IMPORTANTSAFEGUARDS
WARNING –To guard against injury, basic safety precautions should be observed, including the following:
READ AND FOLLOW ALL
SAFETY INSTRUCTIONS
DANGER – To avoid possible electric shock, special care should be taken in the use of aquarium equipment. For each of the following
situations, do not attempt repairs yourself; contact an authorized service facility for service.
1. A. If an appliance falls into the water, DON'T reach for it! First unplug it and then retrieve it. If electrical components of the unit get wet,
unplug this equipment immediately.
B. If the equipment shows any sign of abnormal water leakage, immediately turn off power at main disconnect.
C. Carefully examine the equipment after installation. It should not be plugged in if there is water on parts not intended to be wet.
D. Do not operate any equipment if it has a damaged cord or plug, or if it is malfunctioning or if it is damaged in any manner.
E.To avoid the possibility of the plug or receptacle getting wet, position
tank to one side of a wall mounted receptacle to prevent water from
dripping onto the receptacle or plug.A "drip loop", shown in the
Illustration at right should be arranged bythe user for eachcord
connecting equipment to a receptacle.The "drip loop" is that part of the
cord below the level of the receptacle or the connector, if an extension
cord is used, to prevent water traveling along the cord and coming in
contact with the receptacle. If the plug or receptacle does get wet,
DON'T unplug the cord. Disconnect the fuse or circuit breaker that
supplies power to the appliance.Then unplug and examine for
presence of water in the receptacle.
2. Close supervision is necessary when any equipment is used by or
near children.
3. To avoid injury, do not contact moving parts or hot parts such as heaters, reflectors, lamp bulbs, etc.
4. Always unplug this equipment from an outlet when not in use, before putting on or taking off parts, and before cleaning. Never yank
cordto pull plug from outlet. Grasp the plug and pull to disconnect.
5. Do not use an this equipment for other than intended use.The use of attachments not recommended or sold by the appliance
manufacturer may cause an unsafe condition.
6. Do not install or storethe equipment where it will be exposed to the weather or to temperatures below freezing.
7. Make sure any appliance mounted on a tank is securely installed before operating it.
8. Read and observe all the important notices on the equipment.
9. If an extension cord is necessary, a cord with a proper rating should be used.A cord rated for
less ampere or watts than the equipment rating may overheat. Care should be taken to
arrangethe cordso that it will not be tripped over or pulled.
10. This equipment should be grounded to minimize the possibility of electric shock.This unit
is equipped with an electric cord that has an equipment grounding conductor and a
grounding type plug.The plug must be plugged into an outlet that is installed and grounded
in accordance with all appropriate codes and ordinances.
11. This equipment is for use on a nominal 120 volts circuit, and has a grounding plug that
looks like the plug illustrated in (A).A temporary adapter which looks like the adapter
illustrated in (B) and (C) may be used to connect this plug to a two pin receptacle as shown
in (B) if a grounded outlet is not available.The temporary adapter should be used only until a grounded outlet can be installed by a
qualified electrician.The green colored rigid ear (lug and the like) extending from the adapter must be fastened to a permanent ground
such as a grounded outlet box.
Grounding
Pin
Adapter
Grounding
Means
(C)
Grounding
Pin (D)
(A)(B)
Metal
Screw
Cover of Grounded
Outlet Box
SAVE THESE INSTRUCTIONS
Power
Supply Cord
Drip Loop
