Nikon A1R Series Service manual
NIKON A1R – SETTING KOHLER FOR DIC
SYSTEM START UP
1. Turn on the laser unit
oPress button on left side
oTurn Key on Middle box of unit
oThe light will stop blinking when the laser unit is ready
2. Turn on the Surge protector at the back of the microscope table
3. Turn on the computer
4. Turn on the software – NIS Elements AR 4.51.00
SETTING KOHLER
5. Select the DIC button - light to the eye pieces.
6. Make sure the GIF slider is out of the light path – light through eye piece will appear green
if the GIF slider is pushed in.
7. Under the Lamps option – control brightness
oTo turn off the light, click the green rectangle – turns red when light is off
8. Close down the F stop (turn dial to the left).
F stop
GIF Slider
9. Adjust the condenser height using the large black knobs until a sharp hexagon appears
through the eye pieces.
10. Center the hexagon using the silver centering screws.
11. Open the F stop until the edges of the hexagon are out of the field of view.
Taken from Olympus.com
Table of contents
Other Nikon Microscope manuals
Nikon
Nikon ECLIPSE Ti2-U User manual
Nikon
Nikon ECLIPSE Ni-E User manual
Nikon
Nikon Eclipse 50i POL User manual
Nikon
Nikon eclipse E200 User manual
Nikon
Nikon Eclipse Ci-E User manual
Nikon
Nikon Eclipse Ti TIFT 1454 User manual
Nikon
Nikon P-400R User manual
Nikon
Nikon Live Cell 2 User manual
Nikon
Nikon ECLIPSE E200 MV Series User manual
Nikon
Nikon OPTIPHOT-2 User manual
Nikon
Nikon ECLIPSE TE2000-E User manual
Nikon
Nikon ECLIPSE 80i User manual
Nikon
Nikon LABOPHOT2-POL User manual
Nikon
Nikon SMZ1500 User manual
Nikon
Nikon SMZ800N User manual
Nikon
Nikon SMZ460 User manual
Nikon
Nikon SMZ-10 Operating instructions
Nikon
Nikon Ee1078 User manual
Nikon
Nikon Eclipse TE300 User manual
Nikon
Nikon ECLIPSE Ei User manual
