Micromark 90533 User manual
#90533 WET / DRY VACUUM
INSTRUCTION MANUAL
Please read the instruction manual carefully before use
-
1
-
CONTENTS
1. Parts Identification Drawing--------------------- 2
2. Accessories and Vacuum Specifications-------3
3. Safety Notices ---------------------------------------4
4. Warnings--------------------------------------------5-9
5. Installation and Assembly-------------------------9
6. Application Dry and Wet---------------------10-14
7. Electrical Circuit & Maintenance---------------15
8. Trouble Shooting and Warranty------------16-17
-
2
-
Parts Identification
Fig. 1.
-
3
-
Includes:
Standard Accessories
Φ32*1.2M hose 1pc Dust Bag 1pc
2 in 1 nozzle 1pc Floor Brush 1pc
Plastic Pipe 2pcs Wheels 4pcs
Silencer/Dampener 1pc
Specifications
Product name: VACUUM
CLEANER
Model No.: 90533
Rate Voltage: 110V/ 50~60HZ Rate Power: 1000W
Max Suction: 17KPA Tank
Capacity:
3 Gallon
Noise: 80dB(A) Weight： 7 Lbs.
Package Size： 320*320*400/420/485mm
-
4
-
Production
Standard：
Safety Notice
-
5
-
Warnings:
WARNING! IMPORTANT READ CAREFULLY all safety warnings and all
instructions BEFORE USE.
Failure to follow the warnings and instructions may result in electric
shock, fire and/or serious injury
1. Before use, make sure that this cleaner must be used by people who
have been adequately instructed on the use of this cleaner.
2. Only use the socket outlet on the cleaner for purposes specified in the
instructions.
3. If liquid escapes from the cleaner, switch off immediately.
4. Clean the water level limiting device regularly and examine it for signs
of damage.
5. For Dry Use….Do not use the cleaner without the filter. Replace a
damaged filter immediately.
6. USE OF EXTENSION CORD. If an extension cord is required, make sure
that use an adequate one of size and length for the purpose. Using a gauge
of cord to small or too long will cause the motor to receive insufficient
electrical current and cause the motor to overheat or otherwise be
damaged.
-
6
-
7. VOLTAGE WARNING: Before connecting the cleaner to a power source
(receptacle, outlet, etc.) be sure the voltage supplied is the same as that
specified on the nameplate of the cleaner. A power source with voltage
greater than that specified for the cleaner can result in SERIOUS INJURY
to the operator as well as damage to the cleaner. If in doubt, DO NOT
PLUG IN THE CLEANER. Using a power source with voltage less than the
nameplate rating is harmful to the motor.
8. AVOID UNINTENTIONAL STARTING. Be sure switch is OFF when
plugging in.
9. Do not attempt to pick up flammable materials, fire works, lighted
cigarettes, hot ashes, hot metal chips, sharp materials such as razors,
needles, broken glass or the like.
10. NEVER USE THE CLEANER IN THE VICINITY OF GASOLINE, GAS, PAINT,
ADHESIVES OR OTHER HIGHLY EXPLOSIVE SUBSTANCES. The switch
emits sparks when turned ON and OFF. And so does the motor
commutator during operation. A dangerous explosion may result.
11. Never vacuum up toxic, carcinogenic, combustible or other
hazardous materials such as asbestos, arsenic, barium, beryllium, lead,
pesticides, or other health endangering materials.
12. Never use the cleaner outdoors in the rain.
13. Do not use close to heat sources (stoves, etc.).
-
7
-
14. GUARD AGAINST ELECTRIC SHOCK. Prevent body contact with
grounded surfaces. For example: pipes, radiators, ranges, refrigerator
enclosures.
15. Do not block cooling vents. These vents permit cooling of the motor.
Blockage should be carefully avoided otherwise the motor will burn out
from lack of ventilation.
16. Always keep proper footing and balance.
17. DO NOT ABUSE CORD. Never carry the cleaner by cord or yank it to
disconnect from receptacle. Keep cord away from heat, oil, and sharp
edges.
18. Do not fold, tug, or step on the hose.
19. Stop the cleaner immediately if you notice poor performance or
anything abnormal during operation.
20. DISCONNECT THE CLEANER. When not in use, before servicing, and
when changing accessories.
21. Clean and service the cleaner immediately after each use to keep it
in tiptop operating condition.
22. MAINTAIN THE CLEANER WITH CARE. Keep the cleaner clean for
better and safer performance. Follow instructions for changing
accessories. Inspect cleaner cords periodically and if damaged, have
repaired by authorized service facility. Inspect extension cords
-
8
-
periodically and replace if damaged. Keep handles dry, clean, and free
from oil and grease.
23. CHECK DAMAGED PARTS. Before further use of the cleaner, a guard
or other part that is damaged should be carefully checked to determine
that it will operate properly and perform its intended function. Check for
alignment of moving parts, binding of moving parts, breakage of parts,
mounting, and any other conditions that may affect its operation. A
guard or other part that is damaged should be properly repaired or
replaced by an authorized service center unless otherwise indicated
elsewhere in this instruction manual. Have defective switches replaced
by authorized service center. Don’t use the cleaner if switch does not
turn it on and off.
24. REPLACEMENT PARTS. When servicing, use only identical
replacement parts.
25. STORE IDLE CLEANER. When not in use, the cleaner should be stored
indoors.
26. Be kind to your cleaner. Rough handling can cause breakage of even
the most sturdily built cleaner.
27. Do not attempt to clean the exterior or interior with benzine, thinner
or cleaning chemicals. Cracks and discoloration may be caused.
28. Do not use cleaner in an enclosed space where flammable, explosive
or toxic vapors are given off by oil-base paint, paint-thinner, gasoline,
-
9
-
some mothproofing substances, etc., or in areas where flammable dust
is present.
29. Do not leave the cleaner cord lying on the floor after you have
finished a cleaning job. It can become a tripping hazard or may cause
damage to the cleaner.
30. Do not operate this or any tool while under the influence of drugs or
alcohol.
31. As a basic rule of safety, use safety goggles or safety glasses with side
shields.
32. Use a dust mask in dusty work conditions.
33. The cleaner is not intended for use by young children or inform
persons without supervision.
34. Young children should be supervised to ensure that they do not play
with the cleaner.
35. Never handle plug cord or cleaner with wet hands.
36. Use extreme caution when cleaning on stairs.
Assembly
CAUTION: Always be sure that the cleaner is switched off and
unplugged before carrying out any work on the cleaner.
1. Insert the hose into suction hole and lock by clockwise rotation.
2. Assemble the required tubes and brush onto the handle.
3. Remove the hose with anti-clockwise rotation and pull out after use.
Table of contents
