VISA MOUNT
T-NUTS
MAIN CROSS MEMBER REAR SIDE VIEW
1
3
2
4
2 x T-nut for
the left vertical
member
2 x T-nut for
the overhead vertical
member
2 x T-nut for
the overhead vertical
member
1 x T-Nut to the
middle for the
vesa mount
2 x T-nut for
the right vertical
member
overhead monitor only overhead monitor only
PARTS:
Parts List here
TIPS:
Text for hints and tips for building
this step
PARTS:
Parts List here
TIPS:
Text for hints and tips for building
this step
00
00
Main text descrition for step here
Main text descrition for step here
Video Instruction: bit.ly/nlrbuild
1312
support@nextlevelracing.com
PARTS:
10 X TNUT
TIPS:
Red dots indicate general T-nut
positioning
Countersunk holes in cross member
to be on the front of the cross
member, T-nuts installed on the
rear side
PARTS:
4 X TNUT REGULAR
4 X FEET
TIPS:
Use alignment tab of foot cap
Adjust to desired height and/or level
then tighten with Allen key
Assemble on side for easy
installation
04a
04b
Install 10 x T-Nuts into the cross member as shown
Install T-nut into frame then screw feet into T-nut
PARTS:
4 X M8 40MM BOLT
4 X M8 WASHER
TIPS:
You may find it easier to add the
washers into the channel prior to
the bolts
Get a friend to help you hold parts
in position
This step sets your screen height
PARTS:
8 X M8 16MM BOLT
8 X M8 WASHER
2 X CORNER PLATE
05
06
Bolt the upper cross member to the vertical members using T-Nuts previously installed in step 03a
Bolt corner plate to T-Nuts previously installed in step 4a and step 3b. Repeat on the other side
REPEAT ON
OTHER SIDE
Align set
tab
