montpellier MH600X User manual
Cod:0103086942-00.02
60/70/90/100cm Integrated Chimney Cooker Hood
MH600X / MH600BK / MH700X / MH700BK
MH900X / MH900BK / MH1000X / MH1000BK
We recommend that you keep this manual in a safe place for future reference.
Your &RRNHU+RRGis covered by a comprehensive two year Parts & Labour
Guarantee. In the unlikely event that you experience a problem with your +RRG,
you can rest assured that you are fully protected against WKHFRVWRIUHSDLUVIRU
WKHILUVWPRQWKV3OHDVHQRWHWKDWDQ\FODLPPXVWbe accompanied by the
model reference number, serial number and proof of purchase.
To activate your guarantee, you will need your product serial number. This can
be found on the rear of the machine.
There are two ways to register your Guarantee:
•Online: Visit the Support page on our website and complete the online Product
Registration form. www.montpellier-appliances.com
•By Post:6LPSO\GHWDFKDQGƮOOLQWKHIRUPSURYLGHGDWWDFKDVWDPSDQGVHQG
it in the post. Don’t forget to include your e-mail address so that we can send
FRQƮUPDWLRQWKURXJKWR\RX
Welcome
Thank you for choosing this Montpellier &KLPQH\&RRNHU+RRG.
Our +RRGVhaYH been designed to provide you with the best combination of style, reliability and performance to
give you years of trouble-free use.
You may be familiar with a similar product, but please take time to read these instructions carefully before installing
or using your &RRNHU+RRG to ensure you get the most from your purchase.
Note: We are unable to take registrations over the phone.
ACROSS ALL OUR MODELS
YEAR
GUARANTEE
PA R T S & LA B O U R
www.montpellier-appliances.com
2
3
Using your Extractor
For best performance, you should switch on the extractor 15 minutes before starting to cook and leave it to run
for approximately 15 minutes after the end of cooking.
Control Panel
B – Speed level buttons
C – Light button
Press button C.
To switch on the extractor or change the motor speed at any time when the extractor is running
Press the relevant speed button (B) for the first, second or third speed as required.
Press button A.
Fig. 1 $%&
4
Care and Maintenance
IMPORTANT : DO NOT PERFORM MAINTENANCE OR CLEANING
OF THE EXTRACTOR WITHOUT FIRST SWITCHING OFF THE
ELECTRICITY SUPPLY.
Cleaning
You should use a nonabrasive cleaner. Any abrasive cleaner (including
Cif) will scratch the surface and could erase the control panel markings.
solution of water and mild detergent and drying to a shine with a clean
cloth.
&OHDQLQJWKHJUHDVHƪOWHU
The grease filter should be kept clean to minimise the risk of fire.
At least once a month you should remove and clean the grease
filter with hot soapy water. You can also wash the grease filter in a
dishwasher, ensuring that you place it in an upright position to prevent
damage from other items in the dishwasher. After rinsing and drying,
replace the filter.
To remove the grease filter, push in the button on the handle and then
pull down on the filter at the front. When you have released it at the
front, then you can pull out the filter. To replace the grease filter, repeat
the steps in reverse.
Please note:
Cleaning the grease filter in the dishwasher may lead to discolouration.
This is normal and does not constitute a fault with the appliance.
&KDQJLQJWKHFKDUFRDOƪOWHUUHFLUFXODWLQJRQO\
To ensure best performance of your extractor, you should replace the
charcoal filter every four to six months, depending on use.
To attach a new charcoal filter, first remove the grease filters as
described above.
Insert the charcoal filter into the guide on the side of the motor, then
slide the filter in until it locks into place. Repeat with the second filter
on the opposite side. Finally replace the grease filters.
Fig. 2
1x1.5W MAX
MH900X / MH900BK
MH1000X / MH1000BK
MH600X / MH600BK
MH700X / MH700BK
2x1W MAX
6
FUSE 5A
PROTECTION LINE
5A Fuse is installed inside the plug to protection line.
MH600X / MH600BK /MH700X /MH700BK: 26.5W
230-240V ac, 50Hz
MH900X / MH900BK / MH1000X / MH1000BK: 27W
2
A
B
C*
D
E
F
MH900X
MH900BK
MH1000X
MH1000BK
MH600X
MH600BK
MH700X
MH700BK
60.5
120.5
175
75
80
Height dependent
60.5
120.5
200
75
80
Height dependent
9
INSTALLATION
IMPORTANT SAFETY WARNING: ONLY USE THE SCREWS PROVIDED WITH THE EXTRACTOR TO MOUNT
THE DUCTING ADAPTOR. THE USE OF LONGER SCREWS MAY CAUSE DAMAGE TO THE INTERNAL WIRING
WHICH WILL NOT BE COVERED BY THE WARRANTY.
10mm
Fig. 5 Fig. 6
Fig. 7 Fig. 8
Fig. 9 Fig. 10
Tools required Mark wall as required (see Fig.3)
Drill 4 holes for mounting the body Fit wall fixings and top screws - Ensure that any fixings you use
are appropriate for the wall type.
8
Mount chimney brackets.
This manual suits for next models
7
Table of contents
Other montpellier Ventilation Hood manuals
montpellier
montpellier MON-TCH160 User manual
montpellier
montpellier MON-SWCH500 User manual
montpellier
montpellier CHG613MB-EDGE User manual
montpellier
montpellier MON-CACH500 User manual
montpellier
montpellier CHV611MSS User manual
montpellier
montpellier CHG903MSS User manual
montpellier
montpellier MON-ICHT101 User manual
montpellier
montpellier DDCH60 User manual
montpellier
montpellier MCA52S User manual
montpellier
montpellier CHG603MSS User manual
montpellier
montpellier MON-DDCH60 User manual
montpellier
montpellier CACH510 User manual
montpellier
montpellier CHV601MW User manual
montpellier
montpellier MHG600X User manual
montpellier
montpellier ICHT02101 User manual
montpellier
montpellier DCH7250BGT User manual
montpellier
montpellier CHC602MSS User manual
montpellier
montpellier TCH261 User manual
montpellier
montpellier CHG613MSS User manual
montpellier
montpellier MON-DCH1060BG User manual
