10
DO NOT ADD BOI ING WATER/VERY HOT
IQUID TO THE JUG. A OW TO COO FIRST.
•The Measuring Cup (1) can be used to measure
small quantities of liquid.
1Pour the liquid through the Pouring Hole (3)
in the Lid (2).
2Place the Measuring Cup (1) back in the Lid (2),
twisting to lock/unlock. Then proceed with your
blending.
•Follow the procedure in the ‘Using your Total
Control Table Blender section, replacing food with
the ice cubes to be crushed.
•Select ce Crushing Button (13) on the
Preset Programs.
•Note: The maximum capacity for ice crushing at
any one time is 500ml.
Use your Blender for soups, sauces, drinks,
pates, mayonnaise, dressing etc.
•Do not put dry ingredients into the Blender
without addition of other wet ingredients or liquid.
•When blending, pour the liquids in first and then
add the solid food. Begin blending at the lower
speed and increase when needed.
MPORTANT: To ensure the long life of your
blender when using the Manual Speed Settings
never run it for longer than 60 seconds and allow
to cool for 5 minutes. Switch off as soon as you
have reached the desired consistency.
•The machine will not work if the Plastic Jug (5)
is fitted incorrectly.
•Don’t use the Plastic Jug as a storage container.
Keep it empty when not in use.
•Never blend more than 1 litre (13⁄4pints) -
of frothy liquids, such as milk shakes.
•f using a max of 1.5L do not use any higher than
speed 2.
•When blending soup do not fill over the
1 Litre mark.
•Do not overfill the blender. This could cause
damage to the motor. The plug fuse will blow if
the blender is overloaded. Replace the fuse and
do not exceed the maximum recommended
volumes. Refer to the ‘Operating chart’
on page 11.
•Before cleaning and maintenance, switch the
appliance off and unplug it, remove the
Plastic Jug (5) from the Base Unit (7).
•After use, fill the Plastic Jug (5) with 1L (13⁄4pints)
of warm water and run for 30 seconds on the
pulse setting and repeat as necessary. Never use
abrasives or cream cleaners.
•Clean the Base Unit (7) with a damp cloth or
kitchen paper roll.
•There is a facility to wrap your power cable
around the base of the product and fit the plug
into the Plug Storage (15).
•Reassemble the Total Control Table Blender by
carefully placing the Plastic Jug (5) on the Base
Unit (7), ensuring it fits correctly.
•WARNING : Never immerse the Base Unit in
water.
•WARNING: If any liquid is spilt in the top of the
Base Unit, switch off and unplug from the
socket and dry with a cloth.
Crushing Ice
Top Tips Care And Cleaning
Measuring Cup
IMPORTANT
