FILL IN:
•Type a description of the EDL-Net log-
ger (see example: “Demo 1”),
•Under Host, put the address of the
EDL-Net you wrote down earlier (exam-
ple: “192.168.0.190”),
•The TCP Port is the “Logger Port
Address” you wrote down earlier (exam-
ple: “10001”).
•Click Test to test the connection for
the server.
•Then click on Add. You will return to
the “RF Logger Add” window.
ENTER:
•A description of the EDL-Net
logger (you can use the same
description as the server),
•Select EDLNet from the drop
down list,
•Select the server you just
entered in the previous step.
•Then click OK.
Logger Initialization:
To configure the logger
•In the MDAS-Pro menu bar
click on EDL-Net.
•In the drop-down menu
click on the Logger you just
entered.
•Click on Logger
Initialization.
The Logger Initialization screen
allows you to set up your
parameters for the EDL-Net
logger by using the four tabs:
Setup, Measurement,
Alarms, and Properties.
SETUP TAB
• Description: Enter alpha or numeric
information, such as the location of the
unit.
• Tracking Number: Enter any numeric
information. We recommend using the
same number as the logger address.
• Logger Clock: Set the time manually
in the window provided or to set the
logger-time based on the computer
time as registered on your personal
computer.
• Battery Status: The EDL-Net logger comes with two sets of batteries: one set
powers the RF module and the other one powers the logger. The percentage
bar in this section displays the estimated battery life based on the date when
the logger battery was first installed or replaced.
MEASUREMENT TAB
• Start Delay: Set a time delay in hours,
minutes, or seconds before the EDL-
Net will begin to record.
• Measurement Times: Set the length
of time in days or hours that you wish
to record data. Please note that the
“Duration of Recording” and “Interval
Between Measurements” are dynami-
cally linked. Setting the “Duration of
Recording” will automatically calculate
the “Interval Between Measurements”.
Conversely, setting the “Interval Between Measurements”, will automatically
calculate the “Duration of Recording”.
For example, for a 32K model, if you set the “Duration of Recording” to 365
Days, it will automatically calculate the “Interval Between Measurements” as
16 minutes and 58 seconds. Or, if you set the “Interval Between Measure-
ments” at 10 minutes, it will automatically calculate the “Duration of
Recording” to 215 days and 9 hours.
5 6
