Nice BiDi-WiFi Product manual

Nice

BiDi-WiFi

BiDi-WiFi radio interface

EN - Instructions and warnings for the INSTALLER

  toinstallandcongureNicecontrolunits

2 – ENGLISH

ENGLISH

Translation of the original instructions in full

CONTENTS

GENERAL SAFETY WARNINGS AND

PRECAUTIONS

1 GENERALSAFETYWARNINGSANDPRECAUTIONS

a

CAUTION! – This manual contains important in-

structions and warnings for personal safety. Care-

fully read all parts of this manual. If in doubt, sus-

pend installation immediately and contact the Nice

Technical Assistance.

a

CAUTION! – Important instructions: keep this man-

ual in a safe place to enable future product mainte-

nance and disposal procedures.

a

CAUTION! – All installation and connection oper-

ations must be performed exclusively by suitably

qualied and skilled personnel with the unit discon-

nected from the mains power supply.

–This product may only be used indoors or protected from

weather conditions by control unit’s housing.

–Do not open the device protection housing as it contains

non-serviceable electrical circuits.

–The product packing materials must be disposed of in

compliance with local regulations.

–Neverapplymodicationstoanypartofthedevice.Op-

erationsotherthanthosespeciedmayonlycausemal-

functions. The manufacturer declines all liability for dam-

agecausedbymakeshiftmodicationstotheproduct.

–Never place the device near to sources of heat and never

exposetonakedames.Theseactionsmaydamagethe

product and cause malfunctions.

–This product is not intended for use by people (including

children) with reduced physical, sensory or mental capa-

bilities or who lack experience and knowledge, unless

they have been given supervision or instruction concern-

ing the use of the product by a person responsible for

their safety.

–Make sure that children do not play with the product.

–Check the warnings in the instruction manual for the mo-

tor that the BiDi-WiFi is connected to.

–Handle the product with care, being sure not to crush,

knock or drop it in order to avoid damage.

1 GENERAL SAFETY WARNINGS AND PRECAUTIONS . . . . . 2

2 PRODUCT DESCRIPTION. . . . . . . . . . . . . . . . . . . . . . . . . . . . 3

2.1 List of constituent parts. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3

3 INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3

3.1 Pre-installation checks . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3

3.2 Installation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3

4 LED SIGNALS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4

5 FULL RESET. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5

5.1 Full reset . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5

5.2 Firmware reset . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5

6 TECHNICAL SPECIFICATIONS. . . . . . . . . . . . . . . . . . . . . . . . 5

7 PRODUCT DISPOSAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5

ENGLISH – 3

PRODUCT DESCRIPTION

2 PRODUCTDESCRIPTION

The BiDi-WiFi accessory is a device that – by means of WiFi com-

munication – allows for controlling the movement and status of

Gate&Door-type Nice automations compatible with the BusT4.

a

CAUTION! – Any use other than that specied here-

in or in environmental conditions other than those

stated in this manual is to be considered improper

and is strictly forbidden!

2.1 LIST OF CONSTITUENT PARTS

Figure 1shows the main parts making up the BiDi-WiFi.

A B C D

AData Connection LED

BPAIRING button

CRESET button

DPower LED

EControl Unit CONNECTOR

INSTALLATION

3 INSTALLATION

3.1 PRE-INSTALLATION CHECKS

a

The installation must be carried out by qualied

personnel in compliance with the current legisla-

tion, standards and regulations, and with the in-

structions provided in this manual.

a

CAUTION! – If the BusT4 connection is used for the

IBT4N interface, BiDi-WiFi cannot be connected to

the control unit.

Before proceeding with the product’s installation, it is necessary to:

–check that you have a Nice automation control unit of the Gate&-

Door catalogue equipped with BUS T4 connector (IBT4N). Con-

trol unit with phone connector RJ11 are not supported by Bi-

Di-WiFi (“Figure 2“)

RJ11

–you have a smartphone with Android 6.0.2 or higher

–youhaveinstalledandconguredtheapplicationMyNice Pro

on the smartphone, you can download the App from Play Store.

3.2 INSTALLATION

To install BiDi-WiFi:

–disconnect the power supply from the automation’s control unit

(“Figure 3“)

–all LEDs on the automation’s control unit should be off before

continuing

OFF

–if present, remove the plastic pre-cut element (A) from the IBT4N

connector and check that there are no burrs (“Figure 4“)

4 – ENGLISH

–insert BiDi-WiFi into the IBT4N connector (B) of the control unit

(“Figure 5“)

a

Caution! If BiDi-WiFi is inserted incorrectly, it may

permanently damage the control unit!

–power the automation’s control unit (“Figure 6“)

–Wait for the Data Connection LED (A)tostartashing(“Figure

7“)

–congure BiDi-WiFi through smartphone application MyNice

Pro, following the instructions contained in the relevant instruc-

tion manual that can be downloaded from this "link".

–thecongurationiscompletewhenDataConnectionLED(A) is

xedgreen(“Figure 7“).

LED SIGNALS

4 LEDSIGNALS

In the event of BiDi-WiFimalfunctions, the LEDs(A) and (D) can

lightuporstartashing.(“Figure 8“).

The “Table 1” shows the meanings of the LED signals.

Table 1

LED SIGNALS

Status

Data

Connection

LED (A)

Status

Power LED (D) State duration Description

OFF OFF Fixed BiDi-WiFi off.

Lit green Lit green Fixed

BiDi-WiFi

conguredand

smartphone

connected.

Lit orange Lit green Fixed

BiDi-WiFi

conguredbut

smartphone not

connected.

Flashing

green

Lit green Fixed

BiDi-WiFi is

notcongured.

Use smartphone

application to

perform the

accessory

conguration.

