ML Accessories CAPWGU Instruction Manual

INSTALLATION & MAINTENANCE MANUAL

CAPWGU

These instructions should be read carefully and retained after installation by the end user for

future reference and maintenance.

These instructions should be used to aid installation of the following product:

CAPWGU

GENERAL INSTRUCTIONS

• This product must be installed in accordance with the latest edition of the IEE Wiring Regulations (BS7671)

and current Building Regulations. If in any doubt, consult a qualiﬁed electrician

• Please isolate mains prior to installation or maintenance

• Check the total load on the circuit (including when this product is ﬁtted) does not exceed the rating of the

circuit cable, fuse, or circuit breaker

• This product is safe for use as a drive-over ﬁtting 1000kg @ 5mph (with half-lip cover removed)

• Please note the IP (Ingress Protection) rating of this product when deciding the location for installation

• This product should be installed in the upright position

• This product is Class I and must be earthed

• This product is IP65 rated

SAFETY

INSTALLATION

• Provide power to the required point of installation (refer to BS7671 for correct cabling methods). Suitable IP

rated junction boxes should be used where required

• The power source connections should be local and accessible via a suitable IP rated enclosure

• Cut a suitable hole in the mounting surface as per the cut-out details (see Fig.1) ensuring not to infringe with

any joists, gas/water pipes or electrical cables

Cut-out with sleeve Cut-out without sleeve

70mm 65mm

Fig. 1

• Please note this product is supplied with a sleeve for direct mounting in the ground. The sleeve is not

necessary for installation into decking

• We recommend not installing in areas where there is a high risk of ﬂooding or areas where water may sit on

top of the ﬁtting (see Fig. 2)

• Ensure a minimum of 300mm of drainage is put below the luminaire (see Fig. 2)

INSTALLATION & MAINTENANCE MANUAL

These instructions should be read carefully and retained after installation by the end user for future reference

and maintenance.

These instructions should be used to aid installation of the following product:

CAPWGU

SAFETY

•This product must be installed in accordance with the latest edition of the IEE Wiring Regulations

(BS7671) and current Building Regulations. If in any doubt, consult a qualified electrician

•Please isolate mains prior to installation or maintenance

•Check the total load on the circuit (including when this product is fitted) does not exceed the rating of

the circuit cable, fuse, or circuit breaker

•This product is safe for use as a drive-over fitting 1000kg @ 5mph (with half-lip cover removed)

•Please note the IP (Ingress Protection) rating of this product when deciding the location for installation

•This product should be installed in the upright position

•This product is Class I and must be earthed

•This product is IP65 rated

INSTALLATION

•Provide power to the required point of installation (refer to BS7671 for correct cabling methods).

Suitable IP rated junction boxes should be used where required

•The power source connections should be local and accessible via a suitable IP rated enclosure

•Cut a suitable hole in the mounting surface as per the cut-out details (see Fig.1) ensuring not to

infringe with any joists, gas/water pipes or electrical cables

Cut-out with sleeve

Cut-out without sleeve

70mm

65mm

Fig. 1

•Please note this product is supplied with a sleeve for direct mounting in the ground. The sleeve is not

necessary for installation into decking

•We recommend not installing in areas where there is a high risk of flooding or areas where water may

sit on top of the fitting (see Fig. 2)

•Ensure a minimum of 300mm of drainage is put below the luminaire (see Fig. 2)

Fig. 2

•There must be enough cable below the luminaire to carry out maintenance work (see Fig. 3)

Fig. 2

• There must be enough cable below the luminaire to carry out maintenance work (see Fig. 3)

Fig. 3

•Connect the luminaire to the mains supply ensuring the correct polarity is observed L - Live (brown), E

- Earth (green/yellow), N - Neutral (blue).

•Remove the bezel, lens and seal by unscrewing the two screws on top of the luminaire and insert a

suitable GU10 lamp

•Replace the bezel, lens and seal

•Switch on and check for correct operation

WARNING

This product must be disconnected from the circuit if subjected to any high voltage or insulation resistance

testing. Irreparable damage will occur to the lamp if this instruction is not followed.

Care should be taken when installing into high ‘clay’ content soils which naturally retain water and have poor

drainage. We recommend IP67 or IP68 products to be installed where these environmental conditions occur as

IP65 luminaires will likely be compromised.

This product is not suitable for installation in or near a coastal or marine environment.

GENERAL

The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole

luminaire should be replaced.

Clean the external surfaces with a damp cloth using a mild solution of detergent and warm water only, do not

use aggressive cleaning products or solvents which may damage the product.

Do not use any source of high-pressure washers to maintain or clean this luminaire.

A light film of acid-free oil is recommended after installation and maintained periodically (2-3 times a year) to aid

corrosion prevention.

This product is dimmable dependent on lamp type

This product should be recycled in the correct manner when it reaches the end of its life. Check local authorities

for where facilities exist.

