NCR 7409-K330 Manual
7409-K330
Bar Code Scanner
Kit Instructions
Issue A
Revision Record
Issue Date Remarks
A Aug 2011 First issue
1
Introduction
This kit provides a Bar Code Scanner for the following terminals.
NCR RealPOS 25 (7610)
NCR RealPOS 50 (7611)
The assembly installs on the bottom of the terminal.
7409-K330 Bar Code Scanner
2
Components
Cable Cover Lock Plate
497-0473132
7610 Cable Cover
497-0473300
MS3207 Scanner Cable, Db9 to USB
497-0466203
Screw, M3 x 0.5 x 6 mm, FH
006-8612557
Screw, 6-32 x 5/16, Phillips, FH
006-8611269
MS4980 Scanner Bracket
497-0473130
MS3207-1000 MiniScan
006-8612581
3
Installation Procedures
1. Unplug the terminal power cord and turn off the power to any connected
peripheral devices.
2. Remove the terminal Cable Cover.
3. Connect the scanner cable to a USB Connector on the I/O Panel.
USBAUSB B
4
4. Install the Scanner Assembly onto the bottom of the terminal. There are no
fasteners, the plastic Cable Cover snaps into position on the terminal Rear Cover.
Table of contents
Other NCR Barcode Reader manuals
NCR
NCR RealScan 7883 Instruction Manual
NCR
NCR IBM 7870 User manual
NCR
NCR 7409-K302 Manual
NCR
NCR RealScan 7872 User manual
NCR
NCR 74 OFX (7874) User manual
NCR
NCR 7407-K013 User manual
NCR
NCR Realscan 7837 User manual
NCR
NCR 7409-K313 User manual
NCR
NCR RealScan 7802 User manual
NCR
NCR 7409 K303 Use and care manual
