Matchmaster 01MM-DG27 User manual

Step 1

Open small VHF element to 90º to boom till

plastic insulator snaps into position.

See diagram.

Step 3

Cut the rubber boot seal

provided as in diagram.

Step 5

Select connector provided.

(Suitable for RG6 or semi airspaced cable)

Place “F” connector on back to front and twist to

ensure that all braid is at. See diagram.

(For other cable types

you will need to purchase

the corresponding

connector)

Step 7

Select the UHF dipole then connect the cable you have

just prepared to the connector on the balun marked

"OUTPUT".Then take the

short cable with two

connectors already

attached and connect

one end to the connector

marked "INPUT".

NEW X TYPE

DIPOLE FOR BETTER

PERFORMANCE

01MM-DG27 L4052

UHF/VHF Ch (6-12) (21-46) HD Compliant Antenna Installation Instructions

G-Unit®

Plastic Outer Case

Metal Braid

Dielectric

Metal Sheath Knurled Surface Core

Conductor

Step 4

Strip coax cable as shown in diagram and

feed through rubber boot seal.

Step 6

Then insert cable into rear of connector and twist connector

clockwise until dielectric is ush with the bottom nut as in Fig 6.

Ensure that 2-3mm of centre core conductor protrudes past the nut.

Step 8

Then slide rubber boot

seals into position as per

diagram.

Step 2

Attach double folded dipole ('G' Unit®) to boom using the washers

and wing nut. Ensure short element is on the top of the boom and

the 'G' Unit®is attached to the bottom of the boom. See diagram.

Step 9

Select UHF boom pictured below and clip the X type elements

onto 'U' shaped plastic insulators on the boom ensuring the

clips t securely onto insulator on boom.

Then attach the UHF Dipole ensuring that

the X dipole is positioned towards the front

of the Antenna. See diagrams.

Step 10

Assemble UHF

Boom to VHF boom

as per diagram

using 5mm screw

and wing nut

provided.

Step 12

Then attach corner reector

using the two screws

and wing nuts provided

as per diagram.

Step 13

Attach antenna to mast and point to transmitter as per

diagram. Rotate antenna to achieve best results.Attach cable

to cable tie near u-bolt and attach cable to mast with UV

grade insulation tape or UV grade

cable ties to support cable weight and avoid damage to

connection from wind whipping cable from side to side.

When using the antenna in Canberra, Condobolin,

Taree, Bundaberg, Shepparton and where

UHF is horizontally polarised andVHF is

vertically polarised, turnVHF section so

the elements are vertical .

You will then need to use a stand off

boom mount ( 11MM-SM1-15 ) NOT

INCLUDED to attach antenna to mast.

Attach theSM1-15 to the mast, then attach

the antenna to the SM1-15.

For any technical enquiries, please call Matchmaster TV Reception Systems on

Toll Free Aust: 1800-AERIAL (1800-237425) or Toll Free NZ: 0800-AERIAL (0800-237425)

Step 11

Attach U bolt and mast clamp as per diagram.Then attach the

other end of the short cable to the balun on the VHF dipole.

Attach the short cable and the antenna downlead to the boom

using the cable tie provided.This is to ensure cable

does not move in the wind.

To Transmitter

Other Matchmaster Antenna manuals

Matchmaster

Matchmaster Digimatch 03MM-DC21V User manual

Matchmaster

Matchmaster Digimatch Explorer 01MM-DE7 User manual

Matchmaster

Matchmaster DigiMatch 02MM-DG91 User manual

Matchmaster

Matchmaster Digimatch 01MM-DC21A User manual

Matchmaster

Matchmaster 04MM-RP03 User manual

Matchmaster

Matchmaster DIGIMATCH 01MM-DE13 User manual

Matchmaster

Matchmaster DiGiMATCH 03MM-BIGRAY User manual

Popular Antenna manuals by other brands

Alfa Network

Alfa Network APA-L01 Specifications

Naval

Naval PR-422CA Operation manual

Feig Electronic

Feig Electronic ID ISC.ANTH200/200 Series manual

TERK Technologies

TERK Technologies TV44 owner's manual

Directive Systems & Engineering

Directive Systems & Engineering DSE2324LYRMK quick start guide

HP J8999A instructions

MobilSat

MobilSat MSP-S Mounting instructions

Steren

Steren ANT-UHF 13 instruction manual

Novatel

Novatel 600-G User information

Radio Shack

Radio Shack Amplified VHF/UHF/FM Indoor Antenna owner's manual

TRENDnet

TRENDnet TEW-AO12O Specifications

Radio Shack

Radio Shack 15-1837 owner's manual

CommScope

CommScope CMAX-OMFX-43M-I53 Installation instruction

Ramsey Electronics

Ramsey Electronics DAP25 Kit assembly and instruction manual

COBHAM

COBHAM SAILOR 800 VSAT Replacement procedure

Trango Systems

Trango Systems AD900-9 Specification sheet

Steren

Steren ANT-100 user manual

Proxim

Proxim 5054-PA-23 quick start guide