Naish Fusion ATB Control System 2016 User manual
1. Measure the distance from the bar to
the line organizer. This should be 82 cm.
3. Take your box cutter and cut off the
knot inside the handle.
4. Tape the end of the trim line so that
it doesn’t fray and allows you to feed it
through various spare parts later.
5. Take handle and yellow ball off the
end of the line. Then pull the line out of
the line organizer and cleat so that it is
now entirely free.
Tip: The bradawl tool comes in handy
here when pulling the line out through
the cleat.
2. Measure the distance from the bar to
the cleat. This is typically 54 cm.
7. Pull the trim line completely out of the
quick release mechanism.
8. The end of the trim line is looped onto
the cleat. Use the bradawl to loosen and
remove the trim line from the cleat entirely.
9.Take the taped end of the trim line
and insert between the roller and the
bridge starting from the cleat side of
the metal body. Important: Do not insert
it under the roller as it was when you
disassembled it.
6. Pull the quick release open so you
have access to the trim line underneath.
10. Guide it through the loop at the end
of the trim line and pull it tight.
11. Feed the taped end of the trim line up
through the bottom of the yellow handle.
1.
How to Adjust the Trim Line on the
2016 Fusion ATB Control System
15. Feed the taped end of the trim line up
into the line organizer and back down
through the opposite side of the cleat.
16. Measure the trim line from the bar
to the line organizer, and adjust as
necessary to get to the measurement of
82 cm.
14. Measure the trim line from the bar to
the cleat, and adjust as necessary to get
to the measurement of 54 cm.
13. Insert the taped end of the trim
line through the control bar, and then
insert it into the cleat on the side that is
attached to the safety line.
12. Make sure that the trim line looks like
this before pushing the yellow handle
back down. There should be enough room
that the yellow handle can still freely
come all the way down and click closed.
17. Insert the trim line through the
yellow ball and pull it snug to the cleat.
19. Mark the trim line where the line exits
the velcro handle. Make a gure 8 knot
where you marked the trim line to secure
the yellow ball and velcro handle.
18. Insert the trim line through the velcro
handle and pull it snug to the yellow ball.
20. Cut off the excess trim line.
How to Adjust the Trim Line on the
2016 Fusion ATB Control System
2.
Other Naish Control System manuals
