Lincat Silverlink 600 Manual

IS401 – ECN3553

User, Installation and Servicing Instructions

Silverlink 600 Electric Chargrills

ECG6, ECG9, ECG9/WT

IS401 – ECN3553 2

IMPORTANT

PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE USING THE EQUIPMENT.

KEEP THEM IN A SAFE PLACE FOR FUTURE REFERENCE.

WARNING:

APPLIANCES MUST BE EARTHED

ISOLATE THE POWER SUPPLY BEFORE CARRYING OUT ANY INSTALLATION WORK

PARTS OF APPLIANCES BECOME HOT DURING NORMAL USE. CARE SHOULD BE

TAKEN TO AVOID ACCIDENTAL BURNS

IMPORTANT

All Lincat electrical appliances must be installed, operated and serviced by a competent person. Users

should take care to adopt safe working practices when operating or cleaning appliances. Please contact

your local distributor for further advice.

INSTALLATION

1. Ensure that the electricity supply is adequate for the equipment being installed.

2. Partitions, walls, kitchen furniture and other materials less than 100mm from the appliance should

be made from non-combustible material.

3. Remove all protective plastic coating from the unit.

4. When siting the equipment, make sure that it is level and that there is a free flow of air around the

unit and that any vents to the rear are not blocked.

5. All appliances with an electric load of 3kW and below are fitted with a BS1363 fused plug and

should be connected to an earthed socket.

6. Appliances above 3kW must be connected to the supply by a qualified electrician and should be

installed with a means of isolation with contact separation of at least 3mm on all poles.

7. Appliances must be installed in accordance with the Health and Safety at Work Act, IEE Wiring

Regulations, BS Codes of Practice, Local and National Building Regulations and Fire Precautions

Act 1971.

8. When fitting countertop units onto SLS stands or latest CC pedestals, the feet should be located into

the corresponding holes in the base units. When fitting onto Ovens, HC pedestals or similar closed

bases, the feet can be removed if required.

GENERAL USE

Unless otherwise stated in the equipment instructions the following convention applies where indicator

lights are fitted to appliances:-

Green on - power to the unit.

Amber on - power to the element.

IS401 – ECN3553 3

USER MAINTENANCE

1. Before working on or cleaning the equipment, isolate it from the power supply and allow it to

cool to a safe working temperature.

2. Clean units regularly with hot water and detergent, do not use abrasive or chlorine based cleaners

on stainless steel. Take care to avoid wetting electrical components. Do not use a water jet.

3. For removing carbon deposits from fryers and griddles use "Carb'n'Off" or a similar

proprietary cleaner.

ELECTRIC CHARGRILL

ECG6, ECG9 & ECG9/WT

WARNING

! Always drain food before cooking.

! Do not allow the tank to run out of water, check regularly.

! Disconnect the unit from the electricity supply before servicing or undertaking any electrical

maintenance.

! Parts of this unit may become hot in normal use, therefore suitable precautions must be taken to

avoid accidental contact.

! Never leave the unit unsupervised whilst cooking.

! In the event of a fire occurring, water should not be used to extinguish it. It is advisable to install

a fire extinguisher and have a fire blanket within reach of the chargrill.

! Always use the unit under a fume extraction unit.

OPERATION

1Before first using the chargrill and with it disconnected from the mains, clean the tank, element and

cooking grids with hot water and a little mild detergent. To gain clear access to the tank, first lift off

the splashguard and cast cooking grids (take care not to drag the castings over the element, as this

will shorten the element life). Once the parts are removed, lift the element up until the element stay

latches in uppermost position.

2Clean out the tank and ensure that all parts are completely dry and then push the element back

allowing the element stay to be pulled out, and then gently lower the element into its working

position.

3Place the octagonal water level indicator onto one of element cross supports in a visible position.

4Replace the surround and cast cooking grids. If the unit is not to be used immediately lightly coat

the cooking grids in cooking oil.

5Ensure that the drain valve is closed before adding water via the integral funnel on the rear left hand

corner up to the top level on the level indicator

6Inlet water connected units use the mains water supply control valve/tap on left of control panel.

Water will be dispensed from the inlet on the rear wall of the tank.

7Set the power control to the OFF position and switch on the power supply.

8Turn the power control to the desired temperature setting.

