Rev: 06.12.18 Page 2 CCD-0001410
System Information
The Lippert Component, Inc. Road Armor™features a new stamped steel design, integrating both time-
proven natural rubber inserts and oil impregnated bushings for smoother travel. The Road Armor was
designed as a “drop-in” replacement for a standard equalizer setup, which means there is no drilling or
welding needed for installation.
Safety Information
The load rating is 3,500 pounds to 8,000 pounds for the Road Armor Triple Axle Equalizers.
Incorrect raising or lowering of the trailer could result in death, serious injury, and or damage to the trailer.
Make sure the trailer is properly supported before performing any trailer work. Follow the trailer manufacturer's
recommendations for lifting and supporting the trailer. Use proper personal protective equipment.
• 1 to 2 Persons, Depending on
Task
• Pneumatic Air or Impact Gun
• Torque Wrench
• Cordless or Electric Drill or
Screw Gun
• Appropriate Drive Bits
• Hammer
• Vice to Hold Correct Track Cam
Plate to Install Bolts (Optional)
• ⁄" Deep Well Socket
• ¾" Deep Well Socket
• ⁄" Deep Well Socket
• Steel Tube to Install Bolts with
Grease Fittings
• Appropriately-sized and rated
bolts and fasteners
TABLE OF CONTENTS
System Information 2
Triple Axle Equalizer Options 2
Safety Information 2
Resources Required 2
Installation 3
Rear Equalizer (Between 2nd and 3rd Axles) 3
Front Equalizer (Between 1st and 2nd Axles) 4
Final Component Installation 5
Optional Wheel Installation 5
Triple Axle Equalizer Options
Two Road Armor Triple Axle Equalizers are available, including long arm and short arm versions, with
utilization dependent on axle spacing. Trailers that measure 35” from the center of the first wheel to the
center of the second wheel will use the 9.54” long arm version. Trailers that measure 33" between the center
of the first wheel to the center of the second wheel will use the 8.67” short arm version.
Resources Required
