MacDon R113 User manual
R113/R116 Rotary Disc Pull-Type Mower Conditioner Quick Card MD #147624
Supplement to R113/R116 Operator’s Manual.
R113/R116 Quick Card
Subject to change without notice.
Use this card as a guide only. Refer to your Operator’s Manual
for detailed settings and adjustment procedures.
Short Stubble/Smooth Ground: Upper position (A).
High Stubble/Rocks/Cane: Lower position (B).
Skid Shoes
Header Angle
Smooth/Level/Firm Ground: Steep angle (B).
Rocks/Ridges/Loose Ground: Shallow angle (A).
Increase Conditioning:
Move lever forward (A).
Decrease Conditioning:
Move lever aft (B).
Increase Conditioning:
Loosen (A), turn (B) CW, tighten (A).
Decrease Conditioning:
Loosen (A), turn (B) CCW, tighten (A).
Roll Gap
Light Crop/Dry Grass:
900 rpm – factory set.
Sensitive Crop (new/thin alfalfa, thin grass):
600 rpm – swap pulleys (A) and (B).
Light Crops—Less Tension:
Loosen (A), turn (B) to increase (C), tighten (A).
Heavy/Tough Crops—More Tension:
Loosen (A), turn (B) to decrease (C), tighten (A).
Roll Tension Finger Rotor RPM
Finger Clearance
C on d iti o ni n g
C u t ti n g H e i g h t
R113/R116 Rotary Disc Pull-Type Mower Conditioner Quick Card MD #147624
Supplement to R113/R116 Operator’s Manual
R113/R116 Quick Card Subject to change without notice.
Use this card as a guide only. Refer to your Operator’s Manual
for detailed settings and adjustment procedures.
(A) Wide: Deflectors outboard.
(B) Narrow: Deflectors inboard.
Roll Cond: Move bar (C).
Finger Cond: Move handle (D).
Wide (A): Lower baffle (C)
Narrow (B): Raise Baffle (C)
Finger Baffle Roll Baffle
Smooth/Level/Firm Ground:
10 mph (16 kph) and higher until cutting and conditioning quality
are compromised.
Rocks/Ridges/Loose Ground:
Slow to minimize bouncing, uneven stubble and damage to cutter
bar.
G r ou n d S p e e d
(A) acres/hr, (B) hectares/hr, (C) kph, (D) mph, (E) 16 ft., (F) 13 ft.
Refer to Operator’s Manual.
Switch at (A). Light (C) On.
Tr a ns p or t
Field Mode
Switch at (A). Light (C) Off.
Transport Mode
1000 PTO rpm
800 PTO rpm
Light/Thin Crop Heavy/Tough Crop
D i s c S p e e d
1. Loosen (C).
2. Turn (D) CW.
3. Tighten (C).
1. Loosen (C).
2. Turn (D) CCW.
3. Tighten (C).
Rocks/Ridges/
Loose Ground (100 lb)
Smooth/Level/
Firm Ground (125–150 lb)
F lo at
Tips:
• Sharp blades reduce horse power requirements.
• Install cutterbar filler plates in tall, stemmy crops.
• Remove rear filler plate to reduce dirt accumulation in cutterbar.
Side Deflectors
Wi n dr o w
Other manuals for R113
11
This manual suits for next models
1
Other MacDon Farm Equipment manuals
MacDon
MacDon M105 User manual
MacDon
MacDon M155 User manual
MacDon
MacDon M155 User manual
MacDon
MacDon A40-D User manual
MacDon
MacDon A30-S User manual
MacDon
MacDon M Series User manual
MacDon
MacDon M105 User manual
MacDon
MacDon D1 Series User manual
MacDon
MacDon PW8 User manual
MacDon
MacDon R116 User manual
MacDon
MacDon R116 User manual
MacDon
MacDon PW8 User manual
MacDon
MacDon HC10 Guide
MacDon
MacDon M150 2008 User manual
MacDon
MacDon FlexDraper FD1 Series User manual
MacDon
MacDon CA20 User manual
MacDon
MacDon M105 User manual
MacDon
MacDon M1170NT5 User manual
MacDon
MacDon 625 User manual
MacDon
MacDon A40-D User manual
