LG MyView 32SR85U User manual
ENGLISH_index
OWNER’S MANUAL
www.lg.com
Copyright © 2023 LG Electronics Inc. All
Rights Reserved.
The model and serial number of the product are located on the
back and on one side of the product. Record them below in case
you ever need service.
Model
Serial No.
LG MyView
Smart Monitor
Please read this manual carefully before
operating your set and retain it for future
reference.
32SR85U
Supplier's Declaration of Conformity
Trade Name LG
Responsible
Party
LG Electronics USA,
Inc.
Address 111 Sylvan Avenue,
North Building,
Englewood Cliffs,
NJ07632
E-mail lg.environmental@
lge.com
2
Before reading this manual
•Read this manual thoroughly before operating your Monitor, and keep it for future reference.
•On the website you can download the manual including installation, using, troubleshooting, specifications, license etc and view its contents on
your PC or mobile device.
•User Guide: For more information about this Monitor, read the USER GUIDE embedded in the product.
-To open the USER GUIDE → [ ] →[Support] →[User Guide]
Separate Purchase
•Separate purchase items can be changed or modified for quality improvement without any notification. Contact your dealer to buy these items.
These devices only work with certain models.
•Magic Remote Control: MR23GA (MR23GA model can be used in common with some TV products and this LG Smart Monitor)
Check whether your model supports Bluetooth in the Wireless Module Specification to verify whether it can be used with the Magic Remote.
•A cable to connect external devices must be purchased separately.
Note
•Product specifications or contents of this manual may be changed without prior notice due to upgrade of product functions.
•The items supplied with your product may vary depending upon the model.
•The model name or design may be changed depending upon the upgrade of product functions, manufacturer’s circumstances or policies.
•Image shown may differ from your Monitor.
Important Precautions
Please read these safety precautions carefully before using the product. All precautions and safety information applies to LCD models.
•Failure to follow those warnings may result in death, serious injury or damage to the product or other property.
Precautions to the AC Adapter and Electrical Power
•If water or any foreign substance goes inside the product (Monitor, power cord, or AC adapter), disconnect the power cord immediately and
contact the service center.
-Otherwise, this may cause a fire or electric shock due to damage to the product.
•Do not touch the power plug or AC adapter with wet hands. If the pins of the plug are wet or dusty, wipe and dry them before use.
-Otherwise, this may cause a fire or electric shock.
•Make sure to completely insert the power cord into the AC adapter.
-If loosely connected, the poor connection may cause a fire or electric shock.
•Be sure to use power cords and AC adapters provided or approved by LG Electronics, Inc.
-The use of non-approved products may cause a fire or electric shock.
•When unplugging the power cord, always pull it by the plug. Do not bend the power cord with excessive force.
-The power line can be damaged, which may cause electric shock or fire.
•Be careful not to step or place heavy objects (electronic appliances, clothing, etc.) on the power cord or AC adapter. Be careful not to damage the
power cord or AC adapter with sharp objects.
-Damaged power cords may cause a fire or electric shock.
3
•Never disassemble, repair or modify the power cord or AC adapter.
-This may cause a fire or electric shock.
•Use only the power cord supplied with the unit or another manufacturer's authorized cord.
-Failure to do so may result in fire or electrical shock or damage to the product.
•Use only a properly grounded plug and receptacle.
-If you do not you may be electrocuted or injured. Or the product might be damaged.
•Do not use a damaged or loose plug.
-This may cause electrical shock or fire.
•Operate the display only from a power source(i.e. voltage) indicated in the product specification.
-Otherwise the product can be damaged, fire can occur or you may be electrocuted. If you are not sure what type of power supply you have,
consult a certified electrician.
•In the presence of thunder and lightning, never touch the power cord and signal cable because it can be very dangerous.
-It can cause electric shock.
•Do not connect several extension cords, electrical appliances or electrical heaters to a single outlet. Use a power bar with a grounding terminal
designed for exclusive use with the computer.
-A fire can break out due to overheating.
•Do not touch the power plug with wet hands. Additionally, if the cord pin is wet or covered with dust, dry the power plug completely or wipe dust
off before plugging in the cord.
-You may be electrocuted due to excess moisture.
•If you don’t intend to use the product for a long time, unplug the power cable from the product.
-Covering dust can cause a fire, or insulation deterioration can cause electric leakage, electric shock or fire.