OFF Lit green Fixed

BiDi-WiFi was

notcongured

within 30 minutes

of switching on.

Switch off and

on the accessory

to retry the

conguration.

Flashing

orange

Flashing

orange

Transitory

(about 1

minute)

BiDi-WiFi update

in progress.

-Lit red Fixed

System error.

Contact the

Nice Technical

Assistance.

Lit red - Fixed

Wi-Fi module

error. Contact the

Nice Technical

Assistance.

Flashing red

- Fixed

Conguration

error. Contact the

Nice Technical

Assistance.

ENGLISH – 5

FULL RESET

5 FULLRESET

5.1 FULL RESET

BiDi-WiFi can be completely reset to delete all the settings (users

settings,loglesandWi-Ficonguration).Todothis:

–press and hold the RESET button (C) for at least 10 seconds: all

theLEDswillashred

–release the RESET button (C). BiDi-WiFi device will restart (“Fig-

ure 9“).

5.2 FIRMWARE RESET

Youcanrestorethepreviousrmwareversionanddeleteallset-

tings(userssettings,loglesandWi-Ficonguration).Todothis:

–keeping inserted the |e|null device, power on the control unit with

the RESET button (C)pressed. Data Connection LED (A)willash

red

–press and hold the RESET button (C) for at least 10 seconds.

DataConnectionLEDwillstopashing

–Release the RESET button (C) (“Figure 10“).

TECHNICAL SPECIFICATIONS

6 TECHNICALSPECIFICATIONS

l

All technical specications stated in this section re-

fer to an ambient temperature of 20°C (± 5°C). Nice

S.p.A. reserves the right to apply modications to

the product at any time when deemed necessary,

without altering its functions and intended use.

Table 2

TECHNICAL SPECIFICATIONS

Description Technical specication

Product name BiDi-WiFi

Power supply 12-24Vc

Max. power input 1.2 W

Tipo interfaccia WIFI con

antenna interna

802.11b/g/n – 2.4GHz

client / AP (P < 20 dBm EIRP)

Wi-Fi security OPEN/WEP/WPA-PSK/WPA2-PSK

Bluetooth® v4.2 BR/EDR/BLE

Operating temperature -20°C ... +50°C

Storage temperature -25°C ... +70°C

Humidity 15% - 85%

Dimensions (WxDxH) 43,9 x 27,5 x 21 mm

Weight 15 g

Protection rating (IP) 40

PRODUCT DISPOSAL

7 PRODUCTDISPOSAL

l

This product is an integral part of the operator and

must therefore be disposed of with it.

Aswiththeinstallation,onlyqualiedpersonnelmustdismantlethe

product at the end of its life.

This product is composed of different types of materials. Some

of these materials can be recycled; others must be disposed of.

Please enquire about the recycling or disposal systems in place in

your local area for this type of product.

a

WARNING

Some parts of the product may contain polluting or

dangerous substances. If not disposed of correctly,

these substances may have a damaging effect on

the environment and human health.

l

As indicated by the symbol shown

here, this product must not been

disposed of with household

waste. Separate the waste for dis-

posal and recycling, following the

methods stipulated by local reg-

ulations, or return the product to

the seller when purchasing a new

product.

a

WARNING

Local regulations may impose heavy penalties if

this product is not disposed of in compliance with

the law.

www.niceforyou.com

Nice SpA

Via Callalta, 1

31046 Oderzo TV Italy

[email protected]

IDV0785A00EN_27-11-2020

Table of contents

Other Nice Control Unit manuals

Nice

Nice WIL Product manual

Nice

Nice RO 1000 Product manual

Nice

Nice WA20/A Technical specifications

Nice

Nice Mindy-A01 Product manual

Nice

Nice TT1VR Technical specifications

Nice

Nice Moon MC424 User manual

Nice

Nice elero VarioTec 28 120.0001 User manual

Nice

Nice TTPRO BD Technical specifications

Nice

Nice Moon MC424 Technical specifications

Nice

Nice Oview User manual

Nice

Nice Moon MC824H User manual

Nice

Nice IBT4ZWAVE Technical specifications

Nice

Nice TT3 Product manual

Nice

Nice MC200 Technical specifications

Nice

Nice Mindy A100F Product manual

Nice

Nice UST1K Quick start guide

Nice

Nice IBT4N/BR User manual

Nice

Nice Mindy A500 Product manual

Nice

Nice NDCC4001 Technical specifications

Nice

Nice MNCUT Technical specifications

Nice

Nice mindy TT1N Product manual

Nice

Nice POA1 Technical specifications

Nice

Nice D-Pro Automatic R01 Series Technical specifications

Nice

Nice Moon MC824H Technical specifications

Popular Control Unit manuals by other brands

Festo

Festo Compact Performance CP-FB6-E Brief description

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Quick installation guide

JS Automation

JS Automation MPC3034A user manual

JAUDT

JAUDT SW GII 6406 Series Translation of the original operating instructions

Spektrum

Spektrum Air Module System manual

BOC Edwards

BOC Edwards Q Series instruction manual

KHADAS

KHADAS BT Magic quick start

Etherma

Etherma eNEXHO-IL Assembly and operating instructions

PMFoundations

PMFoundations Attenuverter Assembly guide

GEA

GEA VARIVENT Operating instruction

Walther Systemtechnik

Walther Systemtechnik VMS-05 Assembly instructions

Altronix

Altronix LINQ8PD Installation and programming manual

Eaton

Eaton Powerware Series user guide

WAGO

WAGO 750-407/040-000 manual

Sony

Sony CCU-590 Operation manual

Graco

Graco 25D614 instructions

Task Force Tips

Task Force Tips YE-RF-900 Instructions for installation, safe operation and maintenance

Shini

Shini SPV-U Series manual