Quick Start
../..
DMX/RDM DIGITAL FAN
Installation
The MDG theFan comes ready to use.
It can be suspended from a truss via a Omega clamp or a Half
Cheeseborough clamp, or it can be simply placed on a horizontal
surface on its vibration feet.
Connect the data wiring (DMX or RDM), if you want to use
remote control
Plug the IEC power cord (90–250 VAC, 50-60 Hz, 100 W)
Block the hand wheels
Switch on the power
The MDG theFan is now ready to be used.
… For further details, please read the Operating Guide.
DMX / RDM
The MDG theFan has two personalities:
Mode 1 Channel
1. Fan Off < 10% (26)
Fan Speed, from low (10%) to high (100%)
Mode 2 Channels
1. Fan Off < 50 % (128) ≤Fan On
2. Fan Speed, from low (0%) to high (100%)
The MDG theFan is implemented with the most common RDM parameters.
Menu Tree
1. FAN On/Off Mode 2 Channels only / DMX Channel #1
2. Output 0 –255 Mode 1 Channel / DMX Channel #1
Mode 2 Channels / DMX Channel #2
3. DMX Add 1 –511 Can also be set via RDM
4. DMX Pers 1 CH –2 CH Can also be set via RDM
5. Mode Auto / Local / DMX In AUTO, DMX controls always take precedence over Local commands
6. Firmware 1.xxx
7. Dev. ID xxxxx Label ID. Can only be set via RDM
8. UID xxxxx RDM Unique ID
