Timer is ON and connected MistKing® system is misting
Timer is OFF and idle
Current time clock
Program : P0-P9
Start time of the program
Stop after set duration
Program repeats every day
LCD Display
WEEK
Setup Instructions:
1. Set current time and day of the week (picture A):
In normal status screen, press “
O
” key once to enter time setup.
Press “
O
” key to switch between week date, hour, minute and second. Use up arrow or down
arrow to adjust the value when ashing.
2. Set Timer Programs:
a.a. Set the “MODE” (picture B): In normal status, press “SET” key once, the current mode
ashes, press up arrow or down arrow key to switch between “AUTO, ON and OFF”; choose
the desired mode, then press “SET” key once.
Remember: Timer only executes the P0-P9 program in AUTO mode.
b
b. Set “P0” (picture C): When ”WEEK” of “P0” ashes, press “
O
” key to switch between day of
the week, or whole week (Mon, Tue, Wed, Thu, Fri, Sat, Sun, & Week), start time (hour, minute
and second) and stop duration (hour, minute and second). Use up arrow or down arrow key
to adjust the values when ashing.
START: Requires exact time when program is set to start. ie 10:54:00 am
STOP: Length of time specifying how long the misting system should engage. For example
00:00:40 would indicate 40 sec.
WEEK:
WEEK: Default setting for each program. Instead of executing the program any specic day,
it will repeat every day of the week
L
L
L
MistKing® Seconds Timer (ST-24) can be set to mist at user specified times. In addition, the misting duration of each program can also
be customized. ST-24 has 10 programs (P0-P9), giving you total control. No need to use all programs if not required. Each program can
be repeated daily or on a specific day only.
Example: P0: Start at 8:30 am and mist for 25 sec, every day of the week.
P1: Start at 2:30 pm, and mist for 1 min 20 sec, Wednesdays only.
Model: ST-24
Seconds Timer
Modes:
ON:
Always ON ---
OFF:
Always OFF ---
AUTO:
Uses any of the congured programs (P0-P9)
c. Set “P1”:
When done setting “P0”, press “SET” key once. Display will show “P1”, which can now be congured using same method from above (2b).
Continue pressing "SET" to set up programs for P2-P9 if need. Keep pressing SET until you cycle through all Programs and exit into main
screen.
Seconds Timer Connection
1.
Connect the BLUE lead on the seconds controller to the
power adapter of your MistKing misting system.
2.
Connect the BLACK lead to your pump and ZipDrip (if
available). DO NOT plug ZipDrip to blue lead.
NOTE: Seconds controller works only with MistKing
systems and therefore requires additional Mistking
components to work properly.
Using the seconds timer with non-MistKing
equipment voids warranty.