WARRANTY

This product has a warranty of 1year from date of purchase. Failure to install this product in accordance with

the current edition of the IEE Wiring Regulations (BS7671), improper use, or removal of the batch code will

invalidate the warranty. If this product should fail within its warranty period, it should be returned to the place of

purchase for a free of charge replacement. ML Accessories does not accept responsibility for any installation

costs associated with the replacement product. Your statutory rights are not affected. ML Accessories reserve

the right to alter product specification without prior notice.

230V 50Hz, IP65 Class 1, driveover wheel

• Connect the luminaire to the mains supply ensuring the correct polarity is observed L - Live (brown),

E - Earth (green/yellow), N - Neutral (blue).

• Remove the bezel, lens, and seal by unscrewing the two screws on top of the luminaire and insert a suitable

GU10 lamp

• Replace the bezel, lens and seal

• Switch on and check for correct operation

Fig. 3

WARNING

Care should be taken when installing into high ‘clay’ content soils which naturally retain water and have poor

drainage. We recommend IP67 or IP68 products to be installed where these environmental conditions occur as

IP65 luminaires will likely be compromised.

This product is not suitable for installation in or near a coastal or marine environment.

GENERAL

Clean the external surfaces with a damp cloth using a mild solution of detergent and warm water only, do not

use aggressive cleaning products or solvents which may damage the product.

Do not use any source of high-pressure washers to maintain or clean this luminaire.

A light ﬁlm of acid-free oil is recommended after installation and maintained periodically (2-3 times a year) to

aid corrosion prevention.

This product is dimmable dependent on lamp type

This product should be recycled in the correct manner when it reaches the end of its life. Check local authorities

for where facilities exist.

WARRANTY

This product has a warranty of 1 year from date of purchase. Failure to install this product in accordance with

the current edition of the IEE Wiring Regulations (BS7671), improper use, or removal of the batch code will

invalidate the warranty. If this product should fail within its warranty period, it should be returned to the place

of purchase for a free of charge replacement. ML Accessories does not accept responsibility for any installation

costs associated with the replacement product. Your statutory rights are not affected. ML Accessories reserve

the right to alter product speciﬁcation without prior notice.

AKJUL21_V2

ML Accessories Limited LU5 4LT

www.mlaccessories.co.uk

INTERNATIONAL

CONTACT DETAILS

INTERNATIONAL

CONTACT DETAILS

INTERNATIONAL

CONTACT DETAILS

Table of contents

Other ML Accessories Lighting Equipment manuals

ML Accessories

ML Accessories TPR14LEDS Instruction Manual

ML Accessories

ML Accessories TPOV60B Instruction Manual

ML Accessories

ML Accessories T8BLED12 Instruction Manual

ML Accessories

ML Accessories SPIKE5S Instruction Manual

ML Accessories

ML Accessories WALL1 Instruction Manual

ML Accessories

ML Accessories SPIKEW Instruction Manual

ML Accessories

ML Accessories EA1 Series Instruction Manual

ML Accessories

ML Accessories 5410A Instruction Manual

ML Accessories

ML Accessories GUSPBK Instruction Manual

ML Accessories

ML Accessories AXREMC Instruction Manual

ML Accessories

ML Accessories NH027 Instruction Manual

ML Accessories

ML Accessories EMPDL Instruction Manual

ML Accessories

ML Accessories Knightsbridge BT9H4/6K Instruction Manual

ML Accessories

ML Accessories 12DCIP40 Instruction Manual

ML Accessories

ML Accessories TRIBCCW Instruction Manual

ML Accessories

ML Accessories CFR5CCT Instruction Manual

ML Accessories

ML Accessories FLN10 Instruction Manual

ML Accessories

ML Accessories 12DC50D Instruction Manual

ML Accessories

ML Accessories BATSCWMST4 Instruction Manual

ML Accessories

ML Accessories AX CCT Instruction Manual

ML Accessories

ML Accessories Knightsbridge SFPL Series Instruction Manual

ML Accessories

ML Accessories SHE1B Instruction Manual

ML Accessories

ML Accessories NH0183BD Instruction Manual

ML Accessories

ML Accessories LSPIKEA Instruction Manual

Popular Lighting Equipment manuals by other brands

Brizo

Brizo 8SP-MU-4 manual

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 installation instructions

IKEA

IKEA BJÖRKSPIREA manual

Laserworld

Laserworld Evolution Series ES-400RGB manual

Alien

Alien RG STAR user manual

EuroLite

EuroLite LED B-40 user manual

Qazqa

Qazqa Suplux SL 3 Black 103062 instruction manual

Commercial Electric

Commercial Electric 54568141 Use and care guide

CREE LIGHTING

CREE LIGHTING 304 Series installation instructions

Goobay

Goobay 49867 user manual

ECOMAN ITALIA

ECOMAN ITALIA LED T8 instruction manual

Alkalite

Alkalite Krypton KT-81 user manual

Clas Ohlson

Clas Ohlson GU10 manual

DTS

DTS DELTA 10 F user manual

ring

ring Solar Steplight manual

One Stop Gardens

One Stop Gardens 57696 Owner's manual & safety instructions

Chauvet DJ

Chauvet DJ COREpar UV120 ILS user manual

SIREM

SIREM Swimeo A2 instructions