6
A. Scene Selector
i. Store Scene
After Device join a network, users can add the device, like ZC06, into a group/scene using the
following steps:
Step1. Identify the device which you would like to add.
Step2. Press and hold the button for 3 seconds. The Network Indicator will flash once.
Step3. Release the button and then press the Binding Key within 2 seconds.
Step4. The Network Indicator flashes 5 times after the setting is completed; otherwise, it will
flash 10 times.
To remove the device from the group/scene, do the above steps again.
Via the steps above, one button can only be used for one group/scene.
In order to use one button for multiple groups/scenes (up to 4 groups/scenes), please use ZigBee
application such as Netvox ZiG-BUTLER.
The indicator colors for 4 groups/scenes are blue →red →cyan →pink in sequence.
ii. Recall Scene
After store scene, users can press the button to recall or switch scenes.
B. Mode Selector
Users are able to configure the Mode control through ZigBee applications such as Netvox ZiG-BUTLER.
Each scene selector configurates up to 3 modes.
Each button can be used for 3 ModeID / ShortCut.
The indicator colors for 3 modes are blue →red →cyan in sequence.
C. Turn on / off LED backlight
Long press binding key for 6 seconds (green indicator flashes twice at 3rd and 6th second ). Release the
key, LED backlight turn on / off.
5-4. Restore to Factory Setting
Step1. Press and hold the Binding Key for 15 seconds. The Network Indicator will flash 4 times (at the
3rd , 6th ,10th , 15th second).
Step2. After releasing the Binding Key, press any switch key (Button 1/ Button 2/ Button 3/ Button 4/
Button 5/ Button 6) within 2 seconds. The Network Indicator will be flashing. After the Network
Indicator stops flashing, the restore is completed.
