Lucent Technologies 905 User manual

Doc. No. 503-802-100
Comcode 108339078
Issue 2 August 1998
Business Cordless 905 Telephone
User’s Guide

Copyright, trademarks, & legal
905 Telephone User’s Guide
503-802-100 (Issue 2 August 1998)
Copyright 1998, Lucent Technologies. All Rights Reserved. Printed in U.S.A.
PARTNER, PARTNER II, MERLIN, MERLIN LEGEND, and MLS-12D are
registered trademarks of Lucent Technologies, and PARTNER Endeavor™ is a
trademark of Lucent Technologies.
Every effort has been made to ensure that the information in this book is
complete and accurate at the time of printing. However, information is subject to
change.
Warranty Lucent Technologies provides a limited warranty on this
product.
Federal
Communications
Commission
Statement
The Lucent Technologies Business Cordless 905 telephone
has been tested and has been found to comply with
FCC
Part 15 Rules
. It is identified by FCC registration number
AS5LT905A. These specifications are designed to provide
reasonable protection against harmful interference in a
commercial or residential environment. This telephone
generates, uses, and can radiate radio-frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If the
telephone does cause harmful interference with radio or
television reception, which can be determined by turning the
telephone off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Where it can be done safely, reorient the receiving
radio or television antenna.
• To the extent possible, relocate the television, radio, or
other receiver with respect to the telephone.
• Plug the telephone into an electrical outlet that is not on
the same circuit as one used by the radio or television.

905 Telephone User’s Guide
503-802-100 (Issue 2 August 1998)
Industry Canada
Statement This device complies with RSS-210 of Industry Canada.
Operation is subject to the following two conditions:
• This device may not cause interference.
• This device must accept any interference including
interference that may cause undesirable operation of
the device.
The user is cautioned that modifications to this telephone,
not expressly approved by Lucent Technologies, could void
the user’s authority to operate the equipment.
Toll Fraud Toll fraud is the unauthorized use of your
telecommunications system by an unauthorized party, for
example, persons other than your company’s employees,
agents, subcontractors, or persons working on your
company’s behalf. Note that there may be a risk of toll fraud
associated with your telecommunications system and, if toll
fraud occurs, it can result in substantial additional charges
for your telecommunications services.
You and your system manager are responsible for the
security of your system, such as programming and
configuring your equipment to prevent unauthorized use.
The system manager is also responsible for reading all
installation, instruction, and system administration
documents provided with this product in order to fully
understand the features that can introduce risk of toll fraud
and the steps that can be taken to reduce that risk. Lucent
Technologies does not warrant that this product is immune
from or will prevent unauthorized use of common-carrier
telecommunication services or facilities accessed through or
connected to it. Lucent Technologies will not be responsible
for any charges that result from such unauthorized use.
If you suspect that you are being victimized by toll fraud and
you need technical support or assistance, call the Technical
Service Center Toll Fraud Intervention Hotline at
1-800- 643-2353.

905 Telephone User’s Guide
503-802-100 (Issue 2 August 1998)
Ordering
Information To order parts for the Business Cordless 905 telephone, see
Appendix A. To order a copy of this document, request:
Document No. 503-802-100
Comcode 108339078
Issue 2, August 1998
You can order documentation by mail, telephone, or fax.
Mailing address
Lucent Technologies BCS Publications Center
2885 North Franklin Road
Indianapolis, IN 46219
USA
Telephone numbers
1-800-457-1235 (US)
317-322-6791 (International)
Fax numbers
1-800-457-1764 (US)
317-322-6699 (International)
Standing orders
You can be placed on a standing order list for this and other
documents you may need. Standing orders will enable you
to automatically receive updated versions of individual
documents or document sets, billed to account information
that you provide. For more information on standing orders, or
to be put on a list to receive future issues of this document,
contact the Lucent Technologies BCS Publications Center.
Acknowledgment This document was prepared by Product Publications,
Business Communications Systems, Lucent Technologies,
Basking Ridge, NJ, USA.

Contents
905 Telephone User’s Guide
503-802-100 (Issue 2 August 1998) i
1 Introduction....................................................................1
Business Cordless 905 Telephone.................................................... 1
Package Contents............................................................................. 2
Compatible Systems......................................................................... 3
2 About the Controls ........................................................5
Base Unit Controls............................................................................ 5
Handset Controls .............................................................................. 7
3 Installing the Telephone..............................................13
Table Installation ............................................................................. 13
Wall Installation............................................................................... 17
Attaching the Belt Clip..................................................................... 23
About Registration........................................................................... 23
4 Telephone Compatibility .............................................25
PARTNER Systems......................................................................... 26
MERLIN Systems............................................................................ 29
5 Using the Telephone....................................................31
General Telephone Operation......................................................... 31
Programming the Telephone........................................................... 34
6 Maintenance.................................................................35
About the Batteries ......................................................................... 35
Resetting the Registration Code..................................................... 37
7 Troubleshooting...........................................................39
About Troubleshooting .................................................................... 39
About the Operating Range ............................................................ 44
A Ordering Information ..................................................45

