4 of 24JEM Glaciator X-Stream - Revision A, 06-19-2017, Level 1
Figure 2: Preventing electric shocks
Preventing electric shocks
• Always ground (earth) the machine electrically.
• Use only a source of AC power that complies with
local building and electrical codes, and that has
both overload and ground-fault protection.
• Before connecting the machine to power, check
that the voltage indicated on the machine’s serial
label matches your local AC power voltage. If your
AC power voltage does not match, do not use the
machine. Contact Martin™ Service for assistance.
• Before using the machine, check that all power
distribution equipment and cables are in perfect
condition and rated for the current requirements of
all connected devices.
• If the machine or any cables connected to it are
in any way damaged, defective, wet, or show
signs of overheating, stop using the machine
and contact Martin™ Service for assistance. If
the supply cord is damaged, it must be replaced
by a special cord or assembly available from the
manufacturer or its service agent.
• Disconnect the machine from AC power before
servicing and when not in use as directed.
• This machine is not waterproof and must not
be exposed to wet outdoor conditions. Do not
immerse in water or any other liquid. Do not
expose to high-pressure water jets.
• Do not spill uid over or inside the machine. If
uid is spilled, disconnect AC power and clean
with a damp cloth. If uid is spilled onto electronic
parts, take the machine out of service and contact
Martin™ for advice.
• Do not remove the covers or attempt to repair a
faulty machine. Refer any service not described in
this manual to Martin™ Service.
• Do not operate the machine if any parts are
damaged, defective or missing.
• Moisture and electricity do not mix. Do not aim fog
output at electrical connections or devices.
