4
IMPORTANT SAFEGUARDS
SPECIFICATIONS
5
TRANSPORTATION & PLACEMENT
THERMOSTAT
13. It is not advisable to freeze food and meat inside the unit.
14. Do not store flammable liquids, explosive, and corrosive items inside the unit such as
acids, alkali, and other hazardous materials.
15. Do not place heavy objects on the top of the unit as these objects may fall when
opening or closing the door, and accidental injuries might be caused.
16. Detach the power plug in the event of a power failure or when cleaning. Do not connect
the unit to the power supply within five minutes to avoid damaging the compressor due
to successive starts.
17. CAUTION: Do not wet the power cord or handle the power plug with wet hands.
18. Do not spray or wash the unit or place it in moist or damp places with close contact with
water as doing so may affect the unit's electrical insulation properties.
19. This unit is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities or lack of experience and knowledge, unless they have
been given supervision or instruction concerning use of the unit by a person
responsible for their safety.
20. Children should be supervised to ensure that they do not play with the unit.
21. WARNING: Allow adequate ventilation during operation to maintain proper efficiency
and functioning of the unit.
22. WARNING: Do not use mechanical devices or other means to accelerate the defrosting
process, other than those recommended by the manufacturer.
23. WARNING: Do not damage the refrigerant circuit.
24. WARNING: The use of accessory attachments not recommended by the appliance
manufacturer may cause hazard or injury.
It is important to follow the below instructions when moving upright showcase. This
includes moving it to a new location or purchasing a new unit and transporting it
home.
l Disconnect the power cord from the power supply.
l Pack all accessories that came along with the upright showcase.
l Remove food, defrost, and clean the unit. Ensure there are no food or items inside the
unit during transportation.
l Use blankets to protect the unit's exterior from scratches.
l Do not expose the unit to direct sunlight or heat sources or violent shaking for safety
reasons.
l When transporting, keep the unit in the upright position and do not tilt exceeding 45
degrees to avoid damaging the unit.
l Be careful to secure the door to prevent it from opening.
l Set it upright in its final location and allow the unit to sit for the same amount of time
that it was on its side (24 hours max.).
l Do not plug the unit into the power supply without allowing this settling time to
prevent premature damage.
l Store food inside the unit only when the unit has been operating for some time, and not
immediately.
l The unit must be placed on flat and stable surfaces.
l Do not place the unit in damp or moist places with direct contact to water.
l This unit is for indoor use only.
The cabinet temperature is controlled by the thermostat on the panel. The thermostat can
set a suitable temperature range according to different ambient temperatures and various
quantity of items.
Positions 0 to 7 are indicated on the thermostat knob, where: (Note: Position 0 - 7 identify
refrigeration, not temperatures.)
l Position 1 = Highest setting temperature
l Position 7 = Lowest setting temperature (keep cooling all the time)
l Position 0 = Power off
Model MCS-198 MCS-298
Rated Voltage / Frequency 220-240V~ 50Hz
Rated attage 230 240
Capacity 170L 250L
Refrigerant R134a/95g R134a/113g
