MIDI LOOP & SWITCH LS10/6 Instruction Manual 3
MARK L Custom Guitar Electronics 3
Introduction
Congratulations on buying your MIDI/LOOP & SWITCH LS10/6
Our effect loops guarantee:
-perfectly transparent sound
-ultra-clean sound thanks to using passive components
-signal to noise ration comparable to CD quality recording s(102dB)
-no dynamic loss
-full bandwidth
-silent, click-free switching, even in high gain level
-MIDI compatibility ( CC# Control Change and PC# Program Change )
-six relay contact closures (S1-S6) for devices utilizing switch to ground
functions
-high grade low noise ( INPUT 1 ) line buffer
-alternating or direct current operation
LS10/6 is equipped with 10 effect loops, 6 switches ground separated,
LS10/6 is controlled by MIDI CC (Control Change) and MIDI PC ( Program Change )
commands over 16 MIDI channels.
LS10/6 is compatible with any type of MIDI controller capable of sending CC or PC midi
commands, but to ensure proper operation and maximum effectiveness we recommend using
MLC MARK L controllers.
The effects loop can be hooked up with:
-10 mono effects (10 effects plugged in before the amplifier)
-10 mono effects (10 effects plugged in the amplifier’s FX LOOP )
By dividing the loop into two sections we can plug in:
- 10 mono effects (6 before the amplifier and 4 in the amplifier’s FX LOOP)
- 4 stereo effects (4 left channels to loop 1-4 and 4 right channels to loop 7-10) achieving 4
stereo loops for 4 effects
- 10/6 or 4 MUTE EFFECT (in pair with a line mixer)