905 Telephone User’s Guide
503-802-100 (Issue 2 August 1
1 Introduction
This chapter provides a brief description of the Business Cordless 905
telephone, lists the contents of the telephone package, and identifies the Lucent
communications systems with which the 905 telephone is compatible.
Business Cordless 905 Telephone
The Business Cordless 905 telephone is a 900 MHz cordless telephone, with a
handset LCD display, intended for use in a small or home office. Its multi-line
operation provides up to three outside lines on which you are able to make,
receive, transfer, and hold calls. The Business Cordless 905 telephone is
designed to be used with a variety of PARTNER® and MERLIN®
Communications Systems, allowing you access to features available on those
systems. See "Compatible Systems" later in this chapter for a list.

Package Contents
1. Introduction
905 Telephone User’s Guide
503-802-100 (Issue 2 August 1998) 2
Package Contents
The Business Cordless 905 package includes the following items:
• Base unit
• Separate 110V AC power adapter with 7.5-foot power cord
• Cordless handset
• NiCad rechargeable handset battery
• Two telephone line cords with modular connectors:
– One cord is for MERLIN Communications Systems and has a
4-conductor, 8-pin plug on one end and a 6-pin plug on the other end.
It is a 7-foot long cord with an orange label that states,
"Use this cord
only if you are connecting to a MERLIN Communications System."
– One cord is for PARTNER Communications Systems and is a
4-conductor, 7-foot long cord. This cord is not labeled.
• User’s Guide
• Stick-on directory card
• Inline adapter
– Used to extend the 7-foot telephone line cord (MERLIN
Communications Systems
only
)
• Wall mounting screws

Compatible Systems
1. Introduction
3
905 Telephone User’s Guide
503-802-100 (Issue 2 August 1998)
Compatible Systems
The Business Cordless 905 telephone is compatible with the following Lucent
communications systems.
PARTNER MERLIN
PARTNER 206 MERLIN 206
PARTNER Plus MERLIN 410
PARTNER II®MERLIN 820
PARTNER ACS MERLIN Plus
PARTNER
Endeavor™ MERLIN 1030/3070
MERLIN II
MERLIN LEGEND®

905 Telephone User’s Guide
503-802-100 (Issue 2 August 1998) 5
2 About the Controls
This chapter describes the controls, buttons, and lights on the Business Cordless
905 base unit and handset.
Base Unit Controls
A description of the lights, button, and antenna on the base unit follow the
illustration.
Base Unit Controls
Charging/Handset in Use Light Page/Handset Locator Button
Antenna Message Light Spare Battery Charging Light

Base Unit Controls
2. About the Controls
905 Telephone User’s Guide
503-802-100 (Issue 2 August 1998) 6
1 Antenna When the handset is removed from the base unit, this
antenna should be fully upright so that you can make and
receive all calls with a clear, strong reception.
2 MESSAGE
Light This light is on if you have messages waiting.
3 SPARE BATT
CHARGING
Light
This light is on when the spare battery is charging. A spare
battery charger is built into the base unit and ensures that a
charged battery is always available should the handset
battery charge become low.
4 CHARGING/
HANDSET IN
USE Light
If the handset is in the base and this light is on, the handset
battery is successfully charging.
If the handset is not in the base and this light is on, the
handset is on. (This does not mean that there is a call on the
handset, but just that the handset is turned on.)
5 PAGE/
HANDSET
LOCATOR
Button
The Page feature allows you to signal someone at the
handset from the base. See "Using the Page Feature" in
Chapter 5 for more information.
The Handset Locator feature is useful if you misplace the
handset. See "Using the Handset Locator Feature" in
Chapter 5 for more information.
Table of contents
Other Lucent Technologies Cordless Telephone manuals

Lucent Technologies
Lucent Technologies 9200 User manual

Lucent Technologies
Lucent Technologies DEFINITY 9601 User manual

Lucent Technologies
Lucent Technologies MDW 9031 User manual

Lucent Technologies
Lucent Technologies MDW 9031 User manual

Lucent Technologies
Lucent Technologies TransTalk 9000 User manual

Lucent Technologies
Lucent Technologies MDW 9031DCP Quick start guide

Lucent Technologies
Lucent Technologies TransTalk 9000 Quick start guide

Lucent Technologies
Lucent Technologies DEFINITY 9601 User manual

Lucent Technologies
Lucent Technologies MDW 9031 User manual

Lucent Technologies
Lucent Technologies 4336 User manual





















