Nilfisk-Advance SC800 User manual

Nilﬁsk A/S

Kornmarksvej 1

DK-2605 Brøndby

Denmark

Tel.: +45 43 23 40 50

Fax: +45 43 43 77 00

mail.com@nilﬁsk.com

www.nilﬁsk.com

If the machine has been used until the Red light illuminates on the battery level indicator on the machine, a full recharge of the batteries (10-12 hours) will be required. Failure to carry out this this

procedure may cause damage to the batteries. Charging the batteries after every use is recommended.

PLEASE ENSURE RED SOCKET IS LEFT DISCONNECTED AFTER RECHARGE IF THE MACHINE IS NOT TO BE USED ON A DAILY BASIS

Use and Maintenance

- SC800

ATTENTION! Do not use the machine before you have read and understood the Instructions for User Manual

2. Fill the tank with a clean water. The

clean water temperature must not

exceed 40 °C.

1b. Disconnect the battery charger

cable from the electrical main.

3. Fill the EcoFlex tank with a deter-

gent suitable for the work to be

performed (highly concentrated

detergent).

4. Install the squeegee and fasten it

with the handwheels, then connect

the vacuum hose to the squeegee.

1a. Switch off charger by pressing the

STOP button. Unplug charger cable

from red battery plug. Reconnect

the red battery plug to the machine.

17. Clean the machine using a damp

cloth and where needed use a neutral

cleaning product.

15. Press the switch and wait for the

brushes to fall on the ﬂoor.Remove

the brushes and clean them.

16. Take the squeegee off and remove

debris. Check and clean the squeegee

blades.

18. Charge the batteries: Connect the

battery charger cable from the elec-

trical main.

19. Park the machine with the recovery

tank cover open.

12. At the end of the work. Empty the

recovery tank with the hose. Then

empty the solution tank with the

trasparent hose

10. Lower the squeegee with the lever. 11. Push the drive paddle for starting

ﬂoor cleaning. If solution applied

ﬂows outside the brush housing dur-

ing use, reduce the ﬂow of solution.

Switch off the machine using the key.

13. Wash with clean water the recovery

tank and the vacuum grid. Remove

and clean the debris tray.

14. Clean the ﬁlter: 1) Close the solu-

tion tap under the machine. 2)

Remove the transparent cover and

the gasket, then remove the ﬁlter

strainer.

7. Press the solution ﬂow control

switches as necessary, depending

on the type of cleaning to be per-

formed.

5. Place the brushes or the pad-holders

under the deck. Use the appropriate

brushes to clean the ﬂoor.

6. Turn the ignition key to “I”, then

lower the deck by pressing the Green

switch. To engage the brushes,

slightly press the drive paddle and

then release it.

8. Press the detergent ﬂow control

switch. The number of display shows

the detergent concentration level in the

solution (see the table on the label).

See the User Manual for setting change.

9. Press the EcoFlex™ switch whenever

you temporarily need a greater clean-

ing power.

External battery charger Machine with battery charger

Nilﬁsk A/S

Kornmarksvej 1

DK-2605 Brøndby

Denmark

Tel.: +45 43 23 40 50

Fax: +45 43 43 77 00

mail.com@nilﬁsk.com

www.nilﬁsk.com

The machine

doesn’t work

as it should?

The suction

doesn’t work

as it should?

The machine

doesn’t clean

as it should?

The brush

don’t work as they

should?

Troubleshooting

- SC800

ATTENTION! Do not use the machine before you have read and understood the Instructions for User Manual

1Check if the power cable is correctly

connected.

2Check if the battery is charged. 3Turn the ignition key to “0”, then

try to start the machine without

pressing the paddle.

4Check if the surfaces has a gradient

exceeding the speciﬁcations.

1Check if the suction hose is

correctly installed and cleaned.

2Open the recovery tank and check

if the vacuum grid and gasket are

cleaned.

3Check if squeegee blades are dam-

aged or dirty.

4Close the recovery tank cover prop-

erly and/or verify the gasket wear.

1Check if you have the right

detergent and water settings.

2Check if the solution/clean water

tap is open.

3Check if the solution ﬁlter is

cleaned.

4Check if the isn’t any dirty in the

EcoFlex™ system.

1Check if the brushes are correctly

installed and not worn out.

2Check if there isn’t any brush motor

overload i.e. 3 battery Ledsﬂash

simultaneously or error code on dis-

play.

3Check if there are external materials

avoiding brush.

4Check if the Leds are on. Wait until

the lights are steady.

Other manuals for SC800

Other Nilfisk-Advance Scrubber manuals

Nilfisk-Advance

Nilfisk-Advance Advance SC900 ST-28D User manual

Nilfisk-Advance

Nilfisk-Advance ECOFLEX BR1100S User manual

Nilfisk-Advance

Nilfisk-Advance Kent 56302300 User manual

Nilfisk-Advance

Nilfisk-Advance Focus II Rider Installation and user guide

Nilfisk-Advance

Nilfisk-Advance Advance SC5000 User manual

Nilfisk-Advance

Nilfisk-Advance 48 LPG User manual

Nilfisk-Advance

Nilfisk-Advance SC500 User manual

Nilfisk-Advance

Nilfisk-Advance crescent SC250 User manual

Nilfisk-Advance

Nilfisk-Advance BRX 700 Series User manual

Nilfisk-Advance

Nilfisk-Advance BR 601 User manual

Nilfisk-Advance

Nilfisk-Advance Warrior ST User manual

Nilfisk-Advance

Nilfisk-Advance 1300 LPG User manual

Nilfisk-Advance

Nilfisk-Advance Advance SC750 ST User manual

Nilfisk-Advance

Nilfisk-Advance Advance SC1500 User manual

Nilfisk-Advance

Nilfisk-Advance SW4000 User manual

Nilfisk-Advance

Nilfisk-Advance SC530 53 BD GO User manual

Nilfisk-Advance

Nilfisk-Advance 56390926(850SC) User manual

Nilfisk-Advance

Nilfisk-Advance HSC 585 Operating instructions

Nilfisk-Advance

Nilfisk-Advance SC800 Installation and user guide

Nilfisk-Advance

Nilfisk-Advance Advolution UHR 70-1700 User manual

Nilfisk-Advance

Nilfisk-Advance SC500 User manual

Nilfisk-Advance

Nilfisk-Advance Captor 5400 User manual

Nilfisk-Advance

Nilfisk-Advance SC6000 User manual

Nilfisk-Advance

Nilfisk-Advance Viper Fang 15B User manual

Popular Scrubber manuals by other brands

Olympus

Olympus M200H operating manual

Clarke

Clarke BEXT 100H Operation?and safety

JOHNY VAC

JOHNY VAC JVC70BCT user guide

RCm

RCm Elan Series Instruction and maintenance handbook

Kärcher

Kärcher B 120 W quick start

Truvox

Truvox Orbis MotorScrubber 20 user manual

Numatic

Numatic TTB 4045/100 Original instructions

U.S. Products

U.S. Products PEX 500-C-TICK Information & operating instructions

Mclennan

Mclennan C510 Operator's manual

Tennant

Tennant T20 LPG Operator's manual

Columbus

Columbus ARA 66 BM 100 operating manual

Numatic

Numatic TTV 678G / 300T Owner's instructions

American-Lincoln

American-Lincoln 505-945 Instructions for use

FIORENTINI

FIORENTINI ET 65-75 user manual

Floorpul

Floorpul ruby 48 blt Use and maintenance

Onyx

Onyx RX-34 Operator's manual

Dustbane

Dustbane Hurricane 400 Operation manual

Sana

Sana EUJ-702 user manual