Medeli DR2 User manual
FCC Information
NOTICE
FCC WARNING
GUIDELINES LAID DOWN BY FCC RULES FOR USE OF THE UNIT IN THE U.S.A. (not
applicable to other areas)
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and,if not installed and used in accordance with
the instructions,may cause harmful interference to radio communications. However,there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception,which can be determined by turning
the equipment off and on,the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into anoutlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or anexperienced radio / TV technician for help.
2
3
IMPORTANT NOTES
Thank you very much for purchasing this product . You are recommended to study this
manual carefully before using the unit.
This unit could be operated either by a 3V battery or by a 3V center minus DC adaptor.
Before connection,please ensure the power supply has been properly installed and all power devi-
ces such as amplifiers must firstbe turned off,in order to avoid any malfunction.
Avoid using this unit together with same circuit of electronic products that will generate line noises.
Do not place this unittoo close to heat sources such as radiator and amplifier in order to prevent
damages like interference.
Do not expose this unit under excessive sunlight,water and moisture.
Strong vibration and shock will damage this unit.
Clean this unit with a soft and dry cloth. Aslightly dampened cloth with mild detergent might remove
stubborn dirt.
Never use thinners and alcohol for cleaning the unit.
Hold the unit firmly while unplugging the cables,never pull the audio cables with stress.
Note: If the recorder doesn t w
ork w
ell, p
lease p
ull t
he p
ower jack a
nd t
ake o
ut t
he
battery, then plug the power jack or put the battery in again to turn on the recorder.
The normal function of the product may be disturbed by Strong Electro Magnetic Interference.
If so, simply reset the productto resume normal operation by followingthe instruction manual.
In case the function could not resume, please use the product in other location.
Caution!
When to use DR2 ?
This product is suitable in the following situation
Sound sampling in an external or internal environment
Live recording
Conference recording
Course recording for students
Home Studio
Journalist and other situation need interview recording to record
This product provides high quality recording function and accurate
position for sound
It stores file in both wav and mp3
4
5
MAIN FEATURES
Stereo 4 mics recording,360 degree mode. Support mp3 and wav format.
16bit/24bit,44.1K and 48K sample rate.
Support SD/SDHC card up to 16G.
128*64 OLED display.
Bass compensate, 3D effect, Reverb Chorus Pitch and Delay effect.
MP3 voice cancelling.
Tuner function inside for guitar and bass player.
Easy to operate.
SIDE PANEL
FRONT PANEL
BATTERY REPLACEMENT DIAGRAM
MENU TREE
BASIC OPERATION
RECORDING SETUP
RECORDING
SETUP PLAYBACK
PLAYBACK
EFFECTS
FILE MANAGEMENT
UTILITY
SD CARD
MIC
SPEAKER
PHONES
CURRENT STATE PROTECT
SPECIFICATIONS
6
CONTENTS
7-8
9-10
11
12
13-26
13-15
16-19
20-22
23-26
27-30
31-34
35-38
39-40
41
41
41
43
42
1.POWER supplyjack:(DC in 3V center minus)
Connect an AC adaptor to this jack.
2.[POWER ON/OFF]button:
Turn the power on/off.
3.[VOLUME] button:
Adjust volume.
4. [MIC GAINH..L ] button:
Choose high levelmic input or low level input.
5.USB jack
:
Connect to computer.
67
SIDE PANEL
4
3
2
1
9
8
7
6
5
SIDE PANEL
4
3
2
1
9
8
7
6
5
6.LINE INjack:
Connect to any other audio device such as mp3 and
CD player.
7. EXT MICjack:
Connect the external microphone.
8. [INPUT LEVEL+/-]button:
You can also adjust the recording levelby
[INPUT LEVEL +] or [INPUT LEVEL-] button.
9. PHONES jack:
Connect a pairof stereo headphones to this jack.
8
69
10.[MENU] button:
Press [MENU] button to choose the menu.
11. [BACK/CANCEL] button:
Press [BACK/CANEL] goes back to the home screen.
Long press[BACK/CANCEL]button to hold on / off .
12. [REPEAT A B] button:
A-B repeat function allows you to specify point A
and point B and automatically play the section
between these two points repeatedly.
13. [EFFECT] button:
Effects button to choose.
LRLR
24bit WAVE/MP3
RECORDER
24bit WAVE/MP3
RECORDER
10
12
13
14
15
16
11
FRONT PANEL
14. [MONITOR] :
Headphone monitor output on/off.
Long press to turn on/off speaker while playing.
15. [REC] :
Record button
16. [Display]
A variety ofinformation about the unit appears
here.
17. [ ]/[ ]:
[PLAY/PAUSE] button / [Up] button .
18. [ ]/[ ] :
[STOP] button / [Down] button .
19. [ ]/[ ]
[F.F] button / [Right] button .
20.[ ]/[ ]
[REWIND] button / [Left] button .
LRLR
24bit WAVE/MP3
RECORDER
24bit WAVE/MP3
RECORDER
10
12
13
14
15
16
18 17
11
FRONT PANEL
17
18
19
20
6
10
Table of contents
