produces flammable or corrosive gases, or where they accumulate.•
Do not use for other purposes, such as drying things.•
Do not leave the room while the foot warmer is on.•
Do not use it as a heater for dogs, cats, or other pets.•
When cleaning the product, do not use household detergent, thinner, benzene, alcohol or a•
polishing powder or spray.
Always keep the filter in place while operating the foot warmer.•
Do not touch places that get extremely hot, such as the hot air outlet during use or for some•
time afterwards.
180200aT1CHMS-011USAll.indb4180200aT1CHMS-011USAll.indb4 2018/09/1411:09:362018/09/1411:09:36

5
English
Names of Parts and Their Functions
Handle
Power switch (Power lamp)
Heater Lamp
Front
Back
Power cord
Power plug
[Filter cover + activated carbon filter] × 2
Bottom
Air intake
Hot air outlet
Activated carbon filter
Filter cover
180200aT1CHMS-011USAll.indb5180200aT1CHMS-011USAll.indb5 2018/09/1411:09:362018/09/1411:09:36

6
English
Correct Use of the Foot Warmer
Preparation Before Use
CAUTION
Always keep the filter case and the activated carbon filter in place while
running it.
Running without the filter case or activated carbon filter could result in fire or
damage to the product.
Attach the [filter cover + activated carbon filter] included in the main unit1.
on the two recesses on the back side of the unit.
1
1
2
2
Catch
Filter cover + activated carbon filter
Body recess
Remove the [filter cover + activated carbon filter] packaging.• As shown in the above figure, 1. Attach the front, 2. Push in the rear catch until• you hear a click.
Attach to the two left and right recesses in the same way.•
Place the foot warmer on a level surface.2.
Make sure nothing flammable is nearby; if there is something flammable, move it*
before using the foot warmer.
Keep the foot warmer an appropriate distance from walls and
surrounding objects (Otherwise, it could result in a fire.)
Do not use it in the following kinds of locations:
Unstable places, such as on a thick carpet or on top of a cushion (which may*
cause the unit to tilt, be unsteady or tip over), on easily flammable items (which
could result in a fire), tightly sealed spaces, etc.
About Safety Features
If the foot warmer falls over during use, it activates the tipover switch, turning the• power off.
If the foot warmer gets too hot, it activates the thermostat and automatically• shuts it off. (Once it cools down, it turns back on.) If the temperature gets even
hotter, it activates the thermal fuse, cutting off the operation circuit. (Even after
it cools down, it will not turn back on.) Please contact your dealer or the Service
Center (see the back cover).
180200aT1CHMS-011USAll.indb6180200aT1CHMS-011USAll.indb6 2018/09/1411:09:362018/09/1411:09:36

7
English
Auto switch-off function
When operation continues for about 8 hours, the front heater lamp and the power
turn off.
Turn OFF the power switch momentarily and turn it ON again when the Auto*
switch-off function operates.
Plug the power cord into the outlet.3.
Make sure that the operation switch is OFF, and then plug the power plug
into the power outlet.
WARNING
Use a wall outlet rated at 15A or greater, with no other devices plugged•
in.
If used with other devices plugged in, the outlet may heat abnormally and ignite.
Do not use while clothing is hanging on the foot warmer.•
Do not use the foot warmer with the power cord bundled up.•
If you are going out or will be away from the foot warmer for a long time,•
unplug the power cord from the outlet.
The foot warmer may have stopped due to the Safety Features. Since operation
will start automatically when the temperature goes down, you could forget to
turn it off or a fire could result.
The product is not a seat or a step, so do not sit or step on it.•
180200aT1CHMS-011USAll.indb7180200aT1CHMS-011USAll.indb7 2018/09/1411:09:362018/09/1411:09:36

8
English
Usage
Turn the power switch ON.1.
[ON]: ON
[OFF]: OFF
Operation starts and the foot warmer starts to warm up.
During operation, the front heater lamp (green) and the power lamp (power switch)
light up.
CAUTION
Do not leave the foot warmer unattended during use.•
Only move the foot warmer after it has cooled down, and use the handle.•
Do not touch the hot air outlet during use or for some time afterwards.•
Turn the power switch OFF after use2.
Unplug the power plug3.
180200aT1CHMS-011USAll.indb8180200aT1CHMS-011USAll.indb8 2018/09/1411:09:362018/09/1411:09:36

9
English
Cleaning and Storage
WARNING
When cleaning the product, be sure to unplug the power plug from the
outlet and check that the unit has cooled down.
Failing to do so can result in an electrical shock or burns.
CAUTION
Never use household detergent, thinner, benzene, alcohol, or polishing•
powder on this product.
When using a cloth containing chemical substances, follow its safety•
information.
When cleaning the product, do not use neutral detergent for tableware•
containing citrus ingredients such as orange or lime. Doing so could cause
discoloration or degradation of the plastic.
Cleaning the Foot Warmer
When the unit gets dirty, wipe it clean with a soft cloth dipped in warm
water and/or dish detergent (not citrus type) and well wrung out. Then
polish it gently with a dry cloth. (Do not rub hard on the plastic parts.
Doing so may scratch them.)
Cleaning the hot air outlet/air intake
For normal cleaning, suck up any dust with a vacuum cleaner.
180200aT1CHMS-011USAll.indb9180200aT1CHMS-011USAll.indb9 2018/09/1411:09:362018/09/1411:09:36

10
English
Replacing Activated Carbon Filters
Knob
Activated carbon filter
Filter cover
Catch
Activated carbon filter
Knob
Please attach so that there is nothing
protruding from the filter cover catch.
Filter cover
If the filters are torn, extremely dirty or lost, purchase new ones.
When purchasing activated carbon filters, contact the sales outlet where
you purchased the foot warmer or the Service Center.
Activated carbon filters are not free even during the warranty period.*
Replacement ACFT-CHMR011 filters are sold separately.
Please contact your dealer or the Service Center.
CAUTION
Always attach the activated carbon filter and filter cover except when
cleaning.
Failure to do so may cause foreign matter to enter the heater, causing accidents,
fire, or malfunction.
180200aT1CHMS-011USAll.indb10180200aT1CHMS-011USAll.indb10 2018/09/1411:09:362018/09/1411:09:36
Table of contents
Languages:

















