II. BASIC WORKBENCH ASSEMBLY
1. Open cartons and identify the two leg assemblies
(A & B) and rails (C & D).
NOTE: Rear right and left legs of bench will have
pre-drilled hole for upright plate attachment (I) shown
below. Top side of rail will have pre-drilled holes for
mounting top.
2. Locate top of leg assemblies (A & B) and attach
rails (C & D) to legs with bracket (E) hardware and
Allen wrench provided.
3. Install foot inserts to bottom of legs by placing them
over the legs and tapping them into position with a
mallet. If optional leg extenders are being installed,
refer to diagram on opposite page.
4. Screw the leveling legs into the inserts and adjust
so that table is level.
5. If installing a grounding cable to the table top, it
must be attached to the underside of the top prior to
installing the top. See grounding diagram on page 4.
6. Position the table top (G) so that the rear of the top
is flush with the back of the table frame and has
equal overhang on both ends. Top must be flush
with back of the table, otherwise it may interfere with
upright mounting (shown below).
7. Attach the top to the frame by inserting the wood
screws (H) through the holes in the frame assembly
and screwing them into the underside of the top (G)
in eight places.
8. Make certain all bolts are securely tightened.
1. Open carton and identify the drawer mounting
channels and mounting hardware.
2. Install the mounting channels (K) on the underside
of the table frame; make sure that the short vertical
leg of the channel is to the inside of the drawer
on both channels. Tighten the hardware securely.
3. Remove the drawer (M) from the drawer frame (L)
by extending the drawer on its slides and then
flipping the slide safety stop downward to allow the
drawer to be disengaged from the frame.
4. Position the drawer frame (L) below the mounting
channels (K) and mount to the channels using the
hardware provided. Tighten the hardware securely.
5. Attach drawer front, handle and lock to drawer.
6. Reinstall the drawer to the drawer frame.
7. To install optional add-on drawers (N), remove
drawers from frames. Bolt frames together in
four places using the hardware provided with the
add-on drawer.
1. Orient the mounting brackets (I) so that the short flange is facing inward
(toward the table leg) and the long flange facing away from the table.
2. Attach the bracket to the table leg with the long bolt, washer, and nut.
3. Position the upright (J) against the mounting bracket and attach to the
bracket using the short bolt and rectangular nut. Follow the upright
accessory mounting instruction shown at the top of page 3.
4. The upright should always be attached using two bolts and at minimum,
it should be flush with the bottom of the bracket or protrude below.
(See overleaf for instructions on installation of upright mounted accessories.)
LONG
FLANGE
UPRIGHT
MOUNTING
PLATE
OPTION: ATTACH DRAWER ASSEMBLY
UPRIGHT MOUNTING INSTRUCTIONS
A
E
D
D
B
C
A
F
G
H
IJ
L
N
K
L
K
M
Page 2