•Insert the power plug firm so it cannot come loose.
-A loose connection can cause fire.
•Do not insert metal or other conductive materials into the product openings. Additionally, do not touch the power cable right after plugging into
the wall input terminal.
-You may be electrocuted.
•The AC Plug is the disconnecting device. It should be easily accessible in case of emergency.
•Please make sure the device is installed near the wall outlet to which it is connected and that the outlet is easily accessible.
•Be sure to keep the outlet, AC adapter, and pins of the power plug clean from dust and etc.
-This may cause a fire.
•Do not unplug the power cord while the product is in use.
-Electrical shock can damage the product.
•As long as this unit is connected to the AC wall outlet, it is not disconnected from the AC power source even if the unit is turned off.
Precautions in installing the Product
•Keep away from heat sources like heaters or open flames.
-Electrical shock, fire, malfunction or deformation may occur.
•Keep the packing anti-moisture material or vinyl packing out of the reach of children.
-Anti-moisture material is harmful if swallowed. If swallowed by mistake, force the patient to vomit and visit the nearest hospital. Additionally,
vinyl packing can cause suffocation. Keep it out of the reach of children.
•Do not put heavy objects on the product on sit upon it.
-If the product collapses or is dropped, you may be injured. Children must pay particular attention.
•Do not leave the power or signal cable where someone can trip over it.
-The passerby can falter, which can cause electrical shock, fire, product breakdown or injury.
•Install the product in a neat and dry place. Do not use near water.
-Dust or moisture can cause electrical shock, fire or product damage.
•Do not add accessories that have not been designed for this display.
4
•If you smell smoke or other odors or hear a strange sound from the product unplug the power cord and contact LG Customer Service.
-If you continue to use without taking proper measures, electrical shock or fire can occur.
•If you dropped the product or the case is broken, turn off the product and unplug the power cord.
-If you continue to use without taking proper measures, electrical shock or fire can occur. Contact LG Customer Service.
•Do not drop an object on or apply impact to the product. Do not throw any toys or objects at the product.
-It can cause injury to humans, problems to the product and damage the display.
•Keep out of reach of children and do not place toys near the product.
•Make sure the product ventilation hole is not blocked. Install the product more than 10cm (3.9 inches) from the wall.
-If you install the product too close to the wall, it may be deformed or fire can break out due to internal heat build-up.
•Do not cover the product with cloth or other material (eg. plastic) while plugged in.
-The product can be deformed or fire can break out due to internal overheating.
•Place the product on a flat and stable surface that is large enough to support the product.
-If the product is dropped, you may be injured or the product may be broken.
•Install the product where no Electromagnetic Interference occurs.
•Keep the product away from direct sunlight.
-The product can be damaged.
•Do not place the product on the floor.
-Small Children and others may trip over it.
•Do not install this product on a wall if it could be exposed to oil or oil mist.
-This may damage the product and cause it to fall.
•For displays with glossy bezels the user should consider the placement of the display as the bezel may cause disturbing reflections from
surrounding light and bright surfaces.
Precautions in Moving the Product
•Make sure to turn off the product.
-You may be electrocuted or the product can be damaged.
•Make sure to remove all cables before moving the product.
-You may be electrocuted or the product can be damaged.
•When lifting or moving the product, do not hold it upside down while holding only the stand.
-This may cause the product to fall resulting in damage or injury.
•Do not shock the product when moving it.
-You may be electrocuted or the product can be damaged.
•Make sure the panel faces forward and hold it with both hands to move.
-If you drop the product, the damaged product can cause electric shock or fire.
•Do not place the product face down.
-This may damage theTFT-LCD screen.
5
Precautions in Using/Cleaning the Product
•Do not attempt to disassemble, repair or modify the product yourself.
-Fire or electric shock can occur.
-Contact LG Customer Service for repair.
•When cleaning the product, unplug the power cord and scrub gently with a soft cloth to prevent scratching. Do not clean with a wet cloth or spray
water or other liquids directly onto the product. An electric shock may occur. (Do not use chemicals such as benzene, paint thinners or alcohol)
•Keep the product away from water.
-Fire or electric shock accident can occur.
•Avoid high temperatures and humidity.
•Do not put or store flammable substances near the product.
-There is a danger of explosion or fire.
•Keep the product clean at all times.
•Take a comfortable and natural position when working with the product.
