Manitowoc CNF201A User manual

Part Number 000015432 4/18

Countertop Nugget

Ice Machines

CNF201 & CNF202

Technician’s Handbook

Safety Notices

Read these precautions to prevent personal injury:

• Read this manual thoroughly before operating,

installing or performing maintenance on the

equipment. Failure to follow instructions in this

manual can cause property damage, injury or death.

• Routine adjustments and maintenance procedures

outlined in this manual are not covered by the

warranty.

• Proper installation, care and maintenance are essential

for maximum performance and trouble-free operation

of your equipment.

• Visit our website www.manitowocice.com for manual

updates, translations, or contact information for

service agents in your area.

• This equipment contains high voltage electricity and

refrigerant charge. Installation and repairs are to be

performed by properly trained technicians aware of

the dangers of dealing with high voltage electricity

and refrigerant under pressure. The technician

must also be certified in proper refrigerant handling

and servicing procedures. All lockout and tag out

procedures must be followed when working on this

equipment.

• This equipment is intended for indoor use only. Do not

install or operate this equipment in outdoor areas.

As you work on this equipment, be sure to pay close

attention to the safety notices in this handbook.

Disregarding the notices may lead to serious injury and/or

damage to the equipment.

nWarning

Follow these electrical requirements during

installation of this equipment.

• All field wiring must conform to all applicable

codes of the authority having jurisdiction. It is

the responsibility of the end user to provide the

disconnect means to satisfy local codes. Refer to

rating plate for proper voltage.

• This appliance must be grounded.

• This equipment must be positioned so that the plug

is accessible unless other means for disconnection

from the power supply (e.g., circuit breaker or

disconnect switch) is provided.

• Check all wiring connections, including factory

terminals, before operation. Connections can

become loose during shipment and installation.

nWarning

Follow these precautions to prevent personal injury

during installation of this equipment:

• Installation must comply with all applicable

equipment fire and health codes with the authority

having jurisdiction.

• To avoid instability the installation area must be

capable of supporting the combined weight of the

equipment and product. Additionally the equipment

must be level side to side and front to back.

• Ice machines require a deflector when installed on

an ice storage bin. Prior to using a non-OEM ice

storage system with this ice machine, contact the

bin manufacturer to assure their ice deflector is

compatible.

• Remove all removable panels before lifting and

installing and use appropriate safety equipment

during installation and servicing. Two or more

people are required to lift or move this appliance to

prevent tipping and/or injury.

• Do not damage the refrigeration circuit when

installing, maintaining or servicing the unit.

• Connect to a potable water supply only.

• This equipment contains refrigerant charge.

• Installation of the line sets must be performed by

a properly trained and EPA certified refrigeration

technician aware of the dangers of dealing with

refrigerant charged equipment.

nWarning

Follow these precautions to prevent personal injury

while operating or maintaining this equipment.

• Legs or casters must be installed and the legs/casters

must be screwed in completely. When casters

are installed the mass of this unit will allow it to

move uncontrolled on an inclined surface. These

units must be tethered/secured to comply with all

applicable codes. Swivel casters must be mounted

on the front and rigid casters must be mounted on

the rear. Lock the front casters after installation is

complete.

• Some 50 Hz models may contain up to 150 grams

of R290 (propane) refrigerant. R290 (propane)

is flammable in concentrations of air between

approximately 2.1% and 9.5% by volume (LEL lower

explosion limit and UEL upper explosion limit). An

ignition source at a temperature higher than 470°C

is needed for a combustion to occur.

• Refer to nameplate to identify the type of refrigerant

in your equipment.

• Only trained and qualified personnel aware of the

dangers are allowed to work on the equipment.

• Read this manual thoroughly before operating,

installing or performing maintenance on the

equipment. Failure to follow instructions in this

manual can cause property damage, injury or death.

• Crush/Pinch Hazard. Keep hands clear of moving

components. Components can move without

warning unless power is disconnected and all

potential energy is removed.

• Moisture collecting on the floor will create a

slippery surface. Clean up any water on the floor

immediately to prevent a slip hazard.

nWarning

Follow these precautions to prevent personal injury

while operating or maintaining this equipment.

• Objects placed or dropped in the bin can affect

human health and safety. Locate and remove any

objects immediately.

• Never use sharp objects or tools to remove ice or

frost.

• Do not use mechanical devices or other means to

accelerate the defrosting process.

• When using cleaning fluids or chemicals, rubber

gloves and eye protection (and/or face shield) must

be worn.

DANGER

Do not operate equipment that has been misused,

abused, neglected, damaged, or altered/modified

from that of original manufactured specifications.

This appliance is not intended for use by persons

(including children) with reduced physical, sensory

or mental capabilities, or lack of experience and

knowledge, unless they have been given supervision

concerning use of the appliance by a person

responsible for their safety. Do not allow children to

play with, clean or maintain this appliance without

proper supervision.

nWarning

Follow these precautions to prevent personal injury

during use and maintenance of this equipment:

• It is the responsibility of the equipment owner to

perform a Personal Protective Equipment Hazard

Assessment to ensure adequate protection during

maintenance procedures.

• Do Not Store Or Use Gasoline Or Other Flammable

Vapors Or Liquids In The Vicinity Of This Or Any

Other

• Appliance. Never use flammable oil soaked cloths or

combustible cleaning solutions for cleaning.

