Lightware DVI-OPT-RX220-Pro User manual

www.lightware.eu Firmware version: 1.1.1

For technical support contact support@lightware.eu Document revision: 1.1

DVI-OPT-RX220-Pro

Quick Start Guide

Installation

1. Connect the DVI display devices to the DVI OUTPUT connectors.

2. Connect a compatible Lightware fiber transmitter unit with a multimode fiber cable to the

FIBER INPUT connector. Connect an LC optical cable to the “channel B” LC connector, or

use a Neutrik OpticalCON cable.

3. Power on the fiber transmitter, and the DVI source (computer).

4a. To use the built-in power supply: set the power selector switch to “I”, and connect the IEC

power cable. Now the unit is ready to be used.

4b.To power the unit remotely: works only if the receiver is connected to a

DVI-OPT-TX220-PRO with a Neutrik hybrid fiber cable. Set the power selector switch to “II”.

5. Power on the connected display devices. They will display the picture from the DVI source

(computer).

Power LED

Lights if the unit is powered on.

Laser LED

Green light indicates that the laser is properly detected on

the optical input. Red blinking light indicates low laser level,

or no incoming signal.

Signal LED

Indicates valid DVI clock signal reception.

Monitor LEDs

Each LED indicates if a display device is connected to the

corresponding DVI output.

AC connector

Standard IEC power connector.

Break-out conn.

The break-out LC connector is internally connected to output

A of the Neutrik connector.

Neutrik connector

Channel B carries the signal to this unit’s optical receiver,

and channel A carries any optical signal to the break-out LC

connector.

Serial port

The device is controllable by Lightware Matrix Control

software via RS-232 connection.

Power selector

In position “I” the receiver unit is powered by its own built-in

power supply. In position “II” the receiver unit is powered

through special hybrid fiber cable, type’Neutrik 2M-4S75’.

DVI outputs

Two display devices can be connected. The resolution and

pixel clock frequency are the same on both DVI connectors.

Alarm outputs

DVI signal detection and laser detection signals with ground

reference are available on a three-pole Phoenix connector.

Power LED

Laser LED

Signal LED

Monitor LEDs

Power selector

AC connector

Neutrik connector

Serial port

Break-out connector

Alarm outputs

DVI outputs

Other Lightware Extender manuals

Lightware

Lightware HDBaseT HDMI-TPS-RX110AY User manual

Lightware

Lightware DVI-OPT-TX220-ST-Pro User manual

Lightware

Lightware EDID MANAGER V4 User manual

Lightware

Lightware UMX-TPS-TX120 User manual

Lightware

Lightware DP-OPT-TX150 User manual

Lightware

Lightware UBEX-PRO20-HDMI-F110 User manual

Lightware

Lightware DP-OPT-TX100 User manual

Lightware

Lightware HDMI20-OPTC-TX220-Pro User manual

Lightware

Lightware Modex-Tx User manual

Lightware

Lightware HDMI20-OPTC-TX220-Pro User manual

Lightware

Lightware VINX-110-HDMI-DEC User manual

Lightware

Lightware UBEX Series User manual

Lightware

Lightware UBEX-PRO20-HDMI-F100 User manual

Lightware

Lightware HDMI-TPS-TX95 User manual

Lightware

Lightware MODEX-OPTS-TX User manual

Lightware

Lightware FP-HDMI-TPS-RX97-GB3 User manual

Lightware

Lightware HDMI-3D-OPT-TX210RAK User manual

Lightware

Lightware MODEX User manual

Lightware

Lightware MODEX-F15-OPTS-TX User manual

Lightware

Lightware FP-HDMI-TPS-97-GB3 User manual

Lightware

Lightware UMX-OPT-TX150R User manual

Lightware

Lightware HDMI-TPS-TX97 User manual

Lightware

Lightware VINX-120-HDMI-ENC User manual

Lightware

Lightware HDMI-TPS-TX95 User manual

Popular Extender manuals by other brands

SY HDBT-60T installation guide

Appsys ProAudio

Appsys ProAudio ADX-16 user manual

Atlona

Atlona RS232 user manual

IDK

IDK OPF-TH1000-A user guide

Enable-IT

Enable-IT 824WP quick start guide

Worx

Worx Landroid RadioLink WA0864 Get started

TP-Link

TP-Link TL-WA730RE user guide

Camplex

Camplex CMX-HDMI-SFPL user manual

SC&T

SC&T HE03-4K user manual

Marmitek

Marmitek MegaView70 user manual

Samsung

Samsung SCS-26UC4 user guide

Foxun

Foxun SX-GES24 operating instructions

MuxLab

MuxLab 500771 Operation manual

foxunhd

foxunhd SX-AEX01 operating instructions

TERK Technologies

TERK Technologies LFIRX2 owner's manual

Devolo

Devolo Audio Extender supplementary guide

Edimax

Edimax EW-7438RPn V2 instructions

Shinybow USA

Shinybow USA SB-6335T5 instruction manual