Lightolier 9” PENDALYTE SERIES Instruction Manual

SOCKET

CANOPY ASSEMBLY

BOTTOM PLATE

SPACE NECK

KEYSLOTS

REFLECTOR

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE

This ﬁxture is intended for installation in accordance with the National Electrical Code and local regulations.

To assure full compliance with local codes and regulations, check with your local electrical inspector before

installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.

Retain these instructions for maintenance reference.

INSTRUCTION SHEET NO.

IS:40411

1198 Page 1 of 1

STUD

WIRE NUTS

CROSSBAR

1. Thread STUD into CROSSBAR as shown (ﬁg.1).

2. Using appropriate slots in CROSSBAR, secure

CROSSBAR to OUTLET BOX using OUTLET BOX

SCREWS (provided with OUTLET BOX).

3. While supporting CANOPY ASSEMBLY make

connections: black POWER CORD lead to hot (black)

supply lead; white POWER CORD lead to neutral

(white) supply lead. Green POWER CORD wire is a

ground wire and must be connected to grounding

terminal or ground lead inside OUTLET BOX. Use

WIRE NUTS (local hardware item). Push supply wires

and connections back into OUTLET BOX.

4. Tighten SET SCREW into STRAIN RELIEF BUSHING

to secure POWER CORD.

CAUTION: MAKE CERTAIN WIRES ARE NOT

PINCHED BETWEEN PARTS.

5. Place STUD through hole in CANOPY and thread

ADJUSTING COLLAR onto STUD securing CANOPY

ASSEMBLY against ceiling.

POWERHEAD INSTALLATION:

1. Remove DOOR from POWERHEAD by removing

screw (labled open) in top mounting plate. Pull

door directly away from powerhead.

2. Height Adjustment: To raise ﬁxture, push CABLE

down into HANGER FITTING. If necessary, push

excess POWERCORD down into POWERHEAD.

(Make certain CABLE does not interfere with internal

wiring or components, both POWERCORD and

CABLE may be cut inside POWERHEAD.) To lower

ﬁxture, push down on PLUNGER and allow ﬁxture to

drop to desired height.

3. If necessary, cut excess CABLE from inside

POWERHEAD.

4. Using wire nuts (local hardware item) wire ﬁxture:

Black ﬁxture lead to hot (black) POWERCORD lead;

white ﬁxture lead to neutral (white) POWERCORD

lead. Attach green ground wire from BOTTOM PLATE

to green ground wire from POWERCORD and ballast

(if supplied).

5. Reinstall door and secure in place by tightening SCREW

through TOP MOUNTING PLATE.

6. Install recommended lamp(s).

CAUTION: MAXIMUM WATTAGE AS MARKED ON

FIXTURE MUST NOT BE EXCEEDED.

REFLECTOR INSTALLATION:

1. To secure REFLECTOR to SPACER NECK, position

MOUNTING SCREWS through KEYSLOTS and twist

REFLECTOR counter-clockwise. Secure REFLECTOR

in position by tightening MOUNTING SCREWS.

INSTRUCTION SHEET FOR ASSEMBLY AND INSTALLATION OF 9” PENDALYTE™SERIES

MOUNTING SCREW

CABLE

PLUNGER

HANGER

FITTING POWERHEAD

OUTLET BOX

SET SCREW

COLLAR

DOOR

POWERCORD

SCREW

TOP MOUNTING

PLATE

STRAIN RELIEF

BRUSHING

LIGHTOLIER a GENLYTE THOMAS company.

631 Airport Road, Fall River, MA 02720

OUTLET BOX SCREW

CABLE

FIG. 1

This manual suits for next models

Table of contents

Other Lightolier Light Fixture manuals

Lightolier

Lightolier Surfside User manual

Lightolier

Lightolier Calculite 7065AZ User manual

Lightolier

Lightolier SL103A User manual

Lightolier

Lightolier QVS2GSDOS2FT User manual

Lightolier

Lightolier JS Series User manual

Lightolier

Lightolier Lytespan 8640WH User manual

Lightolier

Lightolier Calculite C4MRD CCDW User manual

Lightolier

Lightolier B16 series User manual

Lightolier

Lightolier D02 User manual

Lightolier

Lightolier ProSpec PA1A1175 User manual

Lightolier

Lightolier Lytespan 8266 User manual

Lightolier

Lightolier Calculite CS7142 User manual

Lightolier

Lightolier Silhouette T5 User manual

Lightolier

Lightolier Paraplus II PPH2G12FW228 User manual

Lightolier

Lightolier QVS2GPFLV332 User manual

Lightolier

Lightolier Lytecaster 1102T User manual

Lightolier

Lightolier Calculite C4P20L User manual

Lightolier

Lightolier Calculite ProSpec PB3A7050 User manual

Lightolier

Lightolier Paraplus II PPH2G8FW2FT User manual

Lightolier

Lightolier 4X4 MATRIX SERIES Instructions for use

Lightolier

Lightolier SL203A User manual

Lightolier

Lightolier Calculite V7009 User manual

Lightolier

Lightolier Lytespan 8420 User manual

Lightolier

Lightolier Lytecaster 1195 User manual

Popular Light Fixture manuals by other brands

Emos

Emos CLASSIC ZY1431T manual

Westinghouse

Westinghouse Outdoor Lighting Fixture owner's manual

Hedler

Hedler C 12 silent Operation manual

Blizzard Lighting

Blizzard Lighting Puck: CSI manual 

Energetic Lighting

Energetic Lighting ELYSL-5004 Series installation instructions

Lightmaxx

Lightmaxx Shaft 5R user manual

Triarch

Triarch 31083 Assembly instructions

Philips

Philips 32614 Series user manual

IKEA

IKEA TIVED Assembly instructions

Chauvet Professional

Chauvet Professional ROGUE R1 BEAM WASH user manual

Martin

Martin MAC 250 Krypton user manual

Cooper Lighting

Cooper Lighting Halo L3232E Specification sheet

Stageline

Stageline ODW-2410RGBW instruction manual

Light Sky

Light Sky Tornado Series user manual

ArtFox

ArtFox Beam 15R extreme manual

GLG

GLG multispot 330 user manual

Home Accents Holiday

Home Accents Holiday TY052-1924-1 Assembly instructions

SELF Electronics

SELF Electronics FLEX instruction manual