Installation & Walk Test
1
4
3
2
6
2.0~2.2m
5
1. The motion detector should be installed in entry or exit which
intruder can easily enter.
2. The detector is more sensitive to cross-movement than to direct
movement. The performance of the detector is optimal when detection
direction is across the walking direction of intruders.
3. Press the clip, insert the battery properly, and then close the cover.
4. Using screws to fix the bracket of detector on the wall, attach the
detector to the bracket.
5. Keep LED indicator at the right direction. The fixing height is about
2~2.2m from the ground.
6. Adjust installation height or bracket to change the detection
distance and angle.
Walk Test:
1. When the power is on, the LED indicator flashes five times
and buzzer beeps five times to enter working state.
2. Walk across detection area and watch the LED indicator to
make sure it flashes once when detecting the movement.
After one detection, it will detect once every one minute.
1. Avoid mounting the detector close to places where heat
changes fast or air stream flows frequently.
(ie. Air conditioner, tube light, oven, waver, refrigerator etc.)
2. Avoid it facing to window which can be easily interfered by
complicated environment. (ie. sunlight, crowds, or flowing
cars etc.)
3. The product can reduce the possibility of
accident, but the user is advised to take all
necessary precautions for the safety and the
protection of the property.
Notice
When the power is on, the LED indicator flashes 5 times, and buzzer
beeps 5 times to enter testing mode. In this state, every movement
will trigger the detector and activate the alarm signal. Detector enters
working mode after 20 detections.
Working Mode:
In this state, the detector enters sleeping mode to save power after
first detection. If there's no movement within 4 minutes, the detector
goes back to the working state. If there's detection occurs within
4 minutes, the time detector goes back to working state will be added
accordingly.
Installation:
Testing Mode:
110°
2m 4m 6m 8m
0m
0m
2m
Detection Area
Side View
Top View
Connecting P.I.R. Motion Detector to Control Panel
The new-bought P.I.R. motion detector should be enrolled
to the control panel before use. For specified operation,
please refer to the manual of alarm system.
