Midea HS-65L User manual

Instruction Manual

Refrigerator

Model: HS-65L

General

This refrigerator is widely used in places such as hotels ,offices,

student dormitories and houses. It is small size, lightweight,

low electric consumption and easy use, most suitable for

refrigerating and preserving foods such as fruits and beverage.

Instructions for Installation

1.Do not tilt the refrigerator more than 450form upright during

moving. Do not apply force on any part such as condenser

and door to prevent the refrigerator from deforming as this

can influence its performance.

2.Allow the refrigerator enough space to operate well.

3.Do not install it in areas of high temperature or humidity to

avoid damage.

Cautions for Safety

1.Before the refrigerator is plugged in, ensure that the local

electric voltage (e.g. 240V) is the same as the rated voltage.

The power plug should have its independent socket as

adapter may cause the socket to overheat.

2.Do not store inflammable materials such as ether, benzine,

LP gas and glue etc. in the refrigerator.

3.Do not splash water on the refrigerator as it may cause

malfunction or electric shock.

Instructions for Use

1.When operating the refrigerator for the first time, run it

without loading any food until it automatically stops at the

desired temperature. Usually it takes 2 or 3 hours. Then, set

the thermostatic dial at the setting desired and put food in the

refrigerator.

2.The temperature of the refrigerator can be adjusted by

turning the thermostatic dial. A medium setting of the

thermostatic dial is the most suitable for general operation.

3.Defrost the freezing compartment whenever the layer of frost

on the surface of the evaporator reaches 3 or 4 mm. When

defrosting, remove all food and set the thermostat at “OFF”

position. Put the drip tray under the evaporator to collect

melted water. After the frost has melted, discard the melted

water and dry up the interior of refrigerator. The refrigerator

can then be restarted by turning its thermostat to the desired

setting.

Cautions for Use

1.The more food is put in or the more and the longer the door

is opened, the more electric it consumes, which may

eventually lead to malfunction.

2.Better not to place objects which are too heavy, pointed or

corrosive on table board.

3.Re-plugging in the power plug at the interval of over ten

minutes.

4.Do not store bottled drinks in the freezer as they may break

and damage the refrigerator.

5.Open the door as little as possible during power-cut.

6.When defrosting, never use any sharp or metallic objects to

remove the frost on the surface of the evaporator as it will

damage the evaporator.

7.Do not touch any food or container in the freezing

compartment with your wet hands to prevent frostbit.

Maintenance

1.While cleaning the refrigerator, pull out the electric power

plug. Wipe the refrigerator carefully with a piece of cloth

soaked with natural cleanser before wiping it with clean

water. Abrasive cleaning powder, alkali cleansers, chemical

cloth, thinner, alcohol, acid petroleum product and hot water

are not suitable for cleaning the refrigerator as they may

cause permanent damage to the painting cover and plastic.

2.Clean the door gasket whenever it is dirty.

3.If the refrigerator is out of use for a long time, pull out the

plug, clean and dry the freezing compartment then close the

door tightly.

The following cases are not malfunction

1. Sound of flowing water:

The sound of flowing water can be heard under normal

operation.

2. Outside condensation:

Outside condensation is normal in areas of high humidity.

You may wipe off the condensation with a cloth.

3.It takes some time for the temperature of the freezer and

refrigerator compartment to become cold after the

refrigerator starts to operate. If the environmental

temperature is higher, it will take a longer time to cool the

compartments.

4. The surface of the compressor becomes hot:

The surface of the compressor may become hot under

normal operation. Do not touch it with your hands.

Troubleshooting

If any case of malfunction, please inspect and rectify it

according to the checklist shown in the following table.

case

Inspection

Not refrigerating

Is there no electric current?

Is the voltage normal or not?

Has the socket fused?

Is the plug inserted into the socket correctly?

Not efficient

Is the thermostatic dial set to the correct

position?

Is there sufficient clearance space around

the refrigerator?

Has the door been opened too frequently or

for too long?

Is the refrigerator exposed to direct sunlight

or placed near heating devices?

Are there too much food inside?

Are the food too hot?

Is the room temperature too high?

Food frozen in

the refrigerator

compartment

Is the thermostatic dial set to the correct

position?

Have the food been put too close to each

other?

Noises

Is the refrigerator placed on a leveled

surface?

Has the refrigerator been struck by some

other objects?

Compressor

does not stop

automatically

Are the food stored too much at one setting?

Are the doors opened too frequently or for

too long?

If the above methods are not effective, please contact your

local Midea Service Centre for assistance.

DANGER or WARNING:

1. Risk of child entrapment. Before you throw away your old

refrigerator or freezer:

-Take off the door.

-Leave the shelves in place so that children may not easily

climb inside.”

2. Do not use extension cords.

For household refrigerating appliances

Try not to open the door too often, especially when the weather

is wet and hot. Once you open the door, mind to close it as

soon as possible.

Every now and then check if the appliance is sufficiently

ventilated (adequate air circulation behind the appliance).

For household refrigerating appliances, in normal temperature

conditions, please arrange the thermostat at the middle setting.

Before loading the appliance with packages of fresh

foods, make sure they are cooled to ambient temperature.

Ice and frost layer increase energy consumption, so do clean

the appliance as soon as the layer is 3-5 mm thick.

If it is the outer condenser, the rear wall should be always

clean free of dust or any impurities.

Always consider instructions stated in sections Positioning and

Energy Saving Tips, otherwise the energy consumption is

substantially higher.

WARNING

1) The appliance has to be unplugged after use and before

carrying out user maintenance on the appliance.

2) This appliance is not intended for use by persons (including

children) with reduced physical, sensory or mental

capabilities, or lack of experience and knowledge, unless

they have been given supervision or instruction concerning

use of the appliance by a person responsible for their

safety.

3) Children should be supervised to ensure that they do not

play with the appliance.

4) If the supply cord is damaged, it must be replaced by the

manufacturer, its service agent or similarly qualified

persons in order to avoid a hazard.

5) Please abandon the refrigerator according to local

regulators for it use flammable blowing gas.

Table of contents

Other Midea Refrigerator manuals

Popular Refrigerator manuals by other brands

Bonnet Neve

Bonnet Neve SKYVIEW PLUS User instructions

Zanussi Electrolux

Zanussi Electrolux ZERB 8441 Instruction book

Sharp

Sharp SJ-BA31IEXW2-EU user manual

CORBERO

CORBERO CC2300MCW Instruction booklet

KitchenAid

KitchenAid 2205264 Use and care guide

Stengel

Stengel KU 1101 A++ user manual

NEFF

NEFF KI181 Series user manual

Hoshizaki

Hoshizaki Reach-In instruction manual

Amana

Amana ASD2524VES00 User instructions

BOMANN

BOMANN KGC 213 instruction manual

Danby

Danby DAR044A1SLDD Owner's use and care guide

Samsung

Samsung RF323TE user manual

Beko

Beko CSA31022 Instructions for use

IKEA

IKEA FROSTIG C 185 E manual

Electrolux

Electrolux ER 6821 D Instruction book

True

True TS-28 Specifications

Frigidaire

Frigidaire FSC23R5DW9 installation guide

Beko

Beko LSP4579W Instructions for use