v
1. Introduction
Once you have soldered the headers your
board is ready to be placed into desired
mikroBUS™socket. Make sure to align the
cut in the lower-right part of the board
with the markings on the silkscreen at
the mikroBUS™socket. If all of the pins are
aligned correctly, push the board all
the way into the socket.
3. Plugging the board in
2 3
2. Soldering the headers
1
4. Essential features
Turn the board upward again. Make sure
to align the headers so that they are
perpendicular to the board, then solder the
pins carefully.
Turn the board upside down so that
bottom side is facing you upwards. Place
shorter parts of the header pins in both
soldering pad locations.
Before using your click™board, make sure
to solder 1x8 male headers to both left
and right side of the board. Two 1x8 male
headers are included with the board in
the package.
ver. 1.01c
0 100000 026595
GSM click
™
with it’s Telit GL865-QUAD IC is
ideal for mobile devices. It features GSM/GPRS
protocol stack 3GPP (release 4 compliant) and
supports GSM/GPRS 850/900/1800/ 1900
MHz Quad-band frequency. Additional features
such as integrated TCP/IP protocol stack
(including UDP, SMTP, ICMP and FTP), serial
multiplexer, remote AT commands and many
more, extend the functionality of the board.
click™
BOARD
www.mikroe.com
GSM click™
GSM click™is an add-on board in mikroBUS™
form factor. It’s a compact and easy solution
for adding GSM/GPRS mobile phones standard
to your design. It features a GL865-QUAD
GSM/GPRS module, a TXB0106 6-bit
bidirectional voltage-level translator and a
SIM CARD socket. GSM click™communicates
with the target board microcontroller via
seven mikroBUS™lines (RX, TX, INT, PWM,
CS, RST and AN). The board is designed to use
3.3V and 5V I/O voltage levels. A LED diode
indicates the presence of power supply.
