Makita ML900 User manual
Rechargeable Flashlight
Power source Bulb Switch
Makita battery cartridge
9000
9
6
V Rocker type
(rechargeable Nc-cdl
500
mA
ON-OFF
MODEL
ML900
Dimensions Net weight
0
84
mm
x
273
mm
(0
3-114"
x
10
314")
IO
6
Ibsl
260
g
INSTRUCTION MANUAL
Installing
or
removingbattery cartridge
NOTE
:
Before operation, charge the battery cartridge with Makita
9.6V
Fast
charger.
To
insert the battery cartridge, pull
out the
set
plate, align the tongue
on the battery cartridge with the
groove in the flashlight handle and
slip it into place. Snap the set plate
back into place. Be sure to close the
set
plate fully before using the flash-
light.
Switch
action
To
turn the flashlight on, press the
"ON" side of the switch.
Press the
"OFF"
side to turn
it
off.
Condensina or disDersina liaht
-
--
To
cast
a
wide beam, turn the knob
so
that the pointer points to the
For
a
narrow spotlight beam, turn
the knob
so
that the pointer points
to the
=w
marking.
marking.
Stand
The stand allows the flashlight to
be positioned
at
a
convenient up-
ward angle.
2
MAINTENANCE
CAUTION
:
Always
be sure
that
the
flashlight
is
switched off and the battery cartridge
is
removed before attempting to perform inspection or maintenance.
Replacing
light
bulb
I
Turn the ring counterclockwise and
remove the ring, reflector and bulb
together. Pull the bulb holder out
of the reflector. Pull the bulb out
of
the bulb holder after turning the
bulb slightly clockwise.
To install
a
new bulb, follow the re-
moval procedure in reverse. There
are three notches in the bulb holder.
Set the bulb in the center notch.
Bulb
holder
rr
Set
the
bulb
here.
CAUTION
:
0
Replacement light bulbs are readily available from your Makita dealers,
or Makita Authorized or Factory Service Centers. Always specify bulb
type
(9.6
V,
500
mA).
*Never attempt to short the bulb
I
I
3
Cleaning
Use
a
cloth dampened in
a
mild detergent to clean off the flashlight from
time to time. Then wipe dry with
a
dry cloth. Benzine, thinner and other
volatile agents will damage the plastic,
so
never use them.
To
maintain product SAFETY and RELIABILITY, repairs, maintenance
and adjustment should be perfomed
by
Makita Authorized or Factory
Service Centers, always using Makita replacement parts.
OPTIONAL ACCESSORIES
The accessories listed in this manual are available at an extra cost from your
Makita Distributor or Makita Factory Service Center. Service centers are listed
on the warranty card packedwith your tool.
Signalcap
Strap
Lanyardset
Recycling the battery
The only way
to
dispose of a Makitabatteryis to recycleit.
The law prohibitsany other method of disposal.
To
recyclethe battery:
1.
Remove the batteryfrom the tool.
2.
(a) Takethe batteryto your nearest Makita Factory
Service Center.
@
Ni-Cd
or
I
(b) Takethe batteryto your nearest MakitaAuthorized
Service Center or Distributorthat has been designated as a Makita
battery recyclinglocation.
Callyour nearestMakitaServiceCenter or Distributor to determine
thelocationthatprovidesMakitabattery recycling.Seeyour local
yellow pages under ‘Tools
-
Electric.
”
Makita Corporation
of
America
Buford,
GA
MCA-4193 883565CO67
PRINTED IN
USA
1995-8-4D
Table of contents
Other Makita Flashlight manuals
Makita
Makita ML106 User manual
Makita
Makita DEADML186 User manual
Makita
Makita DML815 User manual
Makita
Makita ML180 Quick start guide
Makita
Makita BML145 User manual
Makita
Makita DML807 User manual
Makita
Makita ML705 User manual
Makita
Makita DEADML802 User manual
Makita
Makita ML180 Quick start guide
Makita
Makita DML801 User manual
Makita
Makita ML120 User manual
Makita
Makita BML184 User manual
Makita
Makita ML120 Quick start guide
Makita
Makita Adventure ADML812 User manual
Makita
Makita BML803 User manual
Makita
Makita LXLM03 User manual
Makita
Makita BML185 Quick start guide
Makita
Makita DEBDML801X User manual
Makita
Makita DML802 User manual
Makita
Makita DML185 User manual