9Allow 15 minutes for the unit to warm up.

IS401 – ECN3553 4

CLEANING

To clean the unit after use, allow the water to cool to a temperature below 55

C and drain it into a suitable

container. Raise the element from the tank following the instructions in section 1. After cleaning, lower the

element, replace the surround and cooking grids and refill the tank.

TROUBLESHOOTING

If the green neon is illuminated but the elements do not heat up, the high temperature cut-out may require

resetting. This is located on the back panel of the unit and is reset by pressing the exposed button.

Note ECG9/WT resets are located on the control panel.

SERVICE INFORMATION

Catering equipment should be routinely serviced to ensure a long and trouble free life. With this in mind, it

is recommended that appliances are serviced every six months by a competent engineer.

For help regarding the installation, maintenance and use of your Lincat equipment, please call:-

LINCAT SERVICE HELP DESK



01522 875520

AUTHORISED SERVICE AGENTS

We recommend that all servicing, other than routine cleaning, is carried out by our authorised service

agents and will accept no responsibility for work carried out by other persons. Note that for safe and

efficient operation, appliances need regular servicing.

Please quote both the model and serial numbers from the data plate attached to the unit. Give brief details

of the service requirement.

Lincat reserve the right to carry out any work under warranty during normal working hours, i.e. Monday to

Friday, 8.30 a.m. - 5.00 p.m.

CONDITIONS OF GUARANTEE

The guarantee does not cover: -

1. Accidental breakage or damage

2. Operational misuse, wear and tear from normal usage, incorrect adjustment and neglect.

3. Incorrect installation, maintenance, modification or unauthorised service work.

Other manuals for Silverlink 600

Table of contents

Other Lincat Grill manuals

Lincat

Lincat Opus 700 Series User manual

Lincat

Lincat OG7302 Troubleshooting guide

Lincat

Lincat Opus 700 Series Operating instructions

Lincat

Lincat Silverlink 600 Operating instructions

Lincat

Lincat Lynx 400 Operating instructions

Lincat

Lincat OE8306 Owner's manual

Lincat

Lincat Q2PLGR User manual

Lincat

Lincat Silverlink 600 Series Manual

Lincat

Lincat Phoenix Salamander PHEAS01 Owner's manual

Lincat

Lincat OG7401 User manual

Lincat

Lincat Silverlink 600 Manual

Lincat

Lincat Lynx 400 Operating instructions

Lincat

Lincat LCG Operating instructions

Lincat

Lincat Opus 700 Salamander OE7304 Owner's manual

Lincat

Lincat OE8405 Owner's manual

Lincat

Lincat Opus 800 Salamander OG8301 User guide

Lincat

Lincat Silverlink 600 ECG6 Owner's manual

Lincat

Lincat Lynx 400 LSC Guide

Lincat

Lincat Opus 800 OE8413 Owner's manual

Lincat

Lincat Silverlink 600 CG4 Manual

Lincat

Lincat Opus 800 OG8410-A001 User manual

Lincat

Lincat OE7011 Manual

Lincat

Lincat OG7402 User manual

Lincat

Lincat Silverlink 600 GR3 Owner's manual

Popular Grill manuals by other brands

Orbegozo

Orbegozo GR 2300 instruction manual

bora

bora PT11 Operating and installation instructions

Klarstein

Klarstein 10031664 manual

Garland

Garland MWE3W Installation and operation manual

Char-Broil

Char-Broil 463722714 Product guide

Nexgrill

Nexgrill 720-0830HK Operating instruction

Kenmore

Kenmore 415.16123800 Use and care guide

Camp Chef

Camp Chef PG24CLAU Warning & instruction booklet

Tucker Barbecues

Tucker Barbecues GTR Series Assembly, installation and operating instructions

Monogram

Monogram ZGG540NCP1SS owner's manual

Equipex

Equipex Sodir Savoy Operation manual

Gaggenau

Gaggenau VR 414 610 use and care manual

Miele

Miele KM 408-1 operating instructions

George Foreman

George Foreman GGR50B owner's manual

AOG

AOG T series quick start guide

Gorenje

Gorenje TG2000CB Instruction manua

Weber

Weber Genesis Silver-B Permamount NG 051701 owner's guide

Glen

Glen SA 3037 user guide