MANN LAKE Langstroth User manual
Step One:
Take 1 side and 1 end and put the
ngers together. Make sure your
hand holds are facing up and facing
out.
Slide ngers together
Hand holds facing
up and out
→
→
→
Step Two:
Put a construcon square onto each inside
corner of the box. Put nails into the pre-drilled
area on ngers before nailing the nal side/
end. A box that is not square will not sit proper-
ly on the hive. Once square, pound in your nail.
2 Ends
Nails
What you will need for Assembly:
• 2 Ends
• 2 Sides
• Hammer
• Nails (sold separately)
• Construcon Square
2 Sides
Hammer
Assembling Your Langstroth Hive Body & Super
Place nails into pre-drill area on
ngers and hammer in.
→
→
Rev: 1/14/16 MLL 01-INS
501 1st St S, Hackensack, MN 56452
500 Santa Anita Dr., Woodland, CA 95776
485 Stewart Rd, Wilkes-Barre, PA 18706
1600 Commerce Street, Marshall, TX 75672
Telephone: 800-880-7694
www.mannlakeltd.com
You May Also Consider....
Metal Frame Rest:
Used to protect the wood from damage caused by
scraping and hive tool wear.
Specialty Nails:
These cement and resin coated specialty
nails are specically designed with a small
diameter to reduce spling and cracking
during assembly.
Frames We Oer:
• Assembled Frames with
Rite-Cell® Foundaon
• Unassembled Frames
• Rite-Cell® Pro Frame
• Standard Plasc Frame
Assembled Frames with
Rite-Cell® Foundaon
Perfect for the truly cost
conscious beekeeper!
Standard Plastic Frames
9⅛” = 23.18 cm
6¼” = 15.88 cm
Completed hive body or super
Step Three:
Repeat steps one and two.
*Once assembled you should treat the
outside with a primer and paint.
Other MANN LAKE Farm Equipment manuals
