After both sides are retracted, the seat is free to lift out of place. To replace the seat, follow steps 2 - 4
on the front of this installation instruction sheet using the new seat unit.
INSTRUCTIONS FOR REMOVAL AND REPLACEMENT OF THE VANQUISH®SIDE-MOUNT SEAT
Lower both seat and cover
1. 2.
(under view)
a)
b)
(under view)
RETRACTED
(a) the right side is BLUE and the left side is YELLOW.
Hinge rod
release button
found under
hinge assembly
Hinge rod
release button
found under
hinge assembly
C
C
Under each side of the toilet deck,
a) firmly grasp and pinch together the
“flashlight” style buon mechanism.
b) Slide the buons inward to retract
hinge shaft until it secures into the
retracted position and clicks.
C- Hinge Rod
www.mansfieldplumbing.com | 877-850-3060 U.S. Patent No. 9809967
If your toilet seat or cover does not stay standing when lifted:
1. Ensure that your tank is installed properly.
The boom of the tank should be in contact with the top of the bowl. Contact should occur with the sanitary bar evenly and com-
pletely across the front of the tank and also at the center of the back of the tank. If a gap exists between the tank and bowl at either
location, the tank bolts must be tightened down further. Using a 7/16” socket at ¼ turn increments, progressively tighten the bolts until
the tank touches the sanitary bar as described above. DO NOT OVERTIGHTEN or you may fracture the tank. Once you are certain
there is proper contact between the tank and bowl, lift the seat again to check if this adjustment was effective.
TROUBLESHOOTING
If the seat or cover continues to fall when lifted:
2. Adjust the hinge assembly.
a) Follow the instructions above to remove the seat.
b) On both sides of the bowl, remove the nut that secures
the hinge assembly face plate; then remove the plate.
c) Loosen the stainless steel screws
three full turns (two screws per side/
hinge assembly).
d) Shift each hinge assembly forward
and upward until they will move no
further, then retighten the screws.
e) Replace the hinge assembly face
plates, secure the nuts, and reinstall
the seat.
NUT
(under view)
Your seat and cover
should now stand properly.
