Nokia RH-34 Series Quick start guide
CCS Technical Documentation
RH-34 Series Transceivers
Issue 1 11/2003 Confidential ©2003 Nokia Corporation
Disassembly/Assembly
RH-34
Disassembly/Assembly CCS Technical Documentation
Page 2 ©2003 Nokia Corporation Confidential Issue 1 11/2003
Step-by-Step Disassembly Instructions
Alway use ESD protection
Disassembly Instructions
Step-by-Step Disassembly Instructions (Model 6585)
1. Push the Release Button to the left before pulling up
the B-Cover. Remove the battery and the SIM card.
2. Unlock the top guidance to remove the A-Cover.
3. Unscrew the six T6 screws, using the shown order.
For assembly, the reverse order and a torque of 17Ncm
must be used.
4. Remove the modules from the C-cover and unplug
the display connector by pulling the modules apart
carefully.
CCS Technical Documentation Disassembly/Assembly
RH-34
Issue 1 11/2003 Confidential ©2003 Nokia Corporation Page 3
5. The Earpiece is adhered with double-sided adhesive
tape. Use new tape when mounting the Speaker.
6. Remove the Microphone, being careful not to dam-
age the spring contacts.
7. Open the snaps with SRT-6 on both sides of the Dis-
play Shield.
8. The Display Shield is hooked at the bottom edge.
9. Press the LCD off of the LCD Frame. Use a clean cloth
as shown above.
10. Bend the frame a bit, shift the UI Board Module to
the right and then pull it up.
Step-by-Step Disassembly Instructions (Model 6585)
RH-34
Disassembly/Assembly CCS Technical Documentation
Page 4 ©2003 Nokia Corporation Confidential Issue 1 11/2003
Assembly Instructions
Use the Disassembly Instructions in the reverse order to reassemble the handset.
11. To remove the DC Jack, insert tweezers between the
spring contacts and under the jack. You will need to
use some force to pull the jack upward.
12. Grip the Vibra Motor as shown above and pull it off
of its guidance.
13. Use your fingers to remove the Volume Key and the
Infrared Window. The Power Key must first be unlocked
on the lower side (see inset).
14. Use the SRT-6 tool to unlock the Antenna on both
sides.
15. The Antenna Pogo Pins can be removed by using
the torx driver to push them through the C-Cover.
16. If you need to change the Release Button, you can
use the SRT-6 to remove the button.
Step-by-Step Disassembly Instructions (Model 6585)
Other manuals for RH-34 Series
3
Table of contents
Other Nokia Transceiver manuals
Nokia
Nokia NSE-6 SERIES Guide
Nokia
Nokia RM-11 Series Operating instructions
Nokia
Nokia NSE-5 Series Installation instructions
Nokia
Nokia NPM-6 Series Guide
Nokia
Nokia NME-2A Series User manual
Nokia
Nokia NHM-4 Series User manual
Nokia
Nokia NPM-6 Series User manual
Nokia
Nokia RH-57 Series Quick start guide
Nokia
Nokia NSW-6 Series Guide
Nokia
Nokia NPM-6 Series User manual
