Laminate Your Value
www.mefuchina.com
Technical specification
1. Regulate the fraction of the rollers
2. Fix or regulate the chain wheel key on the
3. If Motor or speed controller breakdown, Just
replace the motor or the speed controller.
Control panel is dead halted
1. Check power supply or emergency button.
2. If the fuse is burn down, just replace.
(If none of this helps, please contact a
technician)
1. Rises up the temperature
2. Clean the surface of graphic
3. If there is some problems with the film,
1. Adjust the pressure of the rollers.
2. Make the printings flat
3. Improve speed or lower temperature.
4. Put the beam weight on printings
Regulate the pressure of the rollers.
1. Regulate the film roll's fraction
Regulate the tension of the film or the reception
roll
Repairs
Contact a technician
You should first try contacting a technician through the dealer
where you bought your MEFU Laminator.
If this is not possible, contact MEFU Technical Service
Phone: +00 86 15890020566
Accessories
For any necessary accessories you need, you can try to contact
the dealer where you bought your MFEU Laminator.
The equipment may only be
used for its intended purposed
as specified in this manual. For
any other use may result in
damage or injury, and is at the
user’s own risk.