•Take a regular break when working with the product for a long time.
•Do not press on the panel with a hand or sharp object such as nail, pencil or pen, or make a scratch on it.
•Keep proper distance from the product and rest from time-to-time.
-Your vision may be impaired if you look at the product too closely or for too long.
•Set the appropriate resolution by referring to the User’s Guide.
•Keep small accessories out of the reach of children.
•Displaying a still image for long time on the monitor may leave persistent image or stain on the monitor screen.To avoid this problem, use a screen
saver and power off when this product is not used. Persistent image or stain caused by long time usage are not covered by the warranty on this
product.
•Do not use products using high voltage around the Monitor. (ex. Electrical Swatter)
-Monitor may have malfunction as its electrical shock.
•Spray water onto a soft cloth 2 to 4 times, and use it to clean the front frame, wipe in one direction only. Too much moisture may cause staining.
WATER CHEMICALS
6
Installation
Lifting and moving the Monitor
Please note the following advice to prevent the Monitor from being scratched or damaged and for safe transportation regardless of its type and size.
•It is recommended to move the Monitor in the box or packing material that the Monitor originally came in.
•Before moving or lifting the Monitor, disconnect the power cord and all cables.
•When holding the Monitor, the screen should face away from you to avoid damage.
•Hold the side and bottom of the Monitor frame firmly. Make sure not to hold the transparent part, speaker, or speaker grill area.
•When transporting a large Monitor, there should be at least 2 people.
•When transporting the Monitor, do not expose the Monitor to jolts or excessive vibration.
•When transporting the Monitor, keep the Monitor upright, never turn the Monitor on its side or tilt towards the left or right.
•Do not apply excessive pressure to cause flexing / bending of frame chassis as it may damage screen.
•When handling the Monitor, be careful not to damage the protruding buttons.
•Avoid touching the screen at all times, as this may result in damage to the screen.
•When attaching the stand to the Monitor set, place the screen facing down on a cushioned table or flat surface to protect the screen from
scratches.
7
Installing on a Table
•Lift the monitor and place it on the table in an upright position. Place the monitor at least 100mm (3.9inches) away from the wall to ensure
sufficient ventilation.
: 100mm (3.9inches)
•Unplug the power cord before moving or installing the monitor. There is risk of electric shock.
•Make sure to use the power cord that is provided in the product package and connect it to a grounded power outlet.
•If you need another power cord, please contact your local dealer or the nearest retail store.
8
Adjusting the Angle
1 Place the monitor mounted on the stand base in an upright position.
2 Adjust the angle of the screen.
The angle of the screen can be adjusted forward or backward from -5° to 15° for a comfortable viewing experience.
•To avoid injury to the fingers when adjusting the screen, do not hold the lower part of the monitor’s frame as illustrated below.
•Be careful not to touch or press the screen area when adjusting the angle of the monitor.
Note
•The left or right side of the monitor head can be slightly rotated up or down (up to 5°). Adjust the horizontal level of the monitor head.
9
Adjusting the Stand Height
1 Make sure to hold and move the monitor with both hands.
Max 110.0mm
(4.3 inches)
•To avoid injury when adjusting the height, do not put your hands on the stand.
Using the Kensington Lock
For more information on installation and usage, refer to the Kensington lock owner’s manual or visit the website at http://www.kensington.com.
Connect the monitor to a table using the Kensington security system cable.
Note
•The Kensington security system is optional. You can obtain optional accessories from most electronics stores.
10
Installing on the Wall
This monitor meets the specifications for the wall mount plate or other compatible devices.
•Install the monitor at least 100mm (3.9 inches) away from the wall and leave about 100mm (3.9 inches) of space at each side of the monitor to
ensure sufficient ventilation. Detailed installation instructions can be obtained from your local retail store. Alternatively, please refer to the manual
for how to install and set up a tilting wall mounting bracket.
: 100mm (3.9 inches)
Installing the Wall Mount Plate
To install the monitor to a wall, attach a wall mounting bracket (optional) to the back of the monitor.
Make sure that the wall mounting bracket is securely fixed to the monitor and to the wall.
Wall Mount (mm) 100 x 100 (3.9 x 3.9 inches)
Standard screw M4 x L10
Number of screws 4
Wall Mount Plate (Optional) LSW149
Table of contents
Other LG Monitor manuals