• All covers and access panels must be in place and

properly secured when operating this equipment.

• Risk of fire/shock. All minimum clearances must be

maintained. Do not obstruct vents or openings.

• Failure to disconnect power at the main power

supply disconnect could result in serious injury or

death. The power switch DOES NOT disconnect all

incoming power.

• All utility connections and fixtures must be

maintained in accordance with the authority having

jurisdiction.

• Turn off and lockout all utilities (gas, electric, water)

according to approved practices during maintenance

or servicing.

• Units with two power cords must be plugged

into individual branch circuits. During movement,

cleaning or repair it is necessary to unplug both

power cords.

Table of Contents

Part Number 000015432 4/18 9

General Information

Model Numbers............................... 13

Model/Serial Number Location ............... 13

Manitowoc Cleaner and Sanitizer............. 13

Legs........................................... 14

Touchless Sensing Option .................... 14

Ice Machine Warranty Information............ 14

Installation

Location of Ice Machine....................... 15

Ice Machine Clearance Requirements......... 16

Ice Machine Heat of Rejection ................ 16

Electrical Service.............................. 17

Circuit Ampacity .......................... 17

Ice Machine Head Section Water

SupplyandDrains ............................ 18

Potable Water Supply...................... 18

Potable Water Inlet Lines .................. 18

Drain Connections ........................ 19

Operation ..................................... 21

Ice Making Sequence of Operation ........... 21

CNF201 - CNF202 Nugget Machines........ 21

Touch Pad Sequence of Operation ......... 23

Water Level Check......................... 23

Sequence of Operation Chart ............. 24

10 Part Number 000015432 4/18

Maintenance

Manitowoc’s Cleaning Technology............ 26

Exterior Cleaning .......................... 27

Preventative Maintenance Procedure ........ 28

Heavily Scaled Cleaning Procedure ........... 31

Cleaning Procedure ........................... 33

Sanitizing Procedure.......................... 35

Component Disassembly for Cleaning and

Sanitizing ..................................... 37

General Information ....................... 37

Cleaning the Condenser ................... 51

Removal from Service/Winterization ......... 52

General ................................... 52

Troubleshooting

SafeGuard Feature ............................ 53

SafeGuards ................................... 55

No Water.................................. 55

No Ice Production ......................... 56

Ice Machine Will Not Run Diagnostics......... 58

Refrigeration Diagnostics..................... 64

Before Beginning Service . . . . . . . . . . . . . . . . . . 64

Installation/Visual Inspection Checklist..... 64

Water System Checklist .................... 65

Ice Production/Quality Check .............. 66

Analyzing Discharge Pressure.............. 67

Analyzing Suction Pressure ................ 69

This manual suits for next models

Table of contents

Other Manitowoc Ice Maker manuals

Manitowoc

Manitowoc S series User manual

Manitowoc

Manitowoc KH0177 - IB-0620 User manual

Manitowoc

Manitowoc B Series User manual

Manitowoc

Manitowoc QM30A Owner's manual

Manitowoc

Manitowoc TIMER GSI 200 User manual

Manitowoc

Manitowoc QM20 Series Owner's manual

Manitowoc

Manitowoc I1406 Series Operating and safety instructions

Manitowoc

Manitowoc B200 Series User manual

Manitowoc

Manitowoc FLARE NUT TXV REPLACEMENT (Z100) 7625563 User manual

Manitowoc

Manitowoc NEO UD0140A Installation and operating instructions

Manitowoc

Manitowoc NEO User manual

Manitowoc

Manitowoc QM45 Series Guide

Manitowoc

Manitowoc QM30 Series Operating manual

Manitowoc

Manitowoc G600 Series User manual

Manitowoc

Manitowoc 30" Q-MODEL ICE MACHINES MYLAR STRIP 7600153 User manual

Manitowoc

Manitowoc HR-0200A User manual

Manitowoc

Manitowoc Manitowoc NEO U0140 Series User manual

Manitowoc

Manitowoc UG080A User manual

Manitowoc

Manitowoc ICE MACHINE K00385 User manual

Manitowoc

Manitowoc AUCS-SI K00363 User manual

Manitowoc

Manitowoc QR0670C User manual

Manitowoc

Manitowoc GR-0800A User manual

Manitowoc

Manitowoc FS9000 User manual

Manitowoc

Manitowoc RF0244 User manual

Popular Ice Maker manuals by other brands

Hoshizaki

Hoshizaki KMD-460MWJ instruction manual

Sub-Zero

Sub-Zero 315I Planning information

Unold

Unold 48945 Instructions for use

Kenmore

Kenmore 2217402A Use & care guide

Cornelius

Cornelius WM600 Installation & owner's manual

GE XPIO43SCSS owner's manual

Hoshizaki

Hoshizaki KMD-901MAH Specifications

Whynter

Whynter FIM-450HA instruction manual

U-Line

U-Line UMCR014-SC01A User guide & service manual

Andrew James

Andrew James AJ000522 manual

Scotsman

Scotsman CME1356 user guide

Scotsman

Scotsman ACM 25 Service manual

Kärcher

Kärcher IP 120 manual

U-Line

U-Line SS1095 Quick referenc guide

Maytag

Maytag MIM1554WRS - Ice Maker User instructions

Hoshizaki

Hoshizaki KM-630MAH instruction manual

Princess

Princess Yonanas user manual

Unold

Unold 48946 Instructions for use